Construction Engineering and Management Commons^™

Effect Of Waste Covid-19 Masks On Compaction Characteristics Of Silty-Clay Soil, Sydney K. Lawson

Honors College Theses

The present study aims to explore the effect of adding shredded waste Covid-19 masks to silty-clay soil on the soil’s compaction characteristics for beneficial use in embankment, the subgrade of roadways, or backfill. This was accomplished by using two different types of masks: blue surgical masks and KN95 masks. Both mask types were hand shredded into half-inch sections using safety-scissors. The maximum dry density (MDD) and optimum moisture content (OMC) are the two most important compaction characteristics, and they were determined by the Standard Proctor Compaction Test (ASTM D698 / AASHTO T99). The change of both the MDD and OMC …

Nondestructive Evaluation Of Structural Defects In Concrete Slabs, Ehsanul Kabir

Electronic Theses and Dissertations

Nondestructive testing (NDT) is a reliable method for determining the structural integrity of new and old construction and understanding the condition of structural defects. It is widely acknowledged that the interpretation of nondestructive evaluation (NDE) has a significant impact on the reliability and consistency of this technology. However, NDT data acquisition remains subjective and heavily dependent on the operator’s knowledge and expertise. As a result, there are still issues to be resolved regarding the imaging and diagnostic procedures for NDT-based concrete inspection. NDT methods such as ground penetrating radar (GPR), and impact-echo (IE), have been extensively used to inspect concrete …

New Longitudinal Error Balancing Approaches For Closed Traverses, Jose L. Manzano

Electronic Theses and Dissertations

This study presents two novel approaches to balance the horizontal longitudinal error of closure, E_C, in closed polygonal traverses. The standard procedure to balance E_C is the Compass Rule. This technique reduces E_C to zero by applying corrections in the lengths of all traverse sides. Those corrections are proportional to the corresponding side lengths. That is, this approach is not an error-correcting approach, but an error-balancing procedure.

The proposed new techniques are based on sensitivity analysis of E_C with respect to small variations, Δ_i, in the lengths of all sides i = 1, …

Designing And Testing 3-D Printed Wafer-Box With Embedded Pzt Sensors To Identify The Shape Effect On Energy Harvesting, Ahmad Jami Safayet

Electronic Theses and Dissertations

Piezoelectric energy has been recently paid attention in the field of alternative energy. Day by day the traditional energy sources including Coal tar and oils are becoming scarce. People are heading to an alternative energy source to meet the future energy demand. Piezoelectric energy is one of the competitive energy sources compared to the conventional renewable energy sources including solar, wind, and geothermal power and so on. This energy production method bears enormous research potential because it can be used as the roadway for a new method of power generation. This research project aimed to identify which shaped wafer-box produced …

Building Information Modeling (Bim) Impact On Construction Performance, David D. John

Electronic Theses and Dissertations

This study is designed to address the need for having a measure for Construction Performance on BIM-assisted construction projects. Through this study a new Construction Key Performance Indicator (CKPI) matrix is identified and created by the author. The CKPI could be used to assess BIM-assisted projects. Utilizing a sequential mixed methodology approach, academic and practitioner perspectives are assessed. A qualitative content analysis and quantitative descriptive analysis based on demographics are conducted to establish a better understanding of BIM and Construction Performance. The academic perspective is used to assess the relevance of BIMM and CKPI indicators, and the practitioner perspective is …

Audio-Based Productivity Forecasting Of Construction Cyclic Activities, Chris A. Sabillon

Electronic Theses and Dissertations

Due to its high cost, project managers must be able to monitor the performance of construction heavy equipment promptly. This cannot be achieved through traditional management techniques, which are based on direct observation or on estimations from historical data. Some manufacturers have started to integrate their proprietary technologies, but construction contractors are unlikely to have a fleet of entirely new and single manufacturer equipment for this to represent a solution. Third party automated approaches include the use of active sensors such as accelerometers and gyroscopes, passive technologies such as computer vision and image processing, and audio signal processing. Hitherto, most …

A Case Study Of Student Veteran Efficacy In The College Of Engineering And Information Technology At Georgia Southern University, Kevin G. Finley

Electronic Theses and Dissertations

This thesis addresses the issues student veterans face in their transition from military to academic life while pursuing an undergraduate degree in the STEM fields (Science, Technology, Engineering, Math) at Georgia Southern University’s College of Engineering and Information Technology (CEIT). Historically this transition has been a difficult one. Through the implementation of a mentorship program comprised of military veterans on the staff and faculty of Georgia Southern University as well as assistance and participation from members of the case study researcher team and primary researcher this program assisted incoming military student veterans as they assimilated into the collegiate atmosphere. The …

State Of Accelerated Bridge Construction (Abc) In The United States, Mike Ofili

Honors College Theses

The purpose of this project is to develop a toolkit for the design and construction of bridges using prefabricated materials primarily to reduce the closure time and on-site construction time of newly constructed bridges or bridges undergoing renovation. The research focuses specifically on short span bridges in Georgia (40,60,80, and 120ft spans).

Areas of primary concern for this project were design, constructability, structural analysis, the use of concrete and steel girders, cost efficiency, and industry surveys. In this particular portion of the study, the surveys proved to be most effective when combined with information obtained existing research as well as …

Improving Energy Efficiency And Environmental Sustainability Of Commercial Insulation, Celine F. Manoosingh, James Mihelcic, Manjriker Gunaratne

Department of Civil Engineering & Construction Faculty Research & Publications

With increasingly stringent energy standards set in place by the Department of Energy, energy efficiency is becoming a paramount concern to manufacturers of appliances. Additionally, the production and disposal of the voluminous amount of polyurethane foam commonly utilized as insulation in refrigeration units poses a significant environmental challenge. In this context, this study investigated an alternative insulation for use in commercial refrigerator/freezer units. A prototype exploring the use of evacuated packets of pyrogenic silica substituting for conventional insulation was assessed. Assessment criteria included experimental comparison of heat transfer characteristics and the energy efficiency of the new insulation as well as …

Color Removal From Pulp Mill Effluent Using Coal Ash Produced From Georgia Power Coal Combustion Plants, Christopher B. Willett

Electronic Theses and Dissertations

Two environmental concerns currently face Georgia: coal fly ash (CFA) waste from coal power plants, and the effluent generated by pulp mills. Pulp mill effluent discolors surface waters into which it is discharged, and has been proven to negatively impact the dissolved oxygen and carbon necessary for aquatic life. The proposed solution is a cost-effective adsorption treatment using an inexpensive but abundantly available waste material: CFA. CFA possesses beneficial properties that allow it to effectively remove contaminants, and is available at significantly reduced cost. The primary research objective was to define treatment parameters that would result in the maximum removal …

Library Holdings (2013) Ce Report, Georgia Southern University, Zach S. Henderson

University Libraries Accreditation Documents

This document is a part of the 2013 Library Holdings Report for the Zach S. Henderson Library at Georgia Southern University. The report includes data for the library resources and services supporting the research of the Allen E. Paulson College of Engineering and Computing, Department of Civil Engineering and Construction.