Open Access. Powered by Scholars. Published by Universities.®

Hydraulic Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Hydraulic Engineering

Recycling Wastewater For Hydraulic Fracturing By Use Of Nanofiltration Membranes, Haley D. Cleous Dec 2014

Recycling Wastewater For Hydraulic Fracturing By Use Of Nanofiltration Membranes, Haley D. Cleous

Chemical Engineering Undergraduate Honors Theses

Hydraulic fracturing creates large volumes of produced water, contaminated with organics, suspended solids, and dissolved minerals. This water must either be disposed of in injection wells or treated for reuse. One option is to use a combination of ultrafiltration and nanofiltration to treat this water and reuse it in future hydraulic fracturing wells. The object of this study was to test and characterize commercial nanofiltration membranes. The work done for this project will lead to future work in modifying membranes to improve the rejection of desired components.


Development Of A Hydrologic Model For An Urban Headwater Stream: The Influence Of Pervious Surface Properties On Runoff Dynamics, Dawn A. Farver Dec 2014

Development Of A Hydrologic Model For An Urban Headwater Stream: The Influence Of Pervious Surface Properties On Runoff Dynamics, Dawn A. Farver

Graduate Theses and Dissertations

A hydrologic model was developed for the Mullins Creek (MC) catchment located on the University of Arkansas campus in Fayetteville, Arkansas. The MC catchment is a small, dynamic urban stream system with a range of land use/land cover (LULC), an extensive and well-developed stormwater drainage network, and extensive urbanization (over 90% developed, and almost 50% impervious surface area (ISA)). Selected datasets provided information on the stormwater drainage network, the physical attributes of the catchment and receiving waterway (i.e. drainage area, slope, etc.), infiltration potential of soil map units, LULC, and percent ISA. These datasets were analyzed to provide input parameters …


Dynamic Testing Of An Elevated Water Tank, Alexander Michael Font Aug 2014

Dynamic Testing Of An Elevated Water Tank, Alexander Michael Font

Graduate Theses and Dissertations

The objective of this thesis was to identify the modal properties of a pedesphere type, elevated water tank under different operating conditions relating to the water level in the tank. The research that was conducted included both numerical and experimental components. The numerical components consisted of a simple hand calculation to identify the fundamental frequency as well as numerical computer models to identify the natural frequencies and mode shapes for the first three bending modes. The experimental components consisted of characterizing the vibration of the elevated water tank in its current environment through ambient vibration testing.


Examination Of Nitrogen To Phosphorus Ratio In Nutrient Removal From Wastewater Through Chlorella Vulgaris, Courtney L. Hill May 2014

Examination Of Nitrogen To Phosphorus Ratio In Nutrient Removal From Wastewater Through Chlorella Vulgaris, Courtney L. Hill

Civil Engineering Undergraduate Honors Theses

A need for phosphorus removal is becoming increasingly evident as some wastewater treatment plants struggle to meet wastewater effluent nutrient requirements. High nutrient levels in wastewater effluents have also caused ongoing tension between the state of Oklahoma and Arkansas regarding the pollution of the Illinois River. This research seeks to establish the relationship between nitrogen to phosphorus ratio in wastewater and the level of nutrient reduction using Chlorella vulgaris. Seed cultures of Chlorella vulgaris were added into solutions with various ratios of nitrate to phosphate representative of treated domestic wastewater and the removal of nitrogen and phosphorus were measured in …