Computational Engineering Commons^™

Capturing Microstructural Heterogeneity And Predicting Local Transport Phenomena In Pemfc Catalyst Layers: A Comprehensive Network Modeling Approach, Shahriar Alam

Dissertations, Master's Theses and Master's Reports

A unique network architecture that captures the microstructural heterogeneity and predicts the local transport properties of PEMFC catalyst layers is proposed. Separate networks containing numerous cylindrical elements and nodes are generated that represent the solid and pore phase of the catalyst layer. Transport resistances are assigned to the elements while the nodes are volumeless. The networks are interlinked through nodes where local properties are stored. The generated computational grid's macroscopic behaviors (percolation behavior, gas diffusivity, and ion conductivity) will be matched against the experimental data for validation. Diffusion-like transport equations are applied to the networks that provide local water balance, …

Fluid-Structure Interaction Of Nrel 5-Mw Wind Turbine, Mohamed Sayed Elkady Abd-Elhay

Theses and Dissertations

Wind energy is considered one of the major sources of renewable energy. Nowadays, wind turbine blades could exceed 100 m to maximize the generated power and minimize produced energy cost. Due to the enormous size of the wind turbines, the blades are subjected to failure by aerodynamics loads or instability issues. Also, the gravitational and centrifugal loads affect the wind turbine design because of the huge mass of the blades. Accordingly, wind turbine simulation became efficient in blade design to reduce the cost of its manufacturing. The fluid-structure interaction (FSI) is considered an effective way to study the turbine's behavior …

Renewable Energy Production By Solar Chimney: The Influence Of Curved Guide Vanes On The Performance Of A Solar Chimney Using Cfd Simulation, Haokun Xue

Theses, Dissertations and Capstones

The aim of this study is to investigate the effect of the guide vanes on the efficiency of the turbine of solar chimney power plant using Computational Fluid Dynamics (CFD). In this study, a 3-Dimentional CFD simulation of solar chimney power plant based on the Manzanares prototype is performed. The CFD simulation is validated by comparing the experimental data from the Manzanares prototype and simulation data with both 2D and 3D cases. To capture turbulent flow inside the chimney, the SST 𝑘 − 𝜔 turbulence model is used. The first object is to investigate the flow performance under the influence …

A Reduced Model For Microbial Electrolysis Cells, Dina Aboelela, Moustafa A. Soliman, Ibrahim Ashour

Chemical Engineering

Microbial electrolysis cells (MECs) are breakthrough technology of cheap hydrogen production with high efficiency. In this paper differential-algebraic equation (DAE) model of a MEC with an algebraic constraint on current was studied, simulated and validated by implementing the model on continuous-flow MECs. Then sensitivity analysis for the system was effectuated. Parameters which have the predominating influence on the current density and hydrogen production rate were defined. This sensitivity analysis was utilized in modeling and validation of the batch-cycle of MEC. After that parameters which have less influence on MEC were eliminated and simplified reduced model was obtained and validated. Finally, …

A Reduced Model For Microbial Fuel Cell, Dina Aboelela, Moustafa A. Soliman, Ibrahim Ashour

Chemical Engineering

Microbial fuel cells (MFCs) are a group of microbial electrochemical cells (bioreactors) that are used to generate energy from organic waste found in wastewater. MFCs represent a promising method of waste disposal and production of electricity. Scaling up the use of MFCs requires extensive analysis and detailed grasp of the required processes. The current work aimed to study a model of an MFC, and find the optimum parameters needed for maximum energy production. The process was simulated and validated on continuous-flow MFCs with a Columbic efficiency of 162% and 35% COD removal. Sensitivity analysis of the model was performed. The …

Coarse-Grained Dynamically Accurate Simulations Of Ionic Liquids At Vacuum-Interface, Tyler D. Stoffel

Theses and Dissertations--Mechanical Engineering

Ionic liquids, possessing improved properties in many areas of technical application, are excellent candidates as components in development of next-generation technology, including ultra-high energy batteries. If they are thus applied, however, extensive interfacial analysis of any selected ionic configuration will likely be required. Molecular dynamics (MD) provides an advantageous route by which this may be accomplished, but can fall short in observing some phenomena only present at larger time/length scales than it can simulate. Often times this is approached by coarse-graining (CG), with which scope of simulation can be significantly increased. However, coarse-grained MD systems are generally known to produce …

Toward A Fast And Accurate Modeling Strategy For Thermal Management In Air-Cooled Data Centers, Long Tran Bao Phan

FIU Electronic Theses and Dissertations

Computational fluid dynamics (CFD) has become a popular tool compared to experimental measurement for thermal management in data centers. However, it is very time-consuming and resource-intensive when used to model large-scale data centers, and may not be ready for real-time thermal monitoring. In this thesis, the two main goals are first to develop rapid flow simulation to reduce the computing time while maintaining good accuracy, and second, to develop a whole building energy simulation (BES) strategy for data center modeling. To achieve this end, hybrid modeling and model training methodologies are investigated for rapid flow simulation, and a multi-zone model …

Call For Abstracts - Resrb 2019, July 8-9, Wrocław, Poland, Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Evaluation And Enhancement Of Clean Energy Systems: Analytical, Computational And Experimental Study Of Solar And Nuclear Cycles, Nima Fathi

Mechanical Engineering ETDs

Clean (and specifically renewable) energy is steadily improving its global share. However, finite availability of fossil fuels and the growing effects of climate change make it an urgent priority to convince the industry and governments to incentivize investment in the renewable energy field and to make it more attractive by decreasing the capital cost. Until recently, uncertainties in funding limited renewable energy development, especially in the US. That limitation has been one of the barriers to progress. Another limitation of many renewable energy systems is the variability in their output, which makes them unsuitable for baseline power production. Therefore, fossil …

C.V. - Wojciech Budzianowski, Wojciech M. Budzianowski

Wojciech Budzianowski

-

Renewable Energy And Sustainable Development (Resd) Group, Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Modified Numerical-Analytical Analysis On Scpps, Nima Fathi, Seyed Sobhan Aleyasin, Peter Vorobieff

Nima Fathi

Procesy Cieplne I Aparaty (Lab), Wojciech M. Budzianowski

Wojciech Budzianowski

-

Inżynieria Chemiczna Lab., Wojciech M. Budzianowski

Wojciech Budzianowski

-

Solar Photovoltaic System Control Topology Investigation For Power Source Mismatch, Lynette O'Callaghan

Conference papers

An investigation into solar photovoltaic (PV) system control topology selection, when partial shade is anticipated in the solar array, is presented. As available area is maximised in Building Integrated PV (BIPV) systems, shading is an inevitable consequence. The presence of partial shading in a PV array leads to multiple power peaks in the power-voltage curve, due to bypass diode sections being triggered, and an increase in module mismatch losses in the array. A building energy design software, Integrated Environmental Solutions, is used to determine the shadowed area on PV modules throughout the year, incorporating the PV system location and geometrical …

Project Oasis: Optimizing Aquaponic Systems To Improve Sustainability, Siddharth Nigam, Paige Balcom

Honors Theses and Capstones

Started in Fall 2015, Project OASIS (Optimizing Aquaponic Systems to Improve Sustainability) is an interdisciplinary capstone project with the goal of designing a sustainable and affordable small-scale aquaponic system for use in developing nations to tackle the problems of malnutrition and food insecurity. Aquaponics is a symbiotic relationship between fish and vegetables growing together in a recirculating system. The project’s goals were to minimize energy consumption and construction costs while using universally available materials. The computational fluid dynamics (CFD) software OpenFOAM was used to create transient and steady-state models of fish tanks to visualize velocity profiles, streamlines, and particle movement. …

Numerical-Analytical Assessment On Solar Chimney Power Plant, Nima Fathi, Seyed Sobhan Aleyasin, Peter Vorobieff

Nima Fathi

Inżynieria Chemiczna Ćw., Wojciech M. Budzianowski

Wojciech Budzianowski

-

Tematyka Prac Doktorskich, Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Zespół Energii Odnawialnej I Zrównoważonego Rozwoju (Eozr), Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Wind And Thermal Effects On Ground Mounted Photovoltaic (Pv) Panels, Chowdhury Mohammad Jubayer

Electronic Thesis and Dissertation Repository

A combination of Computational Fluid Dynamics (CFD) simulations and wind tunnel experiments are carried out to investigate the effects of wind on the aerodynamic loading and heat transfer of a ground mounted stand-alone photovoltaic (PV) panel with tilt angle of 25^o in open country atmospheric boundary layer. Several azimuthal wind directions are considered: Southern 0^o, Southwest 45^o, Northwest 135^o and Northern 180^o. Three dimensional Reynolds-Averaged Navier-Stokes (RANS) approaches with an unsteady solver using Shear Stress Transport (SST) k-ω turbulence closure are employed for the CFD simulations, whereas Particle Image Velocimetry (PIV) and …

V&V Exercise For A Solar Tower Power Plant, Nima Fathi, Seyed Sobhan Aleyasin, Peter Vorobieff

Nima Fathi

Termodynamika Procesowa I Techniczna Lab., Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Tematyka Prac Dyplomowych Dla Studentów Wydziału Mechaniczno-Energetycznego Pwr., Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Tematyka Prac Dyplomowych Dla Studentów Wydziału Chemicznego Pwr., Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Mechanika Płynów Lab., Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Experimental Investigation Of Mist Film Cooling And Feasibility Study Of Mist Transport In Gas Turbines, Reda M. Ragab

University of New Orleans Theses and Dissertations

In the modern advanced gas turbines, the turbine inlet temperature may exceed 1500°C as a requirement to increase power output and thermal efficiency. Therefore, it is imperative that the blades and vanes are cooled so they can withstand these extreme temperatures. Film cooling is a cooling technique widely used in high-performance gas turbines. However, the film cooling effectiveness has almost reached plateau, resulting in a bottleneck for continuous improvement of gas turbines' efficiency.

In this study, an innovative cooling scheme, mist film cooling is investigated through experiments. A small amount of tiny water droplets with an average diameter about 10-15 …

Mechaniczny Rozdział Faz Proj., Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.

Challenges And Prospects Of Processes Utilising Carbonic Anhydrase For Co2 Separation, Patrycja Szeligiewicz, Wojciech M. Budzianowski

Wojciech Budzianowski

This article provides an analysis of processes for separation CO2 by using carbonic anhydrase enzyme with particular emphasis on reactive-membrane solutions. Three available processes are characterised. Main challenges and prospects are given. It is found that in view of numerous challenges practical applications of these processes will be difficult in near future. Further research is therefore needed for improving existing processes through finding methods for eliminating their main drawbacks such as short lifetime of carbonic anhydrase or low resistance of reactive membrane systems to impurities contained in flue gases from power plants.

Determination Of Kinetic Parameters From The Thermogravimetric Data Set Of Biomass Samples, Karol Postawa, Wojciech M. Budzianowski

Wojciech Budzianowski

This article describes methods of the determination of kinetic parameters from the thermogravimetric data set of biomass samples. It presents the methodology of the research, description of the needed equipment, and the method of analysis of thermogravimetric data. It describes both methodology of obtaining quantitative data such as kinetic parameters as well as of obtaining qualitative data like the composition of biomass. The study is focused mainly on plant biomass because it is easy in harvesting and preparation. Methodology is shown on the sample containing corn stover which is subsequently pyrolysed. The investigated sample show the kinetic of first order …