Nuclear Engineering Commons^™

Meta-Heuristic Optimization Techniques For The Production Of Medical Isotopes Through Special Target Design, Cameron Ian Salyer

Masters Theses

Medical isotopes are used for a variety of different diagnostic and therapeutic purposes Ruth (2008). Due to recent newly discovered applications, their production has become rapidly more scarce than ever before Charlton (2019). Therefore, more efficient and less time consuming methods are of interest for not only the industry’s demand, but for the individuals who require radio-isotope procedures. Currently, the primary source of most medical isotopes used today are provided by reactor and cyclotron irradiation techniques, followed by supplemental radio-chemical separations Ruth (2008). Up until this point, target designs have been optimized by experience, back of the envelope calculations, and …

Enigma - Ongoing Development Towards Novel Beta-Decay Spectroscopy Station At Isolde, Philipp Wagenknecht

Masters Theses

Beta decay and collinear laser spectroscopy are proven efficient tools to study nuclear structure far from stability. Two areas of significance are investigations into nuclear deformation and shape coexistence, as well as delayed neutron emissions used in nuclear energy applications. This contribution presents the ongoing development towards a novel beta-decay spectroscopy station for the VITO experiment at CERN’s radioactive ion beam facility ISOLDE. The setup will utilize both collinear laser spectroscopy and beta-decay spectroscopy to measure the energy and spin-parities of the ground and excited states of radioactive beams. Initial designs of the support structure, magnetic field, and detector array …

Particle Swarm Optimization For Critical Experiment Design, Cole Michael Kostelac

Masters Theses

“Critical experiments are used by nuclear data evaluators and criticality safety engineers to validate nuclear data and computational methods. Many of these experiments are designed to maximize the sensitivity to a certain nuclide-reaction pair in an energy range of interest. Traditionally, a parameter sweep is conducted over a set of experimental variables to find a configuration that is critical and maximally sensitive. As additional variables are added, the total number of configurations increases exponentially and quickly becomes prohibitively computationally expensive to calculate, especially using Monte Carlo methods.

This work presents the development of a particle swarm optimization algorithm to design …

Empirical Modeling Of Used Nuclear Fuel Radiation Emissions For Safeguards Purposes, Amanda M. Bachmann

Masters Theses

For nuclear nonproliferation safeguards, the ability to characterize used nuclear fuel (UNF) is a vital process. Fuel characterization ^allows for independent verification by inspectors of operator declarations of the special nuclear material flow and nuclear related activities within a facility, and an estimation of fissile material remaining in a fuel assembly. Current methods to verify this information rely heavily on non-destructive assay techniques, such as gamma spectroscopy and neutron detection measurements. While these measurements are effective tools for estimating a specific characteristic of the fuel, such as burnup or cooling time, they often require an accurate estimation of a select …

Modulated Photothermal Radiometry: Detector Sensitivity Study And Experimental Setup, Jessica Nicole Seals

Masters Theses

"This thesis outlines the development of a system used for determining the surface thermal diffusivity of both non-irradiated and irradiated materials. The motivation for this work is to establish a modulated photothermal radiometry (PTR) system on the campus of Missouri University of Science and Technology. One of the main efforts described in this thesis is the design and construction of the physical apparatus. Along the way, it was necessary to perform a detailed sensitivity analysis of the system to determine whether the expected signal emitted from the sample falls within the bounds of detectivity for the HgCdTe (MCT) detector used …

Customized Multi-Group Cross Section Generation With Njoy For Discrete Ordinates Computed Tomography And Radiography Simulation, Steven Michael Wagstaff

Masters Theses

"The purpose of this work was to explore the creation of photoatomic multi-group cross section libraries to be used with a software package DOCTORS (Discrete Ordinates Computed TOmography and Radiography Simulator). This software solves the linear Boltzmann equation using the discrete ordinates method [1]. To create these libraries, NJOY2016 was used, creating both fine and broad energy multi-group cross section files. The cross section's accuracy was tested against an equivalent Monte Carlo simulation using MCNP6.

Two simulation geometries were used. The first, a cylindrical water phantom with a single source projection placed in front, simulating an X-ray radiography. The second …

Development Of Nuclear Underground Engineered Test Surrogates For Technical Nuclear Forensics Exploitation, Robert Boone Gilbreath

Masters Theses

A method for formulation and production of Nuclear UnderGround Engineered Test Surrogates (NUGETS) based on notional improvised nuclear device (IND) detonations in an underground environment analogous to the Nevada National Security Site (NNSS) is presented. Extensive statistical analyses of precursory geochemical and geophysical characteristics are combined with an augmented surrogate debris cooling technique and predictive IND contributions from the ORIGEN Fallout Analysis Tool. Precursory and resultant elemental compositions, cooling curve calculations, and visual comparison of NUGETS to genuine underground debris are reported. Application of NUGETS methodology to future studies in urban, underground post-detonation technical nuclear forensic (TNF) analysis is suggested.

A Study Of The Potential Applications Of Am241, And Determining The Feasibility Of Using Gamma Spectroscopy For Future Physical Validation, Eric A. Feissle

Masters Theses

“Am241 is typically produced via Pu241 decay in a uranium fueled reactor. Presence of Am241 can be used as the age estimation tool for spent fuel, which is a focus of this thesis along with the interest of the measurement and the ratio of production rates of Am241’s activation products; Americium-242 and its first excited state of Americium-242m. MCNP models of the core and BEGe 3825 detector were built. These models were compared with established and physical measurements of gamma/x-ray standards that were available at the reactor. Thermal fluxes at 200 kW for potential foils centered in the source holder …

The Viability Of Advantg Deterministic Method For Synthetic Radiography Generation, Andrew Albert Bingham

Masters Theses

"Time sensitive and high resolution image simulations are needed for synthetic radiography generation. The standard stochastic approach requires lengthy run times with poor statistics at higher resolutions. The investigation of the viability of a deterministic approach to synthetic radiography image generation was explored. The aim was to analyze a computational time decrease over the stochastic method. ADVANTG was compared to MCNP in multiple scenarios including a Benchtop CT prototype, to simulate high resolution radiography images. By using ADVANTG deterministic code to simulate radiography images the computational time was found to decrease over 10 times compared to the MCNP stochastic approach"--Abstract, …

Preliminary Investigation For The Development Of Surrogate Debris From Nuclear Detonations In Marine-Urban Environments, Adam G. Seybert

Masters Theses

No nuclear weapon has ever been detonated in a United States city. However, this also means the nuclear forensic community has no actual debris from which to develop analytical methods for source attribution, making the development of surrogate nuclear debris a vital undertaking. Moreover, the development of marine-urban debris presents an unusual challenge because unlike soil and urban structures, which remain compositionally consistent, the elemental composition of harbor and port waters fluctuates considerably due to natural phenomenon and human activity. Additionally, marine vessel composition and cargo can vary dramatically. While early US nuclear tests were carried out in shallow-water coastal …

Cd Transport In Eutectic Licl-Kcl And Contamination Of Zr Metal And Thermal Dehydration Of Bulk Licl-Kcl, Nicholas Azoy Earle

Masters Theses

Researchers at Idaho National Labs have noted unexpectedly high Cd content in empty cladding hulls after processing in the Mark-IV ER. It has been theorized that Cd metal is transporting from the LCC pool through the eutectic LiCl-KCl salt bath to the anode baskets containing the empty hull where it is retained as a Zr-Cd intermetallic. This study sought to replicate the Cd contamination in a dry Ar glovebox using small-scale analogue of the Mark-IV ER salt-Cd metal system.

Anhydrous eutectic LiCl-KCl was an essential regent in this research and experiments were conducted to investigate the feasibility of dehydrating nominally …

Magnetron Sputtering And Corrosion Of Ti-Al-C And Cr-Al-C Coatings For Zr-Alloy Nuclear Fuel Cladding, Devin Alan Roberts

Masters Theses

The disaster at the Fukushima Daiichi Nuclear Power Plant in March 2011 bought renewed focus to the issue of corrosion in nuclear fuel cladding applications. This thesis reports on the background behind these issues, the investigation strategy, and the analysis of experiments focused on mitigating oxidation of Zr-alloy fuel cladding. This thesis seeks to develop magnetron sputtered Ti-Al-C and Cr-Al-C coatings for Zr-alloy substrates and characterize the as-deposited and corroded samples.

Ti-Al-C and Cr-Al-C coatings were deposited onto ZIRLO, Si, and Al₂O₃ [Aluminum Oxide] substrates under various sputtering conditions. A combinatorial sputtering method was employed to refine …

A Feasibility Study Of A Nuclear Power Plant With No Moving Parts, Jonathan Mark Schattke

Masters Theses

"In a nuclear reactor design, every moving part in a system is considered a failure point. In this study, a proposal is made for designing a nuclear reactor that has no moving parts by coupling an accelerator driven core (removing control system moving parts) to a magnetohydrodynamic generator (removing power generation moving parts) using mercury coolant (removing pumping system moving parts). Further safety is realized by using a subcritical core, where the core is never able to sustain a chain reaction on its own, obviating many safety systems. The design is verified with a Monte Carlo simulation "--Abstract, page iii.

Attenuation Properties Of Cement Composites: Experimental Measurements And Monte Carlo Calculations, Raul Florez

Masters Theses

"Developing new cement based materials with excellent mechanical and attenuation properties is critically important for both medical and nuclear power industries. Concrete continues to be the primary choice material for the shielding of gamma and neutron radiation in facilities such as nuclear reactors, nuclear waste repositories, spent nuclear fuel pools, heavy particle radiotherapy rooms, particles accelerators, among others. The purpose of this research was to manufacture cement pastes modified with magnetite and samarium oxide and evaluate the feasibility of utilizing them for shielding of gamma and neutron radiation. Two different experiments were conducted to accomplish these goals. In the first …

Rapid Dissolution For Destructive Assay Of Nuclear Melt Glass, Jonathan Allen Gill

Masters Theses

This study evaluates four methods for dissolving complex glassy debris resulting from nuclear detonations. The samples of interest simulate the glassy debris generated from a nuclear detonation’s fireball coming in contact with solid masses. Each method attempts to achieve dissolution through different approaches involving either acid digestion, alkaline digestion, or molten salt fusion. Two of the four methods were modified to retain all elements of the debris or surrogate debris. This retention is critical to the proportional relationships used in identifying fuel types and designs of nuclear weapons. Analysis is conducted with an inductively coupled time of flight mass spectrometer …

Thick Target Yield Of Th-229 Via Low Energy Proton Bombardment Of Th-232, Justin Reed Griswold

Masters Theses

Actinium-225 is one of the more effective radioisotopes used in alpha radioimmunotherapy. Due to its ten-day half-life, it is more efficient to create its precursor, ²²⁹Th [Thorium-229] (t_1/2[half-life] = 7932 ± 55 years). In this work, ²²⁹Th was produced via 40 MeV [Mega electron Volts] proton bombardment of a thick ²³²Th [Thorium-232] target. The irradiation took place at the Holifield Radioactive Ion Beam Facility (HRIBF) at Oak Ridge National Lab (ORNL). The target, consisting of 23 stacked natural thorium foils (137 mg/cm² [milligrams per square centimeter] each), was irradiated with 50 nA [nanoamps] of …

Evaluation Of Tagging Techniques Gamma-Decay Probabilities Using The Surrogate Method, Timothy Lee Reed

Masters Theses

A detailed analysis of the statistical and discrete [gamma]-decay tagging techniques was conducted using the absolute surrogate and surrogate ratio method (SRM) to obtain the 92Mo(n,[gamma]) cross section in an equivalent neutron energy range of 80 to 880 keV. Excited 93Mo and 95Mo nuclei were populated using (d,p) reactions on 92Mo and 94Mo targets, respectively. The absolute surrogate 92Mo(n,[gamma]) cross sections disagreed with evaluated neutron capture cross section data by as much as a factor of 4 using the statistical tagging approach, whereas the discrete [gamma]-decay tag absolute surrogate cross section disagreed with the evaluated neutron capture cross section by …

A High-Energy Neutron Flux Spectra Measurement Method For The Spallation Neutron Source, Nicholas Patrick Luciano

Masters Theses

The goal of this work was to develop a foil activation method to measure high-energy (∼1-100 MeV) neutron flux spectra at the Spallation Neutron Source by researching the scientific literature, assembling an experimental apparatus, performing experiments, analyzing the results, and refining the technique based on experience. The primary motivation for this work is to provide a benchmark for the neutron source term used in target station and shielding simulations Two sets of foil irradiations were performed, one at the ARCS beamline and one at the POWGEN beamline. The gamma radiation of the foil activation products was measured with a high …

Positron Emission Tomography (Pet) For Flow Measurement, Bi Yao Zhang

Masters Theses

Positron Emission Tomography (PET) is frequently used for medical imaging. Maturity and flexibility of PET as an imaging technique has expanded its utility beyond the medical domain. It can be used as a tool for fluid flow studies in opaque fluids and for flow within complex geometry where conventional optical flow measurement approaches fail. This study explores the capabilities of PET as flow measurement tool suited to validation of computational fluid dynamic (CFD) predictions.

The MicroPET P4 scanner was used to image the diffusion process in flow around a rod bundle geometry similar to that found in a nuclear reactor …

Estimates Of Linear Energy Transfer From Solar Energetic Particles In Earth's Upper Atmosphere To Human Tissue In Aluminium Aircraft, Michael Ian Hall

Masters Theses

Radiation from extraterrestrial sources is a concern for the safety of passengers and crew in high altitude aircraft. Cosmic radiation and solar particles constantly bombard the atmosphere with energy. Radiation levels from these sources can vary considerably depending on solar activity cycles and energetic particle events such as solar flares. In order to predict the effects of such events the nature of the radiation spectrum must be characterized, and the individual effects of each radiation type understood. The background radiation spectrum is known to good accuracy and prediction of radiation levels due to specific solar events is currently under investigation. …