Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Geotechnical Engineering
Quantifying The Seismic Vulnerability Of Bridges In Low To Moderate Seismicity Regions, John Edward Lens
Quantifying The Seismic Vulnerability Of Bridges In Low To Moderate Seismicity Regions, John Edward Lens
Graduate College Dissertations and Theses
The U.S. Congressional Research Service issued a report for Congress in May 2016, entitled” Earthquake Risk and U.S. Highway Infrastructure: Frequently Asked Questions” which highlighted the absence of a national database on the status of seismic vulnerability of bridges or other infrastructure, and thus no estimate of costs to retrofit vulnerable bridges. Low to moderate seismicity regions exist in each of the continental United States, with over 30 states having mostly or entirely low-to-moderate seismicity. Resources at state transportation agencies and municipalities are focused on higher seismicity regions, creating a gap in quantifying the system-wide seismic vulnerability despite an overall …
Liquefaction-Induced Dragload And/Or Downdrag On Deep Foundations Within The New Madrid Seismic Zone, Ishimwe Elvis
Liquefaction-Induced Dragload And/Or Downdrag On Deep Foundations Within The New Madrid Seismic Zone, Ishimwe Elvis
Graduate Theses and Dissertations
Deep foundation elements are typically used to transfer structural loads for multi-story buildings and large-span bridges to a competent soil layer when 1) the soil close to the ground surface has no sufficient bearing capacity, and when 2) liquefiable soils are encountered. The majority of the bridges constructed within seismic zones rely upon the stability of earthen embankments and deep foundation that are installed above or within liquefiable soil deposits. Despite large factor of safety values or different load and resistance factors being used to adequately design deep foundations within seismic areas, soil liquefaction may cause extensive damage to the …
Multi-Component Active Source Rayleigh Wave Analysis, Gabriel Gribler
Multi-Component Active Source Rayleigh Wave Analysis, Gabriel Gribler
Boise State University Theses and Dissertations
Determining how a building site will respond to earthquake ground shaking plays a critical role in proper construction practices. One critical constraint on how a site responds is the near surface shear wave seismic velocity distribution. One commonly used method for indirectly estimating shear wave velocities is Multichannel Analysis of Surface Waves (MASW), which utilizes a spread of vertical geophones to measure Rayleigh wave dispersion. With this approach, phase velocity vs. frequency dispersion curve picks can be used to estimate shear wave velocities with depth. I investigate the use of two (vertical and horizontal inline) component seismic signals to record …