Electrical and Electronics Commons^™

Design And Fabrication Of A Force-Displacement Control Mechanism For Bone-Surgical Tool Testing, Kenneth Nwagu

Electronic Theses and Dissertations

This project focuses on the design and fabrication of an experimental setup for orthopedic-tool testing, tailored for a surgical instrumentation company. The multifaceted project encompasses a literature review, conceptual design, prototyping, and rigorous testing, resulting in a versatile control system capable of assessing various orthopedic tools, including bone drills, saws, burrs, and power handpieces.

Orthopedic surgical procedures (which include cutting and/or drilling into bone) often need to be performed on bones for faster recovery. The drilling and cutting process can cause an increase in temperature at the cutting site which can cause bone necrosis. The tools also need to be …

Reference Governors For Time-Varying Systems And Constraints, Collin Freiheit

Graduate College Dissertations and Theses

Control systems are often subject to constraints imposed by physical limitations or safety considerations, and require means of constraint management to ensure the stability and safety of the system. For real-time implementation, constraint management schemes must not carry a heavy computational burden; however many of the current solutions are computationally unattractive, especially those with robust formulations. Thus, the design of constraint management schemes with low computational loads is an important and practical problem for control engineers. Reference Governor (RG) is an efficient constraint management scheme that is attractive for real-time implementation due to its low computational complexity and ease of …

A Comparison And Evaluation Of Common Pid Tuning Methods, Justin Youney

Electronic Theses and Dissertations

The motivation behind this thesis is to consolidate and evaluate the most common Proportional Integral Derivative (PID) controller tuning techniques used in industry. These are the tuning techniques used when the plant transfer function is not known. Many of these systems are poorly tuned because such consolidated information is not easily found in one single source such as this thesis. Once one of the tuning methods are applied almost always there will be further fine tuning needed to bring the system into the required design criteria. The purpose here is to find out which tuning technique will yield the lowest …