Electrical and Electronics Commons^™

Design And Development Of Rapid Battery Exchange Systems For Electric Vehicles To Be Used As Efficient Student Transportation, Jonathan A. Bevier

Master's Theses

Rapid battery exchange systems were built for an electric van and pedal assist electric bike as a method of eliminating the need to recharge the vehicles batteries in order to increase the feasibility of using electric propulsion as a method of efficient student transportation. After selecting proper materials it was found that the systems would need a protective coating to ensure consistent operation. 1020 cold rolled steel samples coated with multiple thicknesses of vinyl resin paint, epoxy resin paint, and powder coating were subjected to environmental wear tests in order to determine if the type and thickness of common protective …

Analysis And Design Of Continuous Input Current Multiphase Interleaved Buck Converter, Sean Michael Zich

Master's Theses

The power requirements for microprocessors have been increasing per Moore's Law. According to International Technology Roadmap (ITRS), Voltage Regulator Module (VRM) for microprocessors will be about 200 W at 1 V output in 2010. With the VRM’s topology of synchronous buck, serious technical challenges such as small duty cycle, high switching frequencies, and higher current demands, contribute to decreased power density and increased cost.

This thesis proposes a Continuous Input Current Multiphase Interleaved Buck topology to solve the technical challenges of powering future microprocessors. This new topology is aimed to improve past topologies by providing continuous input current and improved …