Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Keyword
-
- Controller (1)
- Cycle annealing (1)
- FFT (1)
- Harmonic extraction (1)
- Harmonic mitigation (1)
-
- IEEE STD 519 (1)
- InGaP/InAlGaP (1)
- Induction motor (1)
- Lasers (1)
- Orange & yellow emitters (1)
- Power Factor correction (1)
- Quantum-well intermixing (1)
- Required acceleration rate (1)
- STATCOM (1)
- STATCOM control system (1)
- Starting current (1)
- Starting torque (1)
- Strain (1)
- THD (1)
- Variable-frequency drive (1)
Articles 1 - 3 of 3
Full-Text Articles in Electrical and Electronics
A New Method To Start Loaded Induction Motors, Omar El-Sayed Mohammed Youssef
A New Method To Start Loaded Induction Motors, Omar El-Sayed Mohammed Youssef
Journal of Engineering Research
Three-phase induction motors have a widespread use in industry, and starting of loaded induction motors is an important matter. However, there are few studies on motor starting using variable-frequency drives (VFDs). The existing control schemes, described by these studies, have disadvantages such as dependence on derived characteristics, adjustment of settings, design of controllers, or burden of calculations on the control processor. In this paper, a simple and effective control scheme of VFDs to start loaded motors is proposed. In this scheme, there is no dependence on any characteristic, adjustment of settings, controllers, and rotor speed sensor. By this scheme, the …
First Demonstration Of Orange-Yellow Light Emitter Devices In Ingap/ Inalgap Laser Structure Using A Strain-Induced Quantum Well Intermixing Technique, Bayan A. Alnahhas
First Demonstration Of Orange-Yellow Light Emitter Devices In Ingap/ Inalgap Laser Structure Using A Strain-Induced Quantum Well Intermixing Technique, Bayan A. Alnahhas
Effat Undergraduate Research Journal
In this paper, a novel strain-induced quantum well intermixing (QWI) technique is employed on an InGaP/InAlGaP material system to promote interdiffusion via application of a thick-dielectric encapsulant layer, in conjunction with cycle annealing at elevated temperature. With this technique, we demonstrate the first yellow superluminescent (SLD) at a wavelength of 583nm with a total two-facet output power of ~4.5mW—the highest optical power ever reported at this wavelength in this material system. The demonstration of the yellow SLD without complicated multiquantum barriers to suppress the carrier overflow will have a great impact in realizing the yellow laser diode that cannot be …
A New Method Of Statcom Controlling For Harmonic Mitigation And Power Factor Correction, Doha Jdeed
A New Method Of Statcom Controlling For Harmonic Mitigation And Power Factor Correction, Doha Jdeed
Journal of the Arab American University مجلة الجامعة العربية الامريكية للبحوث
This paper presents a control algorithm of 3ph STATic synchronous COMpensator (STATCOM). The algorithm depends on the accurate reference currents extraction from only the nonlinear load current spec-trum in frequency domain using Fast Fourier Transfer (FFT). Then the determined harmonics and reactive components of load current are added together to form the compensating reference signals, the PI controllers then generate signals which control the Pulse Width Modulation (PWM) method. The simulation of the study is carried out under MATLAB/Simulink environment to show the usefulness of this control algorithm with nonlin-ear dynamic loads. It determines exactly the phase shift between the …