Catalysis and Reaction Engineering Commons^™

Fabrication And Modification Of Titania Nanotube Arrays For Harvesting Solar Energy And Drug Delivery Applications, Ahmed El Ruby Abdel Rahman Mohamed

Electronic Thesis and Dissertation Repository

The fast diminishing of fossil fuels in the near future, as well as the global warming caused by increasing greenhouse gases have motivated the urgent quest to develop advanced materials as cost-effective photoanodes for solar light harvesting and many other photocatalytic applications. Recently, titania nanotube arrays (TNTAs) fabricated by anodization process has attracted great interest due to their excellent properties such as: high surface area, vertically oriented, highly organized, one-dimensional, nanotubular structure, photoactivity, chemical stability and biocompatibility. This unique combination of excellent properties makes TNTAs an excellent photoanode for solar light harvesting. However, the relatively wide band gap energy of …

Evaluation Of Voc Degradation In Photo-Catalytic Air Reactors: Tio2 Immobilization, Energy Efficiency And Kinetic Modeling, Cristina S. Lugo Vega

Electronic Thesis and Dissertation Repository

The high VOC emissions from anthropogenic sources are detrimental to both the environment and humans, contributing with ground-level ozone and particle matter formation. Heterogeneous photocatalysis provides significant potential for VOC degradation. However, the approaches to be used for photocatalyst immobilization in scaled and highly efficient photoreactors are still not well established. Furthermore, there is a lack of reported photonic efficiencies and a shortage of required methods to establish these efficiencies.

To address these issues, this PhD Dissertation reports the study of photonic efficiencies, TiO₂ immobilization on a stainless steel mesh and kinetic models in a scaled-up Photo-CREC-Air Reactor. Acetone …

Catalytic Conversion Of Fructose, Glucose And Industrial Grade Sugar Syrups To 5-Hydroxymethylfurfural, A Platform For Fuels And Chemicals, Sadra Souzanchi

Electronic Thesis and Dissertation Repository

5-hydroxymethylfurfural (HMF) as a versatile and polyfunctional compound derived from dehydration of biomass has attracted increasing attentions in research over the past decades. HMF is an important intermediate and platform chemical, which can be converted into different useful chemicals as well as the promising biofuels. It can be obtained from acid-catalyzed dehydration of different C₆-based carbohydrates such as glucose, fructose, sucrose and cellulose.

In this thesis, a cost-effective process for catalytic conversion of simple sugars (particularly glucose and fructose) and industrial grade sugar syrups to HMF was studied in a novel biphasic continuous-flow tubular reactor using inexpensive heterogeneous …

Scale-Up Methodology For Bench-Scale Slurry Photocatalytic Reactors Using Combined Irradiation And Kinetic Modelling, Patricio J. Valades Pelayo

Electronic Thesis and Dissertation Repository

The present study focuses on developing a predictive methodology to scale-up a slurry annular photoreactor using a TiO₂ Degussa P25 from the bench-scale to a pilot-plant scale. The bench-scale photoreactor is a Photo-CREC-Water II, a 2.65 L internally-irradiated slurry annular photocatalytic reactor. The pilot-plant scale photoreactor is a Photo-CREC Water Solar Simulator, a 9.8 L pilot-plant photoreactor, externally irradiated by eight lamps.

The adopted methodology allows the independent validation of radiative and kinetic models avoiding cross-correlation issues. The proposed approach involves two Monte Carlo methods, to model the Radiative Transfer Equation (RTE) inside each photoreactor. With this end, a …

Optimisation Of The Transesterification Stage Of Biodiesel Production Using Statistical Methods, Arnold Paintsil

Electronic Thesis and Dissertation Repository

The present research examines solely the transesterification stage of the biodiesel production process. Six process variables that affect the yield of biodiesel at this stage are examined using the 12 run Plackett-Burman Design. To study the effect of FFA[1] and to replicate real life situations where oil (feedstock) contain varying amounts of FFA, linoleic acid is used as FFA and intentionally added to high oleic acid canola oil containing less than 0.07% FFA. The process is catalyzed with potassium carbonate and evaluated at varying temperatures, stirring rates, reaction times and methanol oil ratios. The yields at the end of …

Upgrading Pyrolysis Oil To Produce Liquid Transportation Fuels, Ehsan Reyhanitash

Electronic Thesis and Dissertation Repository

The effects of stabilizing fast pyrolysis oil via catalytic alcohol pretreatment on upgrading via hydrodeoxygenation or thermal treatment was studied by comparing the properties of upgraded-stabilized oils with those of upgraded-non-stabilized oils (benchmarks). The major expected effect was reduction in molar mass of upgraded oils, as stabilization was expected to reduce the reactivity of fast pyrolysis oil, thereby reducing polymerization. It was observed that molar mass reduction was induced by dilution effect of the alcohol rather than reactivity reduction due to stabilization. Also, the effects of different alcohols on stabilization and subsequent upgrading were examined at minimized dilution effect conditions. …

Treatment Of Aqueous Biomass And Waste Via Supercritical Water Gasification For The Production Of Ch4 And H2, Izad Behnia

Electronic Thesis and Dissertation Repository

The present study targets to convert aqueous fraction of fast pyrolysis oil into methane and hydrogen gases via supercritical water gasification (SCWG). Water above its critical point is referred to as supercritical water, which has unique properties such as a loss of hydrogen bonding, becoming an excellent solvent for organic compounds. In this thesis, SCWG was used to gasify slurry materials into high calorific gases including CH₄ and H₂. Production selectivity towards more methane or hydrogen was affectively controlled by operational conditions. However, in the absence of catalyst (bank test), gas formation was very minimal. SCWG of …

Water Treatment Using Advanced Oxidation Processes: Application Perspectives, Charles R. Gilmour

Electronic Thesis and Dissertation Repository

Advanced oxidation processes (AOPs) using hydroxyl radicals and other oxidative radical species are being studied extensively for removal of organic compounds from various waste streams. However, large scale applications of these highly effective technologies in water and wastewater treatment are still very limited due to cost and inadequate information about the resultant water quality. This study focuses on the evaluation of the upstream processing and downstream post treatment analysis of selective AOPs. In the first stage of research, the performance of a proprietary catalyst (VN-TiO₂) was compared with the industry standard P25 TiO₂, for the use …

Disinfection Of Low Uv Transmittance Fluids: Fundamentals And Applications, Housyn Mahmoud

Electronic Thesis and Dissertation Repository

Modern consumer demands for tasty, safe and healthier liquid foods and beverages. Chemical preservatives are usually added to foods to extend their shelf life and to protect against food borne pathogens. Application of ultraviolet (UV) light is gaining more attention as an alternative technology to disinfect fluids with low UV transmittance replacing classical chemical or thermal procedures due to growing negative public reaction over chemicals added. UV light irradiation has a positive consumer image as it is a physical non-thermal method efficient against microbial hazards, chemicals free cost effective and energy efficient methods and has been approved by regulatory agencies. …

Solar And Visible Light Driven Photocatalysis For Sacrificial Hydrogen Generation And Water Detoxification With Chemically Modified Ti02, Pankaj Chowdhury

Electronic Thesis and Dissertation Repository

Photocatalysis is a recognized approach where light energy is employed to excite the semiconductor material producing electron/hole pair which eventually involves in the detoxification of pollutants and/or water splitting producing hydrogen. Existing photocatalysts suffer from poor activity or no activity in visible light irradiation which restricts them from solar light utilization. This work is focused on two key applications of photocatalysis (i) sacrificial hydrogen generation, and (ii) phenol degradation in visible and/or solar light. Platinum was loaded on TiO₂ photocatalyst by solar photo-deposition method. Eosin Y dye was used as a sensitizer for sensitization of platinum loaded TiO_{2 …}