Dental Materials Commons^™

Comparison Of Bracket Bond Strength By Total, Self-Etch And Laser Treatment, Kyo Sung Shawn Kim

Loma Linda University Electronic Theses, Dissertations & Projects

Laser etching of enamel surfaces alters the physical and chemical characteristics of the enamel. These changes in characteristics enhance the bonding to enamel. The purpose of this study was to compare the shear and tensile bond strength of Er,Cr:YSGG hydrokinetic laser system (Biolase) with 37% phosphoric acid and self etching primer 30 minutes and 72 hours after bonding. Four different laser power output setting was observed: 1.5W, 2.0W, 2.5W, and 3.0W. Two hundred forty bovine teeth free of defect, caries, and dentin exposure were mounted in acrylic resin and divided into 24 groups of 10 teeth. Sixteen groups of 10 …

A Bond Strength Comparison Of Led And Halogen Light Curing Units, John Richard Kavanagh

Loma Linda University Electronic Theses, Dissertations & Projects

The purpose of this research was to compare the tensile bond strength of orthodontic flat based buttons bonded to bovine teeth with four commercial light-emitting diode (LED) curing lights and one conventional quartz tungsten halogen (QTH) curing light.

The dental market has recently been introduced to a number of commercially available light-emitting diode (LED) curing lights. Tensile bond strength was evaluated for LED curing lights (Rembrandt® Allegro^TM, Den-Mat Corp, Santa Maria, CA), (LEDemetron, Kerr/Demetron Corp, Danbury, Conn), (Ortholux LED, 3M^TMESPE^TM, St. Paul, MN),and (FLASH-lite 1001, Discus Dental, Culver City, CA) are compared with one …

The Radiopacity Of 29 Resin Restorative Materials Compared To Enamel, Peter Lubisich Iv

Loma Linda University Electronic Theses, Dissertations & Projects

The radiodensity of a composite resin can greatly influence a clinician's ability to analyze a restoration for failure. The purpose of this study was to determine the relative radiopacities of 29 resin restorative materials compared to enamel, and to verify the comparable radiopacity between shades of 23 of the restorative composite resin materials. Composite resin discs measuring >5mm in diameter and 2 mm in thickness were made and polymerized. Radiographs were taken of the composite resin discs, which included an aluminum step wedge for calibration and a densitometer was used to measure the radiodensity of the composite resin samples. The …

Effects Of Mtad On Some Physical Properties Of Enamel And Dentin, Tanya Kristina Machnick

Loma Linda University Electronic Theses, Dissertations & Projects

Recently, a Mixture of Tetracycline, an Acid, and a Detergent (MTAD) has been advocated to remove smear layer and disinfect canals. The purpose of this study was to evaluate the effect of MTAD the flexural strength and modulus of elasticity of dentin as well as its effect on the bond strength to enamel and dentin. In Part I, dentin bars were randomly assigned to eight groups treated either with various concentrations of NaOCl (5.25%, 2.65%, 1.31%, 0.66%), 17% EDTA, MTAD, saline, or according to a clinical protocol with 1.3% NaOCl and then 5 min of MTAD. …