Structural Engineering Commons^™

Condition Factor Calibration For Load And Resistance Factor Rating Of Steel Girder Bridges, Pranav M. Shakya

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

The Load and Resistance Factor Rating (LRFR) is a reliability-based rating procedure complementary to the Load and Resistance Factor Design (LRFD). The intent of LRFR is to provide consistent reliability for all bridges regardless of in-situ condition. The primary difference between design and rating is the uncertain severity and location of deterioration, including the potential future loss of strength for an element already evidencing deterioration. Ostensibly, these uncertainties are accounted for by applying an additional strength reduction factor: the condition factor, ϕ_c. Currently, condition factors are nominally correlated to the condition of the member, which can be Good, …

Chloride Contamination Remediation On Steel Bridges, Bobby W. Meade, Christopher Goff, Sudhir Palle, Theodore Hopwood Ii

Kentucky Transportation Center Research Report

Researchers evaluated 32 steel surface preparation methods to determine how effectively they remove chloride from corroded chloride-contaminated steel panels. Wet methods proved more effective than dry methods. The three most effective wet methods injected mineral slag abrasives in a water stream and resulted in less than 1% chlorides remaining. Most dry surface preparation methods left significantly more chloride contamination after surface preparation. The three most effective dry methods used multiple blast cleaning cycles. These methods approached the effectiveness of the best wet methods, with 1.6 to 2.0% chlorides remaining. The least effective surface preparation was a single abrasive blast cleaning …

Evaluation Of The Use Of Painted And Unpainted Weathering Steel On Bridges, Theodore Hopwood Ii, Sudhir Palle, Bobby W. Meade, Rick Younce

Kentucky Transportation Center Research Report

KTC researchers studied the use of unpainted weathering steel on bridges, using findings of inspections performed on Kentucky Transportation Cabinet (KYTC) bridges constructed with both painted and unpainted weathering steel as well as laboratory testing. Laboratory tests were conducted on test panels of conventional and weathering grades of steel to determine the performance of barrier and zinc-based coatings over abrasive-blasted substrates of those steel types in both the new and corroded conditions. The report provides the following recommendations for the use of painted and unpainted weathering steel on Kentucky bridges based upon both the field and laboratory findings:

• KYTC should …

State-Of-The-Art Review Of Cathodic Protection For Reinforced Concrete Structures, Aimee Byrne, Niall Holmes, Brian Norton

Articles

Cathodic protection (CP) limits the corrosion of a metal surface by making it the cathode of an electrochemical cell. This can be achieved either by using a more active sacrificial anode to create a driving current, or by using inert anodes and impressing a current onto the cathode surface using an external direct current (DC) source. Impressed current cathodic protection (ICCP) is preferred where widespread protection is required, particularly in reinforced concrete structures. ICCP needs a constant DC power supply that is usually provided through a grid connection or independent generators. This paper presents the currently available CP systems for …