Engineering Science and Materials Commons^™

Effect Of Build Geometry And Build Parameters On Microstructure, Fatigue Life, And Tensile Properties Of Additively Manufactured Alloy 718, Anna Dunn

Browse all Theses and Dissertations

Additive Manufacturing (AM), particularly laser powder bed fusion, is being studied for use in critical component applications. Tensile and fatigue testing shows differences when built using different laser powers. However, when fabricated in an as-printed geometry, the gauge sections of the two specimens are different and experience different thermal behavior. This work explores microhardness, microstructure size, Niobium segregation, and porosity from samples made with varying laser power and different build geometry sizes representative of the gauge sections in the tensile and fatigue bars. Results show that microhardness varies spatially across the sample. Smaller diameter metallographic coupons (fatigue diameter) have a …

Comparison Of Additively Manufactured And Wrought 17-4 Ph Stainless Steels In Ultra Low Cycle Fatigue, Timothy Strasser

Graduate Theses and Dissertations

Additive manufacturing (AM) processes allow for creation of complex geometries that are otherwise impractical to fabricate with traditional subtractive methods. AM technology has potential to improve the optimization of seismic lateral force resisting components which dissipate seismic energy through large plastic strains; however, the ultra low-cycle fatigue performance of AM metals are not yet well understood. Void formation during the AM fabrication process has potential to affect performance. This study compares the performance of heat-treated and non-heat-treated AM and wrought 17-4PH stainless steel in Ultra Low Cycle Fatigue. To understand ULCF performance differences between the AM and wrought specimens, post …

Manufacture Of Fused Deposition Modeling Joints Using Ultem 9085, Zane A. Willburn

Theses and Dissertations

The manufacture of joints between a base structure and a structure manufactured via Fused Deposition Modeling (FDM) will be investigated. ULTEM 9085, a high temperature plastic with potential aerospace applications, will be the material used. The specific application this research is focused on is a robotic and mobile FDM printer capable of building structures onto other structures in space. A joint will be formed by fusing the base layer of the printed structure and the top of the base structure together. Tensile testing will be performed to determine the strength of the bond between parts. Tensile specimens will be manufactured …

Anisotropy Evolution Due To Surface Treatment On 3d-Printed Fused Deposition Modeling (Fdm) Of Acrylonitrile Butadiene Styrene (Abs), Blake E. Lozinski

Honors Undergraduate Theses

Purpose: This paper will present insight to the methodology and results of the experimental characterization of Acrylonitrile Butadiene Styrene (ABS) using Fused Deposition Modeling (FDM). The work in this research explored the effects of print orientation, surface treatment, and ultraviolet (UV) light degradation with the utilization of Digital Image Correlation (DIC) on ABS tensile specimens.

Design/methodology: ABS specimens were printed at three build orientations (flat (0 degrees), 45 degrees, and up-right (90 degrees)). Each of these specimens were treated with three different surface treatments including a control (acrylic paint, Cyanoacrylate, and Diglycidyl Bisphenol A) followed by exposure to UV light …