Oil, Gas, and Energy Commons^™

Fabrication Of Solid Oxide Fuel Cell Components Using Stereolithography 3d Printing, Hannah Dyer

Mechanical & Aerospace Engineering Theses & Dissertations

Transitioning from fossil fuel supplied energy to renewable technology must meet cost efficient parameters throughout the manufacturing process while possessing the characteristics of a functioning and reliable power source. With a significant demand in renewable energy products, developmental techniques require adaptive approaches and procedures for novel materials in the manufacturing phase. This report proposes how a solid oxide fuel cell (SOFC), a renewable energy system, can employ additive manufacturing for directly 3D printing its components by utilizing stereolithography (SLA) 3D printing techniques. Fabrication of the printed components from the mixtures were first mixed with varying concentrations of ceramic powder and …

Offshore Wind Energy: Simulating Local Offshore Wind Turbine, Ian P. Aquino

Mechanical & Aerospace Engineering Theses & Dissertations

Dominion Virginia Energy is looking at the possible creation of an offshore wind plant as a renewable source of electricity to be located off the coast of Virginia Beach. This thesis reports on a computer simulation based on local wind conditions and possible single wind turbine installation.

The National Buoy Data Center keeps records of the local wind conditions gathered in real time and available to the public. These data give a general overview of the wind conditions in Virginia Beach which is used to simulate atmospheric boundary layer (ABL) flow conditions and is subsequently used as input data for …