Open Access. Powered by Scholars. Published by Universities.®

Dental Materials Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Dental Materials

A Comparison Of The Antimicrobial Efficacy Of Silver Diamine Fluoride And Silver Nitrate: An In Vitro Study, Nicholas L. Luke Jan 2018

A Comparison Of The Antimicrobial Efficacy Of Silver Diamine Fluoride And Silver Nitrate: An In Vitro Study, Nicholas L. Luke

Theses and Dissertations

A COMPARISON OF THE ANTIMICROBIAL EFFICACY OF SILVER DIAMINE FLUORIDE AND SILVER NITRATE: AN IN VITRO STUDY

By: Nicholas L Luke, D.D.S.

A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University.

Virginia Commonwealth University, May 2018

Thesis Advisor: William O. Dahlke Jr., D.M.D.

Pediatric Dentistry, Department Chair

Purpose: To determine the antimicrobial efficacy of SDF and SN/NaF.

Methods: Three bacterial species were combined to create an in vitro biofilm. Treatment was completed with SN, SN/NaF, SDF, SDF½ or untreated (control).

Results: The untreated group demonstrated significantly higher …


Evaluation Of Fit For 3d Printed Retainers As Compared To Thermoform Retainers, David J. Cole Jan 2018

Evaluation Of Fit For 3d Printed Retainers As Compared To Thermoform Retainers, David J. Cole

Theses and Dissertations

ABSTRACT

EVALUATION OF FIT FOR 3D PRINTED RETAINERS AS COMPARED TO THERMOFORM RETAINERS

By David Cole, D.M.D.

A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University

Thesis Directors: Eser Tüfekçi, D.D.S., M.S., Ph.D., M.S.H.A.

Professor, Department of Orthodontics

Sompop Bencharit, D.D.S., M.S., Ph.D.

Associate Professor and Director of Digital Dentistry, Department of General Practice

Introduction: Despite recent advances in three-dimensional (3D) printing, little information is available on 3D printed retainers

Methods: Three reference models were used to fabricate traditional vacuum formed, commercially-available vacuum formed, and 3D printed …