Open Access. Powered by Scholars. Published by Universities.®
Engineering Science and Materials Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering Science and Materials
Study On The Mechanical Behavior Of Directly Compounded Long Glass Fiber Reinforced Polyamide 6 Composites, Yuchao Liu
Study On The Mechanical Behavior Of Directly Compounded Long Glass Fiber Reinforced Polyamide 6 Composites, Yuchao Liu
Electronic Thesis and Dissertation Repository
With great lightweight potential, high performance-to-cost ratio and mass productivity, direct-compounded long fiber thermoplastics (D-LFT) have drawn great attention from the automotive industry. With better mechanical properties and higher service temperature, polyamide 6 (PA6) was used to replace polypropylene (PP) which is almost the exclusively used matrix for the D-LFT process currently. The investigation was performed on this new material with a focus on the effect of fiber content, processing parameters, temperature and tailored reinforcement on mechanical behavior. The results show that the mechanical properties of this new material are sensitive to the variation of fiber content and service temperature …
Environment-Induced Degradations In A Target Structural Material For Transmutation Applications, Ramprashad Prabhakaran
Environment-Induced Degradations In A Target Structural Material For Transmutation Applications, Ramprashad Prabhakaran
UNLV Theses, Dissertations, Professional Papers, and Capstones
This investigation is focused on the evaluation of stress corrosion cracking (SCC) and localized corrosion behavior of Type 422 stainless steel in aqueous environments at ambient and elevated temperature. The results of constant load SCC testing using smooth specimens showed no failure in the neutral solution but a threshold stress of 97 ksi was observed in the 90°C acidic environment. SCC testing by the slow-strain-rate test method indicate that the time-to-failure, true failure stress and ductility parameters were gradually reduced with increasing temperature, showing more pronounced effect in the acidic solution. The application of a controlled cathodic potential showed further …