Controls and Control Theory Commons^™

Analysis Of Three-Phase Rectifier Via Three Different Control Methods And Switch Power Loss Comparison, Yichao Wang

All Graduate Theses, Dissertations, and Other Capstone Projects

Traditional uncontrolled or phase-controlled rectifiers have the defects of lower power factor and nontrivial higher harmonics which causes the low efficiency of power, bad power quality, and so on. However, PWM rectifiers overcome the drawbacks mentioned above. They reduce the higher harmonics yielding better sinusoidal current on the grid side, achieve unity power factor and bidirectional power flow, and have better dynamic performance. So, it is favored more by academia and widely applied in high-performance power electronics devices. In this paper, the PWM rectifier is analyzed and a comparison of the switch loss on three-phase rectifier using three different control …

Implementation Of Model-Free Adaptive Power Flow Control For Dual-Active-Bridge-Based Ac-Dc Converters, Qinghang Shen

All Graduate Theses, Dissertations, and Other Capstone Projects

With the rising energy consumption and environment destruction problems worldwide, the development of renewable energy and energy recapture methods to improve the energy utilization rate has become more important as two of the most efficient processes to solve those problems. Bidirectional AC/DC converter and its modulation strategies are widely used as the essential part of implementing bidirectional power conversion between power grid and energy storage systems. To improve the efficiency and accuracy of the power conversion within AC/DC converters, a stable, robust power flow control system with quick response and disturbance rejection ability is desired. This thesis proposes a model-free …

A Four-Port Bidirectional Dc-Dc Converter For Renewable Energy System And Microgrid, Xia Du

All Graduate Theses, Dissertations, and Other Capstone Projects

Renewable energy has nowadays become important in electrical power applications. Power converters play an important role in integrating these distributed energy sources. However, due to their intermittence characteristics, e.g., the output power provided by the PV and wind turbine is not stable, either an energy storage system will be used or microgrid is formed between the main grid and the sources. To integrate these renewable energy sources and manage the power flow, a multiport converter is preferred because it is highly beneficial and cost-efficiently than the traditional solution that using multiple individual power converter for each source. This thesis proposed …

Control Of A Grid-Tied Single-Phase Inverter For Renewable Energy Integration, Dianzhi Yu

All Graduate Theses, Dissertations, and Other Capstone Projects

With increasing demand for generating electricity from clean energy, renewable energy sources (RESs), such as wind and solar, has gained much attention due to the clean and quiet characteristics. In many applications, connecting multiple RESs of different types (e.g., wind and solar), voltages, and capacities to a power grid or load is required. Single- phase inverters have been widely installed in residential power system to meet the full or partial load demand. In this work, multiport converters were developed for integrating multiple RESs, wind turbine and photovoltaic (PV) panel. Since the intermittent characteristic of the RESs, an energy storage device, …

A Four-Port Dc-Dc Converter For A Hybrid Wind/Solar Energy System, Jiahong Ning

All Graduate Theses, Dissertations, and Other Capstone Projects

With the increasing demand for clean and hybrid energy in the last decades, more and more attentions are paid to the renewable energy, e.g., wind and solar energy. According to the International Energy Agency, solar power was growing-fastest source in the world. In a hybrid wind/solar system, power converters play an important role in in power management and the voltage regulation. Gradually, power systems have undergone a paradigm shift from centralized generation to distributed generation. Smart grid, which is a combination of power systems and communication networks, was proposed to allow power systems to fit the future system challenge. However, …

Application Of Droop Control And Synchronization For Single-Phase Inverters In Ac Microgrid Integration, Shuai Yang

All Graduate Theses, Dissertations, and Other Capstone Projects

With the increasing requirements on environment-friendly and sustainable clean energy [1], people have paid more attention to renewable energy around the world in the past few decades. As a result, power systems have undergone a paradigm shift from centralized generation to distributed generation. Smart grids, which are a combination of power systems and communication networks, were proposed to allow power systems to meet future challenges. In smart grids, especially in AC microgrids, converters play an important role in many areas including microgrid integration, uninterrupted power supply, and flexible alternating current transmission systems. The inverter is a power conversion device [2] …

Robust Power Interface For Smart Grid With Renewable Energy Source-To-Grid Functionality, Bohyun Ahn

All Graduate Theses, Dissertations, and Other Capstone Projects

Many renewable energy companies design wind turbine generators, solar panels, or electrical car batteries with different specifications according to their management philosophy. And typical commercial power converters are not universally designed for all different types of renewable energy systems. Because of this lack of flexibility and interoperability, a universal and scalable smart grid power converter design is desirable. Designing a robust controlled bi-directional power converter is the motivation for this thesis as the first step to develop a more universal converter topology connecting renewable energy sources and the electrical smart-grid of the future.

Renewable energy such as wind or solar …