Electromagnetics and Photonics Commons^™

Highly Directional Receiver And Source Antennas Using Photonic Band Gap Crystals, Rana Biswas, Gary L. Tuttle, Ekmel Ozbay, Burak Temelkuran, Mihail Sigalas, Kai-Ming Ho

Gary Tuttle

A directional antenna made with photonic band gap structures has been presented. The directional antenna is formed with two photonic band gap structures oriented back to back and separated from each other by a distance to form a resonant cavity between the photonic band gap structures. An antenna element is placed in the resonant cavity. The resonant frequency of the cavity is tuned by adjusting the distance between the photonic band gap structures. The resonant cavity can be asymmetrical or symmetrical.

Garnet Multilayer Thin Film Structure With Magnetostatically-Altered And Improved Magnetic Properties Prepared By Rf Magnetron Sputtering, Mohammad Nur-E-Alam, Mikhail Vasiliev, Viacheslav Kotov, Kamal Alameh

Mikhail Vasiliev

We prepare an all-garnet multilayer film structure by sandwiching a magneto-soft garnet material in between two magneto-hard garnet materials with high bismuth substitution levels using RF magnetron sputtering technique and investigate the microstructure and the effects of magnetostatic inter-layer coupling on magnetic properties. Both types of the Bi-substituted magneto-optic garnet materials used possess excellent optical, magnetic and magneto-optical properties suitable for the application in different new and emerging technologies in optics and photonics. Garnet layers of composition type Bi2Dy1Fe4Ga1O12 have strong perpendicular magnetic anisotropy and Bi1.8Lu1.2Fe3.6Al1.4O12 magneto-soft layer features magnetization behavior similar to that of in-plane magnetized films. The all-garnet …

Combinatorial Study Of Ni-Ti-Pt Ternary Metal Gate Electrodes On Hfo2 For The Advanced Gate Stack, K.-S. Chang, M. Green, J. Suehle, E. Vogel, H. Xiong, Jason Hattrick-Simpers, I. Takeuchi, O. Famodu, K. Ohmori, P. Ahmet, T. Chikyow, P. Majhi, B.-H. Lee, M. Gardner

Jason R. Hattrick-Simpers

The authors have fabricated combinatorial Ni–Ti–Pt ternary metal gate thin film libraries on HfO2 using magnetron co-sputtering to investigate flatband voltage shift (ΔVfb) , work function (Φm) , and leakage current density (JL) variations. A more negative ΔVfb is observed close to the Ti-rich corner than at the Ni- and Pt-rich corners, implying smaller Φm near the Ti-rich corners and higher Φm near the Ni- and Pt-rich corners. In addition, measured JL values can be explained consistently with the observed Φm variations. Combinatorial methodologies prove to be useful in surveying the large compositional space of ternary alloymetal gate electrode systems.

A Semi-Empirical Model For Tilted-Gun Planar Magnetron Sputtering Accounting For Chimney Shadowing, Johnathan Bunn, C. Metting, Jason Hattrick-Simpers

Jason R. Hattrick-Simpers

No abstract provided.

Giant Magnetostriction In Annealed Co1-XFeX Thin-Films, Dwight Hunter, Will Osborn, Ke Wang, Nataliya Kazantseva, Jason R. Hattrick-Simpers, Richard Suchoski, Ryota Takahashi, Marcus L. Young, Apurva Mehta, Leonid A. Bendersky, Same E. Lofland, Manfred Wuttig, Ichiro Takeuchi

Jason R. Hattrick-Simpers

Chemical and structural heterogeneity and the resulting interaction of coexisting phases can lead to extraordinary behaviours in oxides, as observed in piezoelectric materials at morphotropic phase boundaries and relaxor ferroelectrics. However, such phenomena are rare in metallic alloys. Here we show that, by tuning the presence of structural heterogeneity in textured Co_1−xFe_x thin films, effective magnetostriction λeff as large as 260 p.p.m. can be achieved at low-saturation field of ~10 mT. Assuming λ100 is the dominant component, this number translates to an upper limit of magnetostriction ofλ100≈5λeff >1,000 p.p.m. Microstructural analyses …

Combinatorial Study Of Thin Film Metal Hydride By Prompt Gamma Activation Analysis, L. Cao, Jason Hattrick-Simpers, R. Bindel, R. Bindel, B. Tomlin, R. Zeisler, R. Paul, L. Bendersky, R. Downing

Jason R. Hattrick-Simpers

No abstract provided.

Tunable Multiferroic Properties In Nanocomposite Pbtio3-Cofe2O4 Epitaxial Thin Films, M. Murakami, K.-S. Chang, M. Aronova, C.-L. Lin, Ming Yu, Jason Hattrick-Simpers, M. Wuttig, I. Takeuchi, C. Gao, B. Hu, S. Lofland, L. Knauss, L. Bendersky

Jason R. Hattrick-Simpers

We report on the synthesis of PbTiO3–CoFe2O4 multiferroic nanocomposites and continuous tuning of their ferroelectric and magnetic properties as a function of the average composition on thin-film composition spreads. The highest dielectric constant and nonlinear dielectric signal was observed at (PbTiO3)85–(CoFe2O4)15, where robust magnetism was also observed. Transmission electron microscopy revealed a pancake-shaped epitaxial nanostructure of PbTiO3 on the order of 30 nm embedded in the matrix of CoFe2O4 at this composition. Composition dependent ferroics properties observed here indicate that there is considerable interdiffusion of cations into each other.

Exploration Of Artificial Multiferroic Thin-Film Heterostructures Using Composition Spreads, K.-S. Chang, M. A. Aronova, C.-L. Lin, M. Murakami, M.-H. Yu, Jason R. Hattrick-Simpers, O. O. Famodu, S. Y. Lee, R. Ramesh, M. Wuttig, I. Takeuchi, C. Gao, L. A. Bendersky

Jason R. Hattrick-Simpers

We have fabricated a series of composition spreads consisting of ferroelectric BaTiO₃ and piezomagnetic CoFe₂O₄ layers of varying thicknesses modulated at nanometer level in order to explore artificial magnetoelectricthin-film heterostructures. Scanning microwavemicroscopy and scanning superconducting quantum interference device microscopy were used to map the dielectric and magnetic properties as a function of continuously changing average composition across the spreads, respectively. Compositions in the middle of the spreads were found to exhibit ferromagnetism while displaying a dielectric constant as high as ≈120.

Multimode Quantitative Scanning Microwave Microscopy Of In Situ Grown Epitaxial Ba1-XSrXTio3 Composition Spreads, K. Chang, M. Aronova, O. Famodu, I. Takeuchi, S. Lofland, Jason Hattrick-Simpers, H. Chang

Jason R. Hattrick-Simpers

We have performed variable-temperature multimode quantitative microwavemicroscopy of in situepitaxial Ba1−xSrxTiO3 thin-film composition spreads fabricated on (100) LaA1O3 substrates. Dielectric properties were mapped as a function of continuously varying composition from BaTiO3 to SrTiO3. We have demonstrated nondestructive temperature-dependent dielectric characterization of local thin-film regions. Measurements are simultaneously taken at multiple resonant frequencies of the microscope cavity. The multimode measurements allow frequency dispersion studies. We observe strong composition-dependent dielectric relaxation in Ba1−xSrxTiO3 at microwave frequencies.

Refractory Plasmonics With Titanium Nitride: Broadband Metamaterial Absorber, W Li, U. Guler, N. Kinsey, G. Naik, A. Boltasseva, J. Guan, V Shalaev, A. Kildishev

U. Guler

A high-temperature stable broadband plasmonic absorber is designed, fabricated, and optically characterized. A broadband absorber with an average high absorption of 95% and a total thickness of 240 nm is fabricated, using a refractory plasmonic material, titanium nitride. This absorber integrates both the plasmonic resonances and the dielectric-like loss. It opens a path for the interesting applications such as solar thermophotovoltaics and optical circuits.

Refractory Plasmonics, Urcan Guler, Alexandra Boltasseva, Vladimir M. Shalaev

U. Guler

Refractory materials are defined as those with a high melting point and chemical stability at temperatures above 2000°C. Applications based on refractory materials, usually nonmetallic, span a wide range of areas including industrial furnaces, space shuttle shields, and semiconductor technology. Metals have also been studied as refractories; however, the optical properties of those metals that have been tried for high-temperature applications were not good enough to be used in plasmonic applications (these are almost entirely based on noble metals, which are not good refractories). Refractory materials that exhibit reasonably good plasmonic behavior would undoubtedly enable new devices and boost such …

Nuclear Emp Hardening Approach As The Basis For Unified Electromagnetic Environmental Effects Protection, George H. Baker Iii

George H Baker

Operation DESERT STORM demonstrated the clear military advantage that was provided by our sophisticated electronic C4I and weapons systems. High tech means so dominate the battlefield that the outcome of future conflicts could be decided by electronics attrition rather than human casualties. However, the electromagnetic threat landscape is highly complex. The already formidable list of environments (EMI, lighting, ESD, EMP, HERO, TEMPEST, EW, etc.) is lengthened by emerging threats from high power microwave (HPM) and ultra-wide band (UWB) electromagnetic weapons. Many of these environments overlap in the frequency and amplitude of the electrical stresses they create.

The large number of …