Open Access. Powered by Scholars. Published by Universities.®

Civil Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 6 of 6

Full-Text Articles in Civil Engineering

Visible-Light-Active Disinfection Of Surface Water Coliform Using Silver/Titanium Dioxide/Silver Bromide(Ag/Tio2/Agbr) As Photocatalyst, Ashraya Upadhyaya Aug 2020

Visible-Light-Active Disinfection Of Surface Water Coliform Using Silver/Titanium Dioxide/Silver Bromide(Ag/Tio2/Agbr) As Photocatalyst, Ashraya Upadhyaya

University of New Orleans Theses and Dissertations

As human population becomes diverse, the need for sustainable, inexpensive, scalable, and decentralized water treatment technologies to supplement or replace conventional treatment methods are important, especially to satisfy the need of small, rural communities for safe drinking water. These challenges can be somewhat met with the use of semiconductor photocatalysis, especially if the process is driven by visible light energy. Visible-light-active (VLA) photocatalysis can be effectively applied in disinfection of drinking water. In comparison to traditional, energy-intensive, physical and chemical disinfection methods, VLA photocatalysis is capable of providing high disinfection efficiency with the use of cheaper energy, no harmful by-products, …


Total Fume Emissions And Emission Factors Applicable To Gas Metal Arc Welding, Nayara De Souza May 2019

Total Fume Emissions And Emission Factors Applicable To Gas Metal Arc Welding, Nayara De Souza

University of New Orleans Theses and Dissertations

Welding is a common industrial practice that has the potential to emit air pollutants. Emission factors are useful indicators to help in the understanding of the extent of pollution from a process and managing them to reduce or minimize health impacts. The objective of this thesis is to determine emission factors applicable to the gas metal arc welding (GMAW), under varying current and voltage conditions. The most used base metals and an electrode for the shipbuilding industry were considered. A weld fume chamber was used to achieve the project goals along with standard sampling and analytical procedures. Three test runs …


Electrochemical Disinfection Of Municipal Wastewater Using Alternating Current, Xavier A. Chavez Reyes Dec 2014

Electrochemical Disinfection Of Municipal Wastewater Using Alternating Current, Xavier A. Chavez Reyes

University of New Orleans Theses and Dissertations

This research focused on chlorine-free disinfection of wastewater by complying with today's regulations. The equipment used was a continuous flow electrochemical reactor connected to an alternating current (AC) power supply. The electrodes used were made out of titanium coated with iridium oxide. To determine the inactivation of Escherichia Coli, a bacterial count method based on the USEPA method 1603 was used.

After several experiments it was determined that electrochemical disinfection using AC was not efficient and economic enough to be classified as a viable alternative to chlorine disinfection. It was demonstrated that chlorine can be produced by electrolysis using AC …


Hydrodynamics And Salinity Of Pontchartrain Estuary During Hurricanes, Sina Amini May 2014

Hydrodynamics And Salinity Of Pontchartrain Estuary During Hurricanes, Sina Amini

University of New Orleans Theses and Dissertations

A hurricane is a combination of sustained winds, low atmospheric pressures and precipitation. Over the past decades, Louisiana has experienced several devastating hurricanes.

The east bank of the City of New Orleans is bounded by Lake Pontchartrain to the North and the Mississippi River to the South. Lake Pontchartrain is a brackish system connected to the Gulf of Mexico through Lake Borgne to the East. As a Hurricane enters the Estuary from the Gulf of Mexico, it imposes a sustained surge of a few meters which may lead to flooding in areas which are not protected by levees. These flood …


One-Dimensional Dynamic Modeling Of The Lower Mississippi River, Tshering T. Gurung May 2014

One-Dimensional Dynamic Modeling Of The Lower Mississippi River, Tshering T. Gurung

University of New Orleans Theses and Dissertations

The Mississippi River (MR) has been engineered with the development of the levee system, dams for flood control measures, jetties, revetments and dredging of the navigation channel. These alterations have reduced the replenishment of the sediment to the Louisiana Coastal area. To aid in the restoration planning, 1-D numerical models have been calibrated and validated to predict the river response to various changes such as channel modifications, varied flow conditions and hurricane situations. This study utilized the HEC-RAS 4.1 and the CHARIMA (Dr. Forrest Holly, University of Iowa). The models were calibrated for hydrodynamics and sediment using Tarbert Landing discharges …


3-D Hydrodynamic And Non-Cohesive Sediment Transport Modeling In The Lower Mississippi River, Grecia A. Teran Gonzalez May 2014

3-D Hydrodynamic And Non-Cohesive Sediment Transport Modeling In The Lower Mississippi River, Grecia A. Teran Gonzalez

University of New Orleans Theses and Dissertations

The purpose of this research is to develop a 3-D numerical model on the Lower Mississippi River to simulate hydrodynamics and non-cohesive sediment transport. The study reach extends from Bonnet Carré Spillway (RM 127) to Head of Passes (RM 0). Delft3D with sigma coordinates was selected as the river modeling tool. This model River domain is characterized by a complex distributary system that connects the Mississippi River to the Gulf of Mexico. The boundary conditions were: water levels in the Gulf and Head of Passes; and discharges upstream. For the calibration, there are observed data for both types of boundary …