Physics Commons^™

Multi-Mode And Single Mode Polymer Waveguides And Structures For Short-Haul Optical Interconnects, Kevin L. Kruse

Dissertations, Master's Theses and Master's Reports - Open

Single mode and multi-mode polymer optical waveguides are a viable solution for replacing copper interconnects as high speed and large bandwidth short-haul optical interconnects in next-generation supercomputers and data servers. A precision laser direct writing method is implemented for producing various single mode and multi-mode polymer waveguide structures and their performance is evaluated experimentally showing agreement with theoretically developed models. The laser direct writing method is the optimal solution for low-rate cost-effective prototyping and large area panel production.

A single mode polymer waveguide bridge module for silicon to glass optical fibers is designed, modeled, fabricated, and measured. The bridge module …

Geometry Induced Magneto-Optic Effects In Lpe Grown Magnetic Garnet Films, Ashim Chakravarty

Dissertations, Master's Theses and Master's Reports - Open

This dissertation addresses dimensionality-induced magneto-optic effects in liquid-phaseepitaxy magnetic garnet thin films. It is found that the Faraday rotation (FR) per unit length evinces a marked and steady enhancement as the film thickness is reduced below ~100 nm in Bi_0.8Gd_0.2Lu₂Fe₅O₁₂, although it remains constant in the micron- and most of the submicron- regime. The reported specific FR change in such reduced dimensions is due to sizedependent modifications in diamagnetic transition processes in the garnet film. These processes correspond to the electronic transitions from the singlet ⁶S ground state to …

Direct Write Fabrication Of Waveguides And Interconnects For Optical Printed Wiring Boards, Joseph Carl Dingeldein

Dissertations, Master's Theses and Master's Reports - Open

Current copper based circuit technology is becoming a limiting factor in high speed data transfer applications as processors are improving at a faster rate than are developments to increase on board data transfer. One solution is to utilize optical waveguide technology to overcome these bandwidth and loss restrictions. The use of this technology virtually eliminates the heat and cross-talk loss seen in copper circuitry, while also operating at a higher bandwidth. Transitioning current fabrication techniques from small scale laboratory environments to large scale manufacturing presents significant challenges. Optical-to-electrical connections and out-of-plane coupling are significant hurdles in the advancement of optical …