Engineering Science and Materials Commons^™

Morphological And Energy Transport Optimization Of Spectrally-Selective Solar Absorber Coatings At Mesoscale, Dale Karas

UNLV Theses, Dissertations, Professional Papers, and Capstones

A special class of cuprous-based inorganic oxide materials, synthesized as nanoparticles via hydrothermal and co-precipitation methods, are portable to spectrally-selective absorber coatings with high solar-thermal energy conversion efficiency. Operating reliably at elevated temperatures when used in tandem with solar concentrators, these materials enable cost-competitive solar energy conversion technology that can be incorporated with thermal energy storage systems, supporting the viability of novel renewable power generation; notably, optimizing absorptive performance while mitigating thermal losses through re-radiated waste heat motivates sustainable energy production particular to desert climates, where water conservation and ecological sensitivity needs are paramount.

This work targets the chemical synthesis …

High Early-Age Strength Concrete For Rapid Repair, Matthew O. Maler

UNLV Theses, Dissertations, Professional Papers, and Capstones

The aim of this research was to identify High Early-Age Strength (HES) concrete batch designs, and evaluate their suitability for use in the rapid repair of highways and bridge decks. To this end, two criteria needed to be met; a minimum compressive strength of 20.68 MPa (3000 psi) in no later than 12 hours, and a drying shrinkage of less than 0.06 % at 28 days after curing. The evaluations included both air-entrained, and non-air-entrained concretes.

The cement types chosen for this study included Type III and Type V Portland cement and “Rapid Set” − a Calcium Sulfoaluminate (CSA) cement. …

Mixed Convective Heat Transfer And Evaporation At The Air-Water Interface, Prasad Gokhale

All Theses

Functional forms for mixed convective heat transfer and evaporation from an air-water interface were obtained. To obtain these functions, heat transfer and evaporation rates from the air-water interface of an evaporating body of water were quantified in a wind/water tunnel in the presence of an oleyl alcohol monolayer on the water surface. The Nusselt (Nu) and Sherwood (Sh) numbers, parameterizing the dimensionless heat and mass transfer respectively, for transport from the water bulk to air were expressed as functions of the air side Rayleigh (Ra) and Reynolds (Re) numbers. The Nu and Sh were calculated for a range of Ra …