Controls and Control Theory Commons^™

Design And Implementation Of Ccny Dc Microgrid Testbed, Mahmoud Saleh, Yusef Esa, Yassine Mhandi, Werner Brandauer, Ahmed Mohamed

Publications and Research

This paper presents the design, control, energy management, and implementation of the City College of New York (CCNY) direct current (DC) microgrid laboratory testbed. This facility was custom designed and implemented by researchers at CCNY with minimal off-the-shelf components to enable significant flexibility and reconfiguration capability. The microgrid consists of renewable energy resources, energy storage system and controllable loads, and can operate in either a grid-connected or an islanded mode. The design steps, requirements, and results of the developed testbed were discussed. Moreover, several operational scenarios were tested. The experimental results verify the applicability and flexibility of the developed microgrid …

A System For Monitoring And Managing Indoor Air Quality And Environmental Conditions, Ali Ibrahim

Boise State University Theses and Dissertations

The quality of indoor air depends on different types of pollutant sources existing in a semi-enclosed environment. The sources can be biological, chemical, or toxic pollutants. These sources can cause health issues and discomfort for occupants. One of the indicators of poor indoor air quality is Carbon Dioxide (CO₂). CO₂ can be used to indicate the indoor air exchange rate. The lack of air exchange means higher levels of CO₂. High levels of indoor particulates can also be an indication of poor air quality. Due to the lack of fresh air, air circulation, and air …

A Stroke Therapy Brace Design, Evan Kirkbride

Electrical Engineering

Victims of stroke often have difficulty with rehabilitation. With limited movement on their affected arm, patients often do not want to move much for physical therapy. In this project, we design a robotic brace that helps stroke patients move their arm more effectively in a reaching or pulling motion. By giving patients more movement in their affected arm than they would have otherwise, patients gain more from rehabilitation. The brace also adapts to the patient’s needs, providing more inclination or resistance as needed for their physical therapy. This kind of therapy engages patients rather than relying on their likely dwindled …

Cal Poly Supermileage Electronic Fuel Injection, Alexander Pink

Electrical Engineering

Cal Poly Supermileage is a student-run engineering club that builds prototype gasoline vehicles optimized maximum fuel-efficiency. To power their vehicles, the Supermileage team makes use of single-cylinder, 4-stroke, electronically fuel-injected (EFI) gasoline engines. This report details the development, iterative design & test cycles, and integration of an EFI system for the Supermileage club. This project develops an EFI system that interfaces to the most common types of sensors found in the low-power Supermileage-range of engines, including throttle-position sensors, manifold absolute pressure sensors, gear-tooth hall-effect sensors, variable-reluctance position sensors, engine coolant temperature sensors, intake air temperature sensors, and exhaust oxygen sensors. …

Exertion Control, Travis Taylor

Electrical Engineering

Current wearable fitness devices give the user after-the-fact fitness data, but little real-time feedback. Exertion Control, a new wearable device, continuously measures the user’s heart rate, creates a heart rate target, and helps the user reach it. This project completes the senior design and master’s thesis requirements and contains two milestones. The senior design product continuously measures the wearer’s heart rate and logs it with a user-friendly interface. This data models the heart’s exertion response and recovery response. The master’s thesis device refines the closed control loop with the user to give them a workout optimized to fit their needs.

Impact Of Clustering Microgrids On Their Stability And Resilience During Blackouts, Mahmoud S. Saleh, Ammar Althaibani, Yusef Esa, Yassine Mhandi, Ahmed Mohamed

Publications and Research

In this paper, the impact of clustering multiple microgrids during blackouts, on their stability and supply availability, will be investigated. Microgrids have the capability of satisfying their emergency loads during blackouts. However, distributed energy resources (DERs)-dominated microgrids are affected by the uncertainty of their input energy supply, e.g. impact of solar irradiance on photovoltaic (PV) output. Moreover, an individual islanded microgrid is prone to instability issues due to large sudden load/generation changes. In order to increase the supply security, and enhance system stability, we propose to use the existing distribution grid infrastructure, if applicable, during blackouts to form microgrid clusters. …

Sensorless Rotor Position Estimation For Brushless Dc Motors, Iram G. Raza

Electronic Thesis and Dissertation Repository

Brushless DC motor speed is controlled by synchronizing the stator coil current with rotor position in order to acquire an accurate alignment of stator rotating field with rotor permanent-magnet field for efficient transfer of energy. In order to accomplish this goal, a motor shaft is instantly tracked by using rotating rotor position sensors such as Hall effect sensors, optical encoders or resolvers etc. Adding sensors to detect rotor position affects the overall reliability and mechanical robustness of the system. Therefore, a whole new trend of replacing position sensors with sensorless rotor position estimation techniques have a promising demand.

Among the …

Out-Of-Loop Compensation Method For Op-Amps Driving Heavy Capacitive Loads, Shubham Gandhi

Master's Theses

It is well known that real op-amps do not share most of the desirable characteristics of an ideal one, particularly those of gain and output impedance. When presented with a capacitive load, such as a MOSFET or ADC, feedback in an op-amp circuit can quickly become unstable. This thesis studies and characterizes an op-amp’s output impedance and how its interaction with this type of load creates a parasitic pole which leads to instability. Applying ideas from feedback control theory, a model for studying the problem is developed from which a generalized method for compensating the undesirable circumstance is formulated.

Even …

Sparse Adaptive Local Machine Learning Algorithms For Sensing And Analytics, Jack Cannon

Undergraduate Research & Mentoring Program

The goal of digital image processing is to capture, transmit, and display images as efficiently as possible. Such tasks are computationally intensive because an image is digitally represented by large amounts of data. It is possible to render an image by reconstructing it with a subset of the most relevant data. One such procedure used to accomplish this task is commonly referred to as sparse coding. For our purpose, we use images of handwritten digits that are presented to an artificial neural network. The network implements Rozell's locally competitive algorithm (LCA) to generate a sparse code. This sparse code is …

A Lithium Battery Current Estimation Technique Using An Unknown Input Observer, Daniel Cambron

Theses and Dissertations--Electrical and Computer Engineering

Current consumption measurements are useful in a wide variety of applications, including power monitoring and fault detection within a lithium battery management system (BMS). This measurement is typically taken using either a shunt resistor or a Hall-effect current transducer. Although both methods have achieved accurate current measurements, shunt resistors have inherent power loss and often require isolation circuitry, and Hall-effect sensors are generally expensive. This work explores a novel alternative to sensing battery current by measuring terminal voltages and cell temperatures and using an unknown input observer (UIO) to estimate the battery current. An accurate model of a LiFePO_{4 …}

Comparing Various Hardware/Software Solutions And Conversion Methods For Controller Area Network (Can) Bus Data Collection, Samuel E. Marx, Joe D. Luck, Santosh Pitla, Roger M. Hoy

Biological Systems Engineering: Papers and Publications

Various hardware and software solutions exist for collecting Controller Area Network (CAN) bus data. Digital data accuracy could vary based upon different data logging methods (e.g., hardware/software timing, processor timing, etc.). CAN bus data were collected from agricultural tractors using multiple data acquisition solutions to quantify differences among collection methods and demonstrate potential data accumulation rates. Two types of data were observed for this study. The first, CAN bus frame data, represents data collected for each line of hex data sent from an ECU. One issue with frame data is the resulting large file sizes, therefore a second logging format …

Small Satellite Noncommutative Rotation Sequence Attitude Control Using Piezoelectric Actuators, Joshua L. Evans

Theses and Dissertations--Electrical and Computer Engineering

Attitude control remains one of the top engineering challenges faced by small satellite mission planning and design. Conventional methods for attitude control include propulsion, reaction wheels, magnetic torque coils, and passive stabilization mechanisms, such as permanent magnets that align with planetary magnetic fields. Drawbacks of these conventional attitude control methods for small satellites include size, power consumption, dependence on external magnetic fields, and lack of full control authority. This research investigates an alternative, novel approach to attitude-control method for small satellites, utilizing the noncommutative property of rigid body rotation sequences. Piezoelectric bimorph actuators are used to induce sinusoidal small-amplitude satellite …