Open Access. Powered by Scholars. Published by Universities.®

Other Materials Science and Engineering Commons™

Open Access. Powered by Scholars. Published by Universities.®

Civil and Environmental Engineering

Journal

Articles 1 - 6 of 6

Full-Text Articles in Other Materials Science and Engineering

Mechanical And Durability Properties Of Fly Ash Geopolymer Concrete – A Review, Ali Shebli, Jamal Khatib, Adel Elkordi Jun 2023

Mechanical And Durability Properties Of Fly Ash Geopolymer Concrete – A Review, Ali Shebli, Jamal Khatib, Adel Elkordi

BAU Journal - Science and Technology

Geopolymers have emerged as a promising alternative for Ordinary portland cement (OPC) in construction industry, due to their potential to minimize the emissions of carbon dioxide (CO2) and improve the efficiency of waste recycling. This paper aims to study the fresh and hardened properties of fly ash geopolymer concrete (GPC), as well as to review the raw materials used in the production of geopolymers. Several factors impact the mechanical and durability properties of fly ash GPC, including the specific type of fly ash utilized, the curing temperature, the alkaline activator (AA) concentration, and the type of AA used. …

Go to article

Mechanical And Durability Properties Of Geopolymer Concrete – A Review, Lelian Elkhatib, Fadi Al Aridi, Adel Elkordi, Jamal Khatib Jun 2022

Mechanical And Durability Properties Of Geopolymer Concrete – A Review, Lelian Elkhatib, Fadi Al Aridi, Adel Elkordi, Jamal Khatib

BAU Journal - Science and Technology

Owing to the ongoing increase in human population, there is a need for more construction projects including residential buildings and other amenities. Concrete is by far the dominant material used in construction and cement is a main ingredient. Cement manufacture is an energy intensive process and emit large amounts of carbon dioxide into the atmosphere. A reduction in the amount of cement used in construction is greatly beneficial. The use of geopolymer or alkali activated materials can serve this purpose as it attempts to totally replace cement in concrete. Geopolymers are materials that consist mainly of silica and alumina materials …

Go to article

Computational Design Of Nonlinear Stress-Strain Of Isotropic Materials, Askhad M.Polatov, Akhmat M. Ikramov, Daniyarbek Razmukhamedov May 2021

Computational Design Of Nonlinear Stress-Strain Of Isotropic Materials, Askhad M.Polatov, Akhmat M. Ikramov, Daniyarbek Razmukhamedov

Chemical Technology, Control and Management

The article deals with the problems of numerical modeling of nonlinear physical processes of the stress-strain state of structural elements. An elastoplastic medium of a homogeneous solid material is investigated. The results of computational experiments on the study of the process of physically nonlinear deformation of isotropic elements of three-dimensional structures with a system of one- and double-periodic spherical cavities under uniaxial compression are presented. The influence and mutual influence of stress concentrators in the form of spherical cavities, vertically located two cavities and a horizontally located system of two cavities on the deformation of the structure are investigated. Numerical …

Go to article

Effect Of Incorporating Pottery And Bottom Ash As Partial Replacement Of Cement, Bassam A. Tayeh, Doha M. Alsaffar, Lawend K. Askar, Asmahan Issa Jubeh Dec 2019

Effect Of Incorporating Pottery And Bottom Ash As Partial Replacement Of Cement, Bassam A. Tayeh, Doha M. Alsaffar, Lawend K. Askar, Asmahan Issa Jubeh

Karbala International Journal of Modern Science

This study addressed the environmental constraints in cement produc­tion. Ordinary Portland cement (OPC) was replaced with pottery powder (PP, produced by grinding locally available pottery) and bottom ash (BA) at 10%, 20% and 30% of cement mass. Moreover, 4% calcium chloride solution (CaCl2.2H2O) was used as mixing water. Material properties, such as standard consistency, setting time and compressive strength, were measured with different percentages of OPC replacement with PP and BA. Results indicated that the replacement with PP and BA increased the water demand to achieve the standard consistency. These results revealed that the strength evolution …

Go to article

Experimental Tests And Numerical Simulations For Failure Investigation On Corrugated Boxes Used On Household Appliance Packaging, Diego Fernandes Rodrigues, José Carlos Pereira Sep 2018

Experimental Tests And Numerical Simulations For Failure Investigation On Corrugated Boxes Used On Household Appliance Packaging, Diego Fernandes Rodrigues, José Carlos Pereira

Journal of Applied Packaging Research

Packages made of corrugated paper are fundamental to the protection, transportation and handling of the appliance product market. During the storage and sales stages of a product, the package must resist compressive loads in different directions beyond moderate impacts. In this context, the objective of this work is to develop and implement a post-processor that allows the simultaneous analysis of two of the most common failure modes of packages made of corrugated paper: failure due to tensile or compressive stress limit, and failure due to local buckling, when the buckling of the faces of the corrugated paper between two peaks …

Go to article

The Burnett Control Gate For Irrigation Channels, B Swan Jan 1960

The Burnett Control Gate For Irrigation Channels, B Swan

Journal of the Department of Agriculture, Western Australia, Series 4

THIS type of check-gate for use in irrigation ditches, was evolved on the Kimberley Research Station and has definite advantages over wooden or concrete structures in that it is termite-proof and can be removed and replaced in a few minutes to permit of the channel being cleaned out by straight runs with modern machinery.

Go to article