Design, Fabrication And Characterization Of Zero Power Sensor/Harvester For Smart Grid Applications, Zeynel Guler

Mechanical Engineering ETDs

This study presents a flexible sensor/harvester device to be used in both electromagnetic sensing and energy harvesting applications for smart grids. When a current passes through a wire, the sensor detects the magnetic field created by that current. The sensor magnet interacts with the wire magnetic field resulting in a transfer of energy through the piezoelectric cantilever. Piezoelectric, conductive, magnetic, and magnetostrictive composite thin films were prepared to fabricate this device.

Initially, the magnet of the cantilever was optimized considering its shape, thickness, length, taper angle etc. via both simulations and experiments. Peak to peak voltage versus cantilever position graph …

Material Characterization And Comparison Of Sol-Gel Deposited And Rf Magnetron Deposited Lead Zirconate Titanate Thin Films, Katherine Lynne Miles

Mechanical Engineering ETDs

Lead zirconate titanate (PZT) has been a material of interest for sensor, actuator, and transducer applications in microelectromechanical systems (MEMS). This is due to their favorable piezoelectric, pyroelectric and ferroelectric properties. While various methods are available to deposit PZT thin films, radio frequency (RF) magnetron sputtering was selected to provide high quality PZT films with the added capability of batch processing. These sputter deposited PZT films were characterized to determine their internal film stress, Young’s modulus, composition, and structure. After characterization, the sputtered PZT samples were poled using corona poling and direct poling methods. As a means of comparison, commercially …

Dc Microgrid Fault Detection Using Multiresolution Analysis Of Traveling Waves, Rudy Montoya

Mechanical Engineering ETDs

Fast detection and isolation of faults in a DC microgrid is of particular importance. Fast tripping protection (i) increases the lifetime of power electronics (PE) switches by avoiding high fault current magnitudes and (ii) enhances the controllability of PE converters. This thesis proposes a traveling wave (TW) based scheme for fast tripping protection of DC microgrids. The proposed scheme utilizes a discrete wavelet transform (DWT) to calculate the high-frequency components of DC fault currents. Multiresolution analysis (MRA) using DWT is utilized to detect TW components for different frequency ranges. The Parseval energy calculated from the MRA coefficients are then used …

Dc Microgrid Fault Detection Using Multiresolution Analysis Of Traveling Waves, Rudy Montoya

Mechanical Engineering ETDs

Fast detection and isolation of faults in a DC microgrid is of particular importance. Fast tripping protection (i) increases the lifetime of power electronics (PE) switches by avoiding high fault current magnitudes and (ii) enhances the controllability of PE converters. This thesis proposes a traveling wave (TW) based scheme for fast tripping protection of DC microgrids. The proposed scheme utilizes a discrete wavelet transform (DWT) to calculate the high-frequency components of DC fault currents. Multiresolution analysis (MRA) using DWT is utilized to detect TW components for different frequency ranges. The Parseval energy calculated from the MRA coefficients are then used …

Zero-Power Ac Current Sensor, Omar Aragonez

Mechanical Engineering ETDs

In this study, a magnetic piezoelectric cantilever powered AC current and frequency sensor is proposed. This paper covers the configuration of the experimental setup, finite element modeling of the magnetic coupling, and the optimal spatial location of the magnetic proof mass in relation to the wire for smart grid applications. Solid and stranded copper wires of various gauges were used and carried current up to 30A. The magnets act as a proof mass to lower the frequency while also coupling to the magnetic field generated by the current carrying wire. The frequency of the AC current produces a sinusoidal force …

Intra-Hour Solar Forecasting Using Cloud Dynamics Features Extracted From Ground-Based Infrared Sky Images, Guillermo Terrén-Serrano

Electrical and Computer Engineering ETDs

Due to the increasing use of photovoltaic systems, power grids are vulnerable to the projection of shadows from moving clouds. An intra-hour solar forecast provides power grids with the capability of automatically controlling the dispatch of energy, reducing the additional cost for a guaranteed, reliable supply of energy (i.e., energy storage). This dissertation introduces a novel sky imager consisting of a long-wave radiometric infrared camera and a visible light camera with a fisheye lens. The imager is mounted on a solar tracker to maintain the Sun in the center of the images throughout the day, reducing the scattering effect produced …

Machine Learning Based Dynamic Power Dispatching And Smoothing Using Hybrid Energy Storage System For Renewable Energy Systems, Bhuvaneshwarr Ramalingam

Electrical and Computer Engineering ETDs

The stochastic fluctuations from Renewable Energy Resources (RER) have a great influence on power quality and off-grid communities. A combination of the different storage systems is accessible for RER generation intermittency and to bring about finest smoothing operating cycle compared to sole Energy Storage System (ESS). Additionally, energy management in Hybrid Energy Storage System (HESS) creates an uncertainty during power smoothing operation. This research materializes, an intelligent mechanism for power smoothing and dispatch with the introduction of hybridized storage that can accommodate the unpredictable behavior of RER under dynamic load. A feed-forward neural network is proposed as a power smoothing …

The Picture Fuzzy Distance Measure In Controlling Network Power Consumption, Florentin Smarandache, Ngan Thi Roan, Salvador Coll Arnau, Marina Alonso Diaz, Juan Miguel Martinez Rubio, Pedro Lopez, Fran Andujar, Son Hoang Lee, Manh Van Vu

Branch Mathematics and Statistics Faculty and Staff Publications

In order to solve the complex decision making problems, there are many approaches and systems based on fuzzy theory were proposed.

Symmetry And Dopant Diffusion In Inverted Nanopyramid Arrays For Thin Crystalline Silicon Solar Cells, Seok Jun Han

Chemical and Biological Engineering ETDs

In this dissertation, we enhance the efficiency of thin flexible monocrystalline silicon solar cells by breaking symmetry in light trapping nanostructures and improving homogeneity in dopant concentration profile. These thin cells are potentially less expensive than conventional thick silicon cells by using less silicon material and making the cells more convenient to be handled when supported on polymer films. Moreover, these cells are widely applicable due to their flexibility and lightweight. However, for high efficiencies, these cells require effective light trapping and charge collection. We achieve these in cells based on 14-mm-thick free-standing silicon films with light-trapping arrays of nanopyramidal …

Co-Simulation Framework For Power Distribution System Analysis With Humans In The Loop, Victor H. Ayon

Mechanical Engineering ETDs

Recent developments in the area of power generation have led to an increased penetration of storage and distributed energy resources (DER) in power distribution systems. As a result, new and enhanced energy management systems will be necessary as the deployment of DERs, as well as the need to control loads, continues to increase in the coming years. Advanced management systems are especially important to achieve resilient power delivery during emergency situations. During a blackout for example, a section of a distribution feeder could island to operate as a microgrid to ensure critical services such as water, food, and medical care …

Integration Of Thin Film Tpv Cells To Cvd Diamond Heat Spreaders, Emma J. Renteria

Electrical and Computer Engineering ETDs

In this work, techniques to isolate thermophotovoltaic (TPV) devices from the growth substrate and their subsequent integration with Chemical Vapor Deposition (CVD) diamond heat spreaders will be discussed, with the envisioned goal of fabricating thermally managed cells. CVD diamond heat spreaders are a great option for thermal management of TPV cells. The key requirement, however, is the bonding of the TPV cell directly onto the diamond wafer without the presence of thick (>350 μm) growth substrates, which can offer significant thermal resistance.

The first approach is to release GaSb epitaxial layers from GaSb substrates. However, this is challenging due …

Design & Evaluation Of A Hybrid Switched Capacitor Circuit With Wide-Bandgap Devices For Dc Grid Applications, Joshua L. Stewart

Electrical and Computer Engineering ETDs

ABSTRACT

As technologies advance, the rate at which renewable power sources, such as solar photovoltaic (PV) and wind, are being added to the power grid is increasing. Typically, PV power plants require large inverters for direct current to alternating current (DC-AC) power conversion, as well as large transformers to step up voltages to the grid voltage. Offshore wind farms and large PV power plants in remote locations often aggregate power on a DC bus in order to improve efficiency and reduce the cost of power conversion hardware within the energy complex. However, the power must still be converted to AC …

Optimized Sizing And Placing Of Distributed Energy Resources (Ders) In An Island Microgrid Using Der-Cam, Bhuwan B. Bastola

Electrical and Computer Engineering ETDs

The electric grid at La Gomera, an island in the Canary archipelago, has been the subject of interest in optimized integration of Distributed Energy Resources (DERs) primarily because of high distribution losses and concerns about complying with emission regulations. Consequently, the utility that operates the island power system wishes to mitigate the problem with installation of renewable and distributed energy sources like PV and battery, which is the focus of this research.

Specifically, the focus of this thesis is to use Distributed Energy Resource - Customer Adoption Model (DER-CAM) to optimize the installation of PV and battery in terms of …