Environmental Chemistry Commons^™

Photocatalytic Activity: Experimental Features To Report In Heterogeneous Photocatalysis, Md. Ariful Hoque, Marcelo I. Guzman

Chemistry Faculty Publications

Heterogeneous photocatalysis is a prominent area of research with major applications in solar energy conversion, air pollution mitigation, and removal of contaminants from water. A large number of scientific papers related to the photocatalysis field and its environmental applications are published in different journals specializing in materials and nanomaterials. However, many problems exist in the conception of papers by authors unfamiliar with standard characterization methods of photocatalysts as well as with the procedures needed to determine photocatalytic activities based on the determination of “apparent quantum efficiencies” within a wavelength interval or “apparent quantum yields” in the case of using monochromatic …

Assembling Of Niox/Mwcnts-Gc Anodic Nanocatalyst For Water Electrolysis Applications, Yaser M. Asal Mr., Islam M. Al-Akraa Dr, Saher D. Khamis Eng

Chemical Engineering

Glassy carbon (GC) electrode is intended to be modified with nickel oxide (NiOx) and multiwalled carbon nanotubes (MWCNTs) in the anodic reaction of water electrolysis. NiOx deposition time is optimized and a 5 min was enough to attain the maximum activity. A further modification of the catalyst with MWCNTs could greatly enhance its stability during continuous electrolysis. As an outcome, an energy amount of 21.7 kWh/KgO₂ is minimized. Several electrochemical and materials characterization setups will be utilized to test the catalyst activity and to know its geometry and structure.

Plant Stimuli-Responsive Biodegradable Polymers For The Use In Timed Release Fertilizer Coatings, Spencer Heuchan

Electronic Thesis and Dissertation Repository

The use of nitrogen-based fertilizers continues to accelerate with human population growth and increases in global food requirements. Enhanced efficiency fertilizers (EEFs) have been developed to improve the synchronization between nutrient supply and crop nutrient demand. However, many of the current controlled release fertilizers are coated with non-degradable polymers that contribute to accumulation of microplastics within ecosystems. This thesis describes research towards the development of a new class of fertilizer coatings using a self-immolative polymer known as poly (ethyl glyoxylate) (PEtG). PEtG itself does not have suitable properties to produce a viable coating but once blended with another degradable polyester …

Fabrication Of Mnox/Mwcnts-Gc Nanocatalyst For Oxygen Evolution Reaction, Yaser M. Asal Mr, Islam M. Al-Akraa Dr, Amr M. Arafa Eng.

Chemical Engineering

Manganese oxide (MnOx) and multiwalled carbon nanotubes (MWCNTs) are intended to modify the GC electrode for oxygen evolution reaction (OER). Optimization of MnOx loading is carried out and the deposition of 55 cycles was sufficient to obtain the highest activity toward OER. The stability of the catalyst is enhanced by the addition of MWCNTs. As a result, an amount of 22 kWh/Kg of O₂ of energy is saved. Several techniques including cyclic voltammetry, linear sweep voltammetry, chronoamperometry, chronopotentiometry, field-emission scanning electron microscopy, and energy dispersive X-ray spectroscopy will be combined to track the catalyst activity and to determine its …

Desalination Concentrate Disposal: Ecological Effects And Sustainable Solutions, Ryan Hanley

Global Honors Theses

Freshwater availability is a growing global concern, and desalination is often presented as the solution, but from this important technology comes issues of toxic waste. Ecosystems are delicate areas that contain species adapted to that specific location, and any chemical or physical changes can disrupt the fitness of species. The concentrate byproduct waste from desalination plants is toxic to species if the concentrate is not compatible with the receiving water body. A critical review of scientific articles, industry-leading books, conversations with industry experts, and information from the American Membrane Technology Association conference was used to analyze the current knowledge. Species …

Variable Temperature Thermochromic Switching Under Varying Illumination, Alexis Corbett, Danielle Hall, John E. Sinko

Huskies Showcase

Award for "Runner-Up Poster Presentation".

Abstract

Minnesota is home to some of the greatest temperature ranges in the United States, with lows reaching below -40º Celsius and highs reaching nearly 40ºC. This results in higher than average spending on the heating and cooling of buildings. We have been investigating into responsive building materials to help address this. In particular, we have been studying a thermochromic paint that can capture solar energy and transfer it into the building as heat at low temperatures and reflect the energy at higher temperatures to keep the building cooler.

Nanoporous Carbon-Based Co2 Reduction Catalysts: Exploring The Combined Effects Of Surface Chemistry And Porosity, Wanlu Li

Dissertations, Theses, and Capstone Projects

For the first-time sulfur-doped, nitrogen-doped and sulfur, nitrogen-codoped nanoporous carbons were systematically studied as catalysts for CO₂ electrochemical reduction reaction (CO₂ERR). The Faradaic efficiencies (FE) of CO and CH₄ formation were calculated to evaluate the performance of these carbons. The best catalysts showed the FE of CO and CH₄ formation of 29% and 0.76%, respectively. It was found that the overall performance in CO₂ERR dramatically increased upon the reduction pretreatment of the carbons in N₂-saturated electrolyte before the CO₂ reduction process. The pretreated carbon showed the maximum FE of CO …

Fabrication Of Mnox/Mwcnts-Gc Nanocatalyst For Oxygen Evolution Reaction, Islam M. Al-Akraa Dr., Yaser M. Asal Mr, Amr M. Arafa Eng.

Chemical Engineering

Manganese oxide (MnOx) and multiwalled carbon nanotubes (MWCNTs) are intended to modify the GC electrode for oxygen evolution reaction (OER). Optimization of MnOx loading is carried out and the deposition of 55 cycles was sufficient to obtain the highest activity toward OER. The stability of the catalyst is enhanced by the addition of MWCNTs. As a result, an amount of 22 kWh/Kg of O2 of energy is saved. Several techniques including cyclic voltammetry, linear sweep voltammetry, chronoamperometry, chronopotentiometry, field-emission scanning electron microscopy, and energy dispersive X-ray spectroscopy will be combined to track the catalyst activity and to determine its morphology …

Assembling Of Niox/Mwcnts-Gc Anodic Nanocatalyst For Water Electrolysis Applications, Islam M. Al-Akraa Dr., Yaser M. Asal Mr, Saher D. Khamis Eng

Chemical Engineering

Glassy carbon (GC) electrode is intended to be modified with nickel oxide (NiOx) and multiwalled carbon nanotubes (MWCNTs) in the anodic reaction of water electrolysis. NiOx deposition time is optimized and a 5 min was enough to attain the maximum activity. A further modification of the catalyst with MWCNTs could greatly enhance its stability during continuous electrolysis. As an outcome, an energy amount of 21.7 kWh/KgO2 is minimized. Several electrochemical and materials characterization setups will be utilized to test the catalyst activity and to know its geometry and structure.

Fabrication Of Cuox-Pd Nanocatalyst Supported On A Glassy Carbon Electrode For Enhanced Formic Acid Electro-Oxidation, Islam M. Al-Akraa Dr., Ahmad M. Mohammad Prof, Mohamed S. El-Deab Prof, Bahgat E. El-Anadouli Prof

Chemical Engineering

Formic acid (FA) electro-oxidation (FAO) was investigated at a binary catalyst composed of palladium nanoparticles (PdNPs) and copper oxide nanowires (CuOxNWs) and assembled onto a glassy carbon (GC) electrode. /e deposition sequence of PdNPs and CuOxNWs was properly adjusted in such a way that could improve the electrocatalytic activity and stability of the electrode toward FAO. Several techniques including cyclic voltammetry, chronoamperometry, field-emission scanning electron microscopy, energy dispersive X-ray spectroscopy, and X-ray diffraction were all combined to report the catalyst’s activity and to evaluate its morphology, composition, and structure. /e highest catalytic activity and stability were obtained at the CuOx/Pd/GC …