Engineering Mechanics Commons^™

Rc Baja Suspension And Steering, Garrett Bailey

All Undergraduate Projects

The RC Baja team set out to engineer and construct a working remote-control device that can compete in the ASME Baja Competition. The students have a focus on either suspension and steering or drivetrain and chassis. This report is centered on the suspension and steering. First, multiple analyses were completed using engineering methods such as mechanical design, statics, strengths of materials, and dynamics for parts of the device. The calculations found in the analysis are then used to create designs for the parts so that they will meet the requirements and be successful in the competition. After the parts are …

Stability Analysis, Dynamic Modeling, And Kinematic Analysis Of Hydraulically Amplified Dielectric Elastomer Actuators And Robot Manipulators, Amir Hosein Zamanian

Mechanical Engineering Research Theses and Dissertations

In this dissertation, we have proposed a new dielectric elastomer actuator design and model that couples electrostatics, fluid mechanics, linear and nonlinear elastic deformations. The internal hydraulic pressure can amplify the structural deformation generated by induced electrostatic forces (Maxwell pressure), given the name of this class of actuators, hydraulically amplified dielectric elastomer actuators (HADEAs).

First, we developed novel lumped-parameter models (LPMs) using linear and hyper-elastic material models and second compared the LPM results with finite element analysis in quasi-static simulations. We analytically expressed the conditions for the snap-through instability in the HADEA, which appears after exceeding a certain voltage applied …

Investigation Of Fundamental Principles Of Rigid Body Impact Mechanics, Khalid Alluhydan

Mechanical Engineering Research Theses and Dissertations

In impact mechanics, the collision between two or more bodies is a common, yet a very challenging problem. Producing analytical solutions that can predict the post-collision motion of the colliding bodies require consistent modeling of the dynamics of the colliding bodies. This dissertation presents a new method for solving the two and multibody impact problems that can be used to predict the post-collision motion of the colliding bodies. Also, we solve the rigid body collision problem of planar kinematic chains with multiple contacts with external surfaces.

In the first part of this dissertation, we study planar collisions of Balls and …

Lightweight Uav Launcher, Ben Miller, Christian Valoria, Corinne Warnock, Jake Coutlee

Mechanical Engineering

This report discusses the design, construction, and testing of a lightweight, portable UAV launcher. There is a current need for a small team of soldiers to launch a US Marine Tier II UAV in a remote location without transport. Research was conducted into existing UAV launcher designs and the pros and cons of each were recorded. This research served as a basis for concept generation during the initial design development stage. It was required that the design weigh less than 110 lbs, occupy a smaller volume than 48" x 24" 18" in its collapsed state, be portable by a single …