Dental Materials Commons^™

Catechol-Containing Copolymers As An Active Ingredient For Denture Adhesives, Vincent Ying Wun Kong

Electronic Thesis and Dissertation Repository

Moisture inside the mouth adds challenge to making denture adhesives formulations. Some formulations have zinc to enhance adhesion on wet skin despite knowing the health hazards. Inspired by mussel foot proteins’ catechol unit’s strong underwater adhesion, nine catechol-containing copolymers (P1A-P3C) were synthesized by free radical polymerization of 3,4-dimethoxystyrene (3,4- DMS) with different styrene derivatives followed by deprotection. P1A-P3C were used to make Fn(P)-C-PBS denture adhesive formulations which had suitable shear stresses around ≥ 5 kPa satisfying ISO 10873. In-situ NMR studies of free radical polymerization of 3,4 - DMS and styrene derivatives allowed computation of their reactivity ratios showing all …

Influence Of Immediate Dentin Sealing On The Bond Strength Of Indirect Bonded Restorations, Alexander Duque

Student Theses, Dissertations and Capstones

Introduction: A critical issue and concern that has been documented in dentistry is the complexity of bonding to dentin, a fact that has been referred to as a less reliable technique due to the intrinsic characteristics of the dentin substrate. Effectiveness on dentin bonding is a clinical important approach for indirect bonded restorations in order to achieve a good adhesion that can surpass the test of time. Long-term clinical trials have shown that indirect bonded restorations have an increased risk of failure when using dentin as the major substrate. Consequently, an effort should be made to improve techniques and materials …

An Analysis Of Adhesion Promoters On Shear Bond Strength Of Orthodontic Brackets To Teeth, Loren Andrew Cadelinia

UNLV Theses, Dissertations, Professional Papers, and Capstones

Purpose:The aim of this study was to evaluate the shear bond strength of two adhesion promoters, EnhancetmLC and AssureRUniversal Bonding Resin, and their effects with two different adhesion systems (Light Bondtmand TransbondtmXT). To better understand their behavior upon failure, the amount of adhesive remnant remaining on the tooth surface was also observed.

Methods:One-hundred forty human premolars, which were extracted for reasons other than this study, were utilized and divided into seven groups of 20 teeth each. Groups A1 and B1 were bonded without adhesion promoters and with two different adhesive systems - Light Bondtmand TransbondtmXT. Groups A2 and B2 were …