Open Access. Powered by Scholars. Published by Universities.®
Electrical and Computer Engineering Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Keyword
-
- Thin films (2)
- Annealing (1)
- Chemical (1)
- Conductive films (1)
- Copper compounds (1)
-
- Crystal orientation (1)
- Crystalline materials (1)
- Crystallization (1)
- Deposition (1)
- Diffusion in solids (1)
- Electric conductivity of solids (1)
- Electron-stimulated desorption (1)
- Energy gap (1)
- Etching (1)
- Evaporation (1)
- Film preparation (1)
- Gallium arsenide semiconductors (1)
- Grain boundaries (1)
- Molecular beam epitaxy (1)
- Morphology (1)
- Raman scattering (1)
- Semiconducting aluminum compounds (1)
- Semiconducting films (1)
- Semiconductors (1)
- Surface roughness (1)
- Synthesis (1)
- Textures (1)
- Vacuum applications (1)
Articles 1 - 3 of 3
Full-Text Articles in Electrical and Computer Engineering
Gallium Desorption Behavior At Algaas/Gaas Heterointerfaces During High-Temperature Molecular Beam Epitaxy, K. Mahalingam, D. L. Dorsey, K. R. Evans, Rama Venkat
Gallium Desorption Behavior At Algaas/Gaas Heterointerfaces During High-Temperature Molecular Beam Epitaxy, K. Mahalingam, D. L. Dorsey, K. R. Evans, Rama Venkat
Electrical & Computer Engineering Faculty Research
A Monte Carlo simulation study is performed to investigate the Ga desorption behavior during AlGaAs-on-GaAs heterointerface formation by molecular beam epitaxy. The transients in the Ga desorption rate upon opening the Al shutter are shown to be associated with the concurrent reduction in the V/III flux ratio. Monte Carlo simulations employing a constant V/III flux ratio yield a “steplike” variation in the Ga desorption rate with the resulting interfaces closer in abruptness to the ideal AlGaAs-on-GaAs interface. Further details on the stoichiometry of the interface and its relationship with predicted Ga desorption profiles is presented.
Optical And Electrical Properties Of Cualse² Thin Films Obtained By Selenization Of Cu/Al/Cu... Al/Cu Layers Sequentially Deposited, J. C. Bernède, S. Marsillac, C. El Moctar, A. Conan
Optical And Electrical Properties Of Cualse² Thin Films Obtained By Selenization Of Cu/Al/Cu... Al/Cu Layers Sequentially Deposited, J. C. Bernède, S. Marsillac, C. El Moctar, A. Conan
Electrical & Computer Engineering Faculty Publications
Optical and electrical properties of CuAlSe2 thin films obtained by selenization of Cu/Al/Cu...Al/Cu layers sequentially deposited have been investigated. It is shown that the expected energy gap (2.67 eV) is measured for well crystallized films, whereas a slightly higher value is measured for films not so well crystallized. Raman diffusion also shows differences between well and poorly crystallized films with peaks corresponding to the reference powder for the former samples. A p-type conductivity is found whatever the crystalline quality of the samples. The conductivity of the films depends also strongly on their crystalline properties. When the films are badly …
Cualse² Thin Films Obtained By Chalcogenization, S. Marsillac, K. Benchouk, C. El Moctar, J. C. Bernède, J. Pouzet, A Khellil, M. Jamali
Cualse² Thin Films Obtained By Chalcogenization, S. Marsillac, K. Benchouk, C. El Moctar, J. C. Bernède, J. Pouzet, A Khellil, M. Jamali
Electrical & Computer Engineering Faculty Publications
CuAlSe2 thin films have been synthesized by chalcogenization of thin Cu and Al layers sequentially deposited by evaporation under vacuum. It is shown that CuAlSe2 films are obtained with some Cu2-δSe and Se phases present at the surface. These surface phases are suppressed by annealing under vacuum and by chemical etching in a KCN solution. At the end of the process, the XRD spectrum demonstrates that textured CuAlSe2 films have been obtained with preferential orientation of the crystallites along the (112) direction. The gap of the films is 2.7 eV as expected. The …