Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
Experimental Validation Of A Numerical Phase Change Model For Microchannel Slug Flow Boiling, Christian J. Retter, Todd A. Kingston, Justin A. Weibel, Suresh V. Garimella
Experimental Validation Of A Numerical Phase Change Model For Microchannel Slug Flow Boiling, Christian J. Retter, Todd A. Kingston, Justin A. Weibel, Suresh V. Garimella
The Summer Undergraduate Research Fellowship (SURF) Symposium
Thermal management of high-power electronic devices continues to be a critical challenge. Flow boiling in microchannel heat sinks has been demonstrated to be an effective method for removing high heat fluxes from these devices owing to utilization of the latent heat of the fluid and the large surface area enhancement for heat exchange. However, microchannel flow boiling technologies have yet to be broadly implemented due to a lack of experimentally validated prediction and design tools. The goal of this study is to use high-fidelity experimental data to validate a previously developed numerical phase change model, to help enable physics-based prediction …
Laser-Assisted Microchanneling On Pmma Substrate Utilizing Two-Pass Fabrication Method, Sijie Zhang, Yung C. Shin
Laser-Assisted Microchanneling On Pmma Substrate Utilizing Two-Pass Fabrication Method, Sijie Zhang, Yung C. Shin
The Summer Undergraduate Research Fellowship (SURF) Symposium
Microchannel is widely used in microfluidic devices for mixing, chemical reaction, detection, particle separation and etc. CO2 laser-based microchanneling of PMMA as a low cost, rapid, noncontact fabrication method has attracted the attention of industry. However, the typical V-shape grooves fabricated by CO2 laser microchanneling have limitations since the V-shape grooves will affect the flow behavior and heat transfer of the fluid, which are important to the performance of microfluidic devices. A two-pass fabrication method is proposed and investigated in this paper to improve the quality of the PMMA microchannel fabricated by CO2 laser. It was found …