Open Access. Powered by Scholars. Published by Universities.®
- Publication Type
Articles 1 - 3 of 3
Full-Text Articles in Electrical and Electronics
Lithium-Based Battery System Management And Balancing, William Joel Schmidt Iii
Lithium-Based Battery System Management And Balancing, William Joel Schmidt Iii
Purdue Polytechnic Masters Theses
This thesis builds upon previous work completed for the design and evaluation of active lithium battery system management. Simulations were performed to provide a comparison for the hardware that was designed, built, and tested. An analysis of the simulation and hardware results was completed to support or disprove the initial hypothesis. A DC-DC converter was used as the source for the balancing current. Lithium polymer batteries with a 5Ah capacity were used for testing the designed hardware. The findings showed that there is a reduction in the system voltage swing during balancing as well as less time taken to decrease …
Exercise Bicycle Dc-Dc Converter For The Energy Harvesting From Exercise Machines Project, Ryan Rickard, Logan Stowe
Exercise Bicycle Dc-Dc Converter For The Energy Harvesting From Exercise Machines Project, Ryan Rickard, Logan Stowe
Electrical Engineering
Project is a continuation of previous projects that seek an efficient DC to DC converter for the existing exercise bicycle system created by Mechanical and Electrical Engineering students. This DC-DC converter is to integrate with the wide range of DC voltages produced by the bicycle in order to produce a constant optimal voltage for charging a car battery. This converter will boost voltages when the bicycle outputs below the optimal voltage and buck voltages when above. The converter will take EHFEM one step closer to its overall and final goal of harvesting energy from the exercise machines in Cal Poly’s …
Elliptical Machine Dc-Dc Converter For The Energy Harvesting From Exercise Machines Project, Greg Hollister
Elliptical Machine Dc-Dc Converter For The Energy Harvesting From Exercise Machines Project, Greg Hollister
Electrical Engineering
Designing a DC/DC Converter for the Cal Poly Energy Harvesting from Exercise Machines project requires special attention to the unique operating characteristics of the source and the load. An elliptical machine powered by a person exercising comprises the source, while an AC Inverter makes up the load. This project attempts to integrate the two devices with a custom DC/DC Converter in order to ultimately deliver power back into the power grid.