Electronic Devices and Semiconductor Manufacturing Commons^™

A Low-Power Approach For Front End Biological Signal Conditioning, Logan Smith Taylor

Masters Theses

In a lab-on-a-chip (LOC) application, the measurement of small analog signals such as local temperature variation often involves detection of very low-level signals in a noisy micro-scale environment. This is true for other biomedical monitoring systems as well. These systems observe various physiological parameters or electrochemical reactions that need to be tracked electrically. For temperature measurement pyroelectric transducers represent an efficient solution in terms of speed, sensitivity, and scale of integration, especially when prompt and accurate temperature monitoring is desired.

The ability to perform laboratory operations on a small scale using miniaturized LOC devices is a promising biosensing technique. The …

Millimeter Wave Indium Phosphide Heterojunction Bipolar Transistors: Noise Performance And Circuit Applications, Metin Ayata

Masters Theses

The performance of III-V heterojunction bipolar transistors (HBTs) has improved significantly over the past two decades. Today’s state of the art Indium Phosphide (InP) HBTs have a maximum frequency of oscillation greater than 800 GHz and have been used to realize an amplifier operating above 600 GHz . In comparison to silicon (Si) based devices, III-V HBTs have superior transport properties that enables a higher gain, higher speed, and noise performance, and much higher Johnson figure- of-merit . From this perspective, the InP HBT is one of the most promising candidates for high performance mixed signal electronic systems.

Design And Evaluation Of An L-Band Current-Mode Class-D Power Amplifier Integrated Circuit, Michael J. Shusta

Masters Theses

Power amplifiers (PAs) convert energy from DC to high frequencies in all radio and microwave transmitter systems be they wireless base stations, handsets, radars, heaters, and so on. PAs are the dominant consumers of energy in these systems and, therefore, the dominant sources of system cost and inefficiency. Research has focused on efficient solid-state PA circuit topologies and their optimization since the 1960s. The 2000s saw the current-mode class-D (CMCD) topology, potentially suitable for today's wireless communications systems, show promise in the UHF frequency band. This thesis describes the design and testing of a high-efficiency CMCD amplifier with an integrated …

Low Pressure Chemical Vapor Deposition Of Semiconducting Boron Carbide Thin Films On Silicon, Thomas Gregory Wulz

Masters Theses

Boron carbide thin films were grown on the (100) plane of n-type silicon in a low pressure chemical vapor deposition (CVD) system from the thermal decomposition of boron trichloride and methane reactant gases with hydrogen as a carrier gas. Boron trichloride to methane molar ratio was 5, while the boron trichloride to hydrogen molar ratio was 3.5. Thin film deposition was carried out at 900 degrees Celsius at 25 Torr. The thin films were analyzed using scanning electron microscopy (SEM), transmission electron microscopy (TEM), Energy Dispersive X-Ray Spectroscopy (EDS), Laser Induced Breakdown Spectroscopy (LIBS), and current-voltage characteristics. The crystallography of …