Electrical and Electronics Commons^™

Feedback Correction Of Angular Error In Grating Readout, Monish Ranjan Chatterjee, Sundaram Ramachandran

Electrical and Computer Engineering Faculty Publications

Angular and wavelength READ beam errors in holographic interconnection systems are often a recurrent problem. Several strategies have been proposed to minimize or eliminate such READOUT misalignments.

Some years ago, Chatterjee and co-workers proposed a method involving READ beam wavelength tuning to correct output angular errors. In this paper, we investigate the possibility of using an acousto-optic (A-O) Bragg cell with optoelectronic feedback to dynamically correct the scattered beam for deviations in the incidence direction of the READ beam of a hologram. The concept here is based on an acoustic frequency feedback strategy used recently by Balakshy and Kazaryan for …

Overview Of Acousto-Optic Bistability, Chaos, And Logical Applications, Monish Ranjan Chatterjee, Erol Sonmez

Electrical and Computer Engineering Faculty Publications

An overview is presented of the key results in the field of acousto-optic bistability in the past two decades. It is shown that the basic acousto-optic bistable device may be described as a nonlinear dynamical system which satisfies a quadratic map. Thereafter, details are presented of several analytical methods, computer modeling approaches, including the SPICE circuit modeling technique, and experiments that have been used to understand the phenomenon.

Extensions to logical and digital applications are also discussed.

The Determination Of Failure Occurring In The Stator Coil Winding Due To The Over-Voltage Using Matlab Software, Ali Reza Alavizadeh

Morehead State Theses and Dissertations

A thesis presented to the faculty of the College of Science & Technology at Morehead State University in partial fulfillment of the requirements for the Degree of Master of Science in Vocational Education / Technology by Ali Reza Alavizadeh on January 8, 2001.

Study Of Dynamics And Mechanism Of Metal-Induced Silicon Growth, Elena A. Guliants, Wayne A. Anderson

Electrical and Computer Engineering Faculty Publications

The present study addresses the mechanism of metal-induced growth of device-quality silicon thin films. Si deposition was performed by magnetron sputtering on a 25-nm-thick Ni prelayer at 525–625 °C and yielded a continuous, highly crystalline film with a columnar structure. A Ni disilicide intermediate layer formed as a result of the Ni reaction with Si deposit provides a sufficient site for the Si epitaxial growth because lattice mismatch is small between the two materials. The reaction between Ni and Si was observed to progress in several stages. The NixSiy phase evolution in a Ni:Si layer was studied by x-ray photoelectron …