Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Keyword
-
- CO2 sequestering (1)
- Carbonation (1)
- Civil engineering (1)
- Cultural heritage (1)
- Descriptive statistics (1)
-
- Electrical properties (1)
- Energy efficiency policy (1)
- Experimental modal analysis (1)
- Glazing (1)
- Heat loss (1)
- Indian Construction Industry (1)
- Insulation (1)
- Museum contents (1)
- Occupant (1)
- Plain concrete (1)
- Questionnaire (1)
- Retrofit (1)
- SPD (1)
- Seawater (1)
- Seismic isolation (1)
- Statue (1)
- Structural engineering (1)
- Suspended particle device glazing (1)
- Sustainable materials (1)
- System identification (1)
- Thermal comfort (1)
Articles 1 - 6 of 6
Full-Text Articles in Structural Engineering
Comparison Of Lean Construction In India And United States Of America, Vedangi Mahashabde
Comparison Of Lean Construction In India And United States Of America, Vedangi Mahashabde
Masters Theses & Specialist Projects
The concept of Lean Construction has been introduced successfully into the Construction Industry to increase efficiency and profit by elimination of non-value adding activities or ‘Waste’. Lean Construction is an adaptation of Lean manufacturing principles and is the future of the Construction Industry in developing as well as developed countries. There has been much study and documentation conducted on ‘Lean Construction’ in USA. Even though people have started practicing Lean in India, there is lack of documented information available about it. Professionals within the Industry could already be minimizing ‘Waste’ and/or following Lean principles without the knowledge of the term …
Experimental Modal Analysis And Seismic Mitigation Of Statue-Pedestal Systems, Christine E. Wittich, Tara C. Hutchinson
Experimental Modal Analysis And Seismic Mitigation Of Statue-Pedestal Systems, Christine E. Wittich, Tara C. Hutchinson
Department of Civil and Environmental Engineering: Faculty Publications
The seismic protection of cultural heritage, particularly statues, is a critical issue due to its high cultural significance, difficulty to repair or replace artifacts, and observed poor behavior during past earthquakes. Recent research has explored analysis techniques and methodologies for predicting the seismic response of statues; however, these studies typically assume the statue to be either freestanding or rigidly attached. The seismic response of statues with these different boundary conditions varies widely and therefore accurate characterization is critical. While modern mounting techniques aim to rigidly attach a statue to the floor or to a pedestal, the degree of rigidity of …
Daylighting And Thermo-Electrical Performance Of An Autonomous Suspended Particle Device Evacuated Glazing, Aritra Ghosh
Daylighting And Thermo-Electrical Performance Of An Autonomous Suspended Particle Device Evacuated Glazing, Aritra Ghosh
Doctoral
Suspended particle device (SPD) glazing is an AC powered switchable glazing. PV powered SPD evacuated (vacuum) glazing was proposed with the potential of reducing the heating demand, cooling demand and artificial lighting demand of a building. To achieve an autonomous SPD vacuum glazing, semi empirical simulation and outdoor characterisation was explored in this thesis. Transmission of SPD glazing (area 0.058 m2) varied from 5% when opaque to 55% when transparent in the presence of 110 V, 0.07 W AC supply was characterised in outdoor test cell in Dublin. The SPD glazing has variable spectral transmission in the presence of variable …
Preliminary Investigation Into The Rate Of Carbonation Of Concrete Blocks Under Normal Production Yard Conditions, Aimee Byrne, Eanna Nolan
Preliminary Investigation Into The Rate Of Carbonation Of Concrete Blocks Under Normal Production Yard Conditions, Aimee Byrne, Eanna Nolan
Conference papers
The release of CO2 from calcination during the manufacture of cement can be partially or fully offset by the CO2 it naturally absorbs during its lifetime. This paper reports results from a preliminary investigation into the rate of carbonation in concrete blocks stacked in a production yard over a period of 6 months. The blocks were stacked in a normal manner under natural exposure conditions. Carbonation progress was determined by splitting the blocks and spraying the freshly exposed surface with a phenolphthalein solution at intervals over the test period. It was found that the rate of the carbonation front progression …
Case Studies Of Cavity And External Wall Insulation Retrofitted Under The Irish Home Energy Saving Scheme: Technical Analysis And Occupant Perspectives, Aimee Byrne, Gerard Byrne, Garrett O'Donnell, Anthony Robinson
Case Studies Of Cavity And External Wall Insulation Retrofitted Under The Irish Home Energy Saving Scheme: Technical Analysis And Occupant Perspectives, Aimee Byrne, Gerard Byrne, Garrett O'Donnell, Anthony Robinson
Articles
The residential sector represents 27% of primary energy consumption in Ireland. This paper examines the case study of the Irish government’s national grant scheme to encourage energy efficiency retrofit in private housing. That is the Home Energy Saving (HES) Scheme, later rebranded the Better Energy: Homes (BEH) Scheme. The methodology involved monitoring several homes immediately before and after retrofit alongside discussions with occupants. The examination focused on specific measures commonly introduced through the HES/BEH programme − cavity and external wall insulation. It has been found that a significant decrease in heat loss through the walls was measured in all cases. …
State-Of-The-Art Review Of Cathodic Protection For Reinforced Concrete Structures, Aimee Byrne, Niall Holmes, Brian Norton
State-Of-The-Art Review Of Cathodic Protection For Reinforced Concrete Structures, Aimee Byrne, Niall Holmes, Brian Norton
Articles
Cathodic protection (CP) limits the corrosion of a metal surface by making it the cathode of an electrochemical cell. This can be achieved either by using a more active sacrificial anode to create a driving current, or by using inert anodes and impressing a current onto the cathode surface using an external direct current (DC) source. Impressed current cathodic protection (ICCP) is preferred where widespread protection is required, particularly in reinforced concrete structures. ICCP needs a constant DC power supply that is usually provided through a grid connection or independent generators. This paper presents the currently available CP systems for …