Engineering Science and Materials Commons^™

Characterization Of Carbon-Fiber Reinforced Polyetherimide Thermoplastic Composites Using Mechanical And Ultrasonic Methods, Mohannad A. Alhaidri

Theses and Dissertations

Continuous fiber-reinforced thermoplastics (CFRT) have the potential for being a mass-produced material for high-performance applications. The primary challenge of using CFRT is achieving fiber wet-out due to the high viscosity of thermoplastics. This results in higher temperatures and pressures required for processing the composites. Co-mingling thermoplastic fibers with a reinforcing fiber, potentially, can enable better wetting by reducing the distance the matrix needs to flow. This could result in shorter cycle times and better consolidation at lower temperatures and pressures. In this study, a polyetherimide (PEI) fiber was comingled with carbon fibers (CF). The resultant fibers were woven into fabrics …

Analysis Of Multi-Directional Recycled Jute Fiber Composite Behavior Using Experimental, Numerical, And Analytical Methods, Patrick Severson

Theses and Dissertations

Composite materials are increasing in popularity as a material of choice in many engineering applications. Major industries using composites include automotive, construction, and sports equipment. Most of the knowledge, research, and technology that will help decrease the cost of composite materials have been aimed at developing synthetic fibers as the reinforcing constituent.

This thesis characterizes jute fibers obtained as a byproduct from the coffee industry to determine if they can be viable in composite manufacturing. Experimental analysis, finite element analysis, and analytical modeling are used to characterize jute fiber based composites. Experimental analysis consists of jute fiber bundle tensile testing …

Natural Fibers And Fiberglass: A Technical And Economic Comparison, Justin Andrew Zsiros

Theses and Dissertations

Natural fibers have received attention in recent years because of their minimal environmental impact, reasonably good properties, and low cost. There is a wide variety of natural fibers suitable for composite applications, the most common of which is flax. Flax has advantages in tensile strength, light weight, and low cost over other natural fibers. As with other natural and synthetic fibers, flax is used to reinforce both thermoset and thermoplastic matrices. When flax is used in thermoplastic matrices, polypropylene and polyethylene are the main resins used. Although at first glance flax may seem to be a cheaper alternative to fiberglass, …