Polymer and Organic Materials Commons^™

Stress Relaxation In Orthodontic Aligner Plastics; An In Vitro Comparison Study, Kristopher J. Keller

Theses & Dissertations

The purpose of this study was to ascertain if repeated stresses from extension cycling would result in accumulated damage in aligner materials and affect force delivery. A secondary goal was to identify potential differences in mechanical behavior present among orthodontic aligner polymers. Four thermoplastic polymers (Essix ACE, Taglus, Zendura, and Zendura FLX) were thermoformed, cut into strips, and extension cycled to 0.4 millimeters in a 37C water bath. Force decay, maximum and minimum force, and elastic modulus were measured during cycling. Additional samples were subjected to controlled tension until failure, allowing the measurement of yield strength, ultimate strength, and elastic …