Other Civil and Environmental Engineering Commons^™

Modeled Affinity Constants For Phosphorus Adsorption And Desorption Due To Saltwater Intrusion, Yasemin Taşcı

USF Tampa Graduate Theses and Dissertations

It is important to understand the processes that regulate phosphorus (P) fluxes to coastal environments, because P is an important nutrient in coastal ecosystems. Phosphorus adsorbs to the surface of minerals in sediment and bedrock, and an influx of seawater can cause some of that P to desorb, raising the P concentration of ambient water. Although seawater-induced P desorption is thought to be an important source of P to coastal environments, the chemical reactions that underlie it have not been established. Previous work provides some relevant surface reactions and associated affinity constants between various aqueous P species and the surface …

Expediting The Consolidation Of Clayey Soils Utilizing Microwaves, Thilini Jayatissa

USF Tampa Graduate Theses and Dissertations

Post-construction settlement has been an issue in the field of construction due to the excessive time taken for the dissipation of pore water pressure. This is significant for construction carried out on clayey soils primarily due to the low permeability of clayey soils. Therefore, attention has been directed at finding means of increasing the rate of pre-consolidation. Recent research has focused on the effects of temperature on consolidation. It has been shown that elevated temperature increases the hydraulic conductivity of pore water due to both the reduction of viscosity and differential volumetric expansion of soil and water. This results in …

Improved 2d And 3d Resistivity Surveys Using Buried Electrodes And Optimized Arrays: The Multi-Electrode Resistivity Implant Technique (Merit), Henok Gidey Kiflu

USF Tampa Graduate Theses and Dissertations

This thesis presents a novel resistivity method called Multi-Electrode resistivity technique (MERIT) that is used for high resolution imaging of complex geologic features at depth and near the edges of survey lines. The MERIT electrodes are especially shaped and designed to be self-driven using a robust-direct push technique. Measurements are taken using optimized arrays that are generated using a modified version of the “Compare-R” optimization algorithm. This work focused on both two-dimensional (MERIT2D) and three-dimensional (MERIT3D) applications of the buried array and show the relevance of the additional information gained by the addition of deep electrodes especially in sites with …

Laboratory Evaluation Of Organic Soil Mixing, Spencer Dean Baker

USF Tampa Graduate Theses and Dissertations

Organic soils present a difficult challenge for roadway designers and construction due to the high compressibility of the soil structure, the often associated high water table, and the high moisture content. For other soft or loose soils (inorganic soils), stabilization via cement or similar binders (a method called soil mixing) has proven to be an effective solution. To this end, the Federal Highway Administration has published a comprehensive design manual for these techniques. Organic soils, however, are not addressed therein to a level of confidence for design, as organic soils do not follow the trends of inorganic soils. This has …

Interpolating Beach Profile Data Using Linear And Non-Linear Functions, Lance Calloway Croft

USF Tampa Graduate Theses and Dissertations

ABSTRACT

Beach and nearshore surveys are conducted in a variety of ways, the most commonly used being the level-and-transit method; because it is inexpensive, time conducive and highly accurate. Specifically, beach surveys are conducted to better understand cross-shore, long-shore sediment transport processes, as well as to quantify volume changes, which are used to evaluate beach performance. In this study, a section of the beach on Sand Key, FL was surveyed using rod-and-transit. In addition to the commonly used linear data analysis, a non-linear analysis was conducted using NURBS (Non-Uniform Rational B-Splines).

Survey data was collected within a short time window …

Optimized Correlation Of Geophysical And Geotechnical Methods In Sinkhole Investigations: Emphasizing On Spatial Variations In West-Central Florida, Henok Gidey Kiflu

USF Tampa Graduate Theses and Dissertations

Abstract

Sinkholes and sinkhole-related features in West-Central Florida (WCF) are commonly identified using geotechnical investigations such as standard penetration test (SPT) borings and geophysical methods such as ground penetrating radar (GPR) and electrical resistivity tomography (ERT). Geophysical investigation results can be used to locate drilling and field testing sites while geotechnical investigation can be used to ground truth geophysical results. Both methods can yield complementary information. Geotechnical investigations give important information about the type of soil, groundwater level and presence of low-density soils or voids at the test location, while geophysical investigations like GPR surveys have better spatial coverage and …