Chemical Engineering Commons^™

New Approaches To Scaled-Up Carbon Nanotube Synthesis And Nanotube-Based Metal Composites And Sensors, Amit Goyal

Dissertations

The first phase of the work presented in this dissertation is the development of a scaleable process for the cost-effective synthesis of single walled carbon nanotubes (SWNTs) by thermally-induced catalytic chemical vapor deposition (CVD). With the goal of understanding the growth mechanism and optimize the synthesis process, the effect of CVD and catalyst parameters on nanotube formation was investigated in detail. It was found that nucleation and growth of SWNTs occurred within a few seconds of the introduction of the carbon source, carbon monoxide, at temperatures above 675°C over a Co-Mo/MgO catalyst/support system, resulting in the formation of high quality …

In Vitro Studies Of Degradation And Bioactivity Of Aliphatic Polyesther Composites, Georgia Chouzouri

Dissertations

In spite of numerous publications on the potential use of combinations of aliphatic polyester composites containing bioactive fillers for bone regeneration, little information exists on the combined in vitro mechanisms involving simultaneously diffusion for polymer degradation and bioactivity through nucleation and growth of apatite in simulated body fluid (SBF) solution. The objective of this study is to contribute to the understanding of the fundamentals in designing non-porous, solid materials for bone regeneration, from experimental data along with their engineering interpretation.

Bioactivity, in terms of apatite growth, was assessed through several experimental methods such as scanning electron microscopy (SEM), energy dispersive …

Hydrodynamics Investigation Of In-Vitro Dissolution Testing, Ge Bai

Dissertations

Dissolution testing is routinely carried out in the pharmaceutical industry to determine dissolution rate of solid dosage forms. The United States Pharmacopoeia (USP) Dissolution Apparatus II is the device most commonly used for this purpose. Despite its widespread use, dissolution testing remains susceptible to significant error and test failures. Limited information is available on the hydrodynamics of this apparatus, although hydrodynamic effects can play a major role on test performance.

Laser-Doppler Velocimetry (LDV) and Computational Fluid Dynamics (CFD) were used here to experimentally map and computationally predict the velocity distribution inside a standard USP Apparatus II under the typical operating …

Solvent Resistant Microporous/Nanoporous Polymeric Hollow Fiber And Flat Film Membranes And Their Applications, Praveen B. Kosaraju

Dissertations

The separation and purification of organic-solvent-based process streams may be carried out by membrane processes such as nanofiltration/ultrafiltration/microfiltration and membrane solvent extraction. Lack of solvent stability and chemical stability of most commercially available membranes is limiting the utilization of the above mentioned membrane technologies. This dissertation was primarily focused on developing solvent resistant hollow fiber and flat film membranes for separation and purification of organic-solvent-based process streams.

Available porous polymeric supports (Polypropylene (PP), Polyethersulfone (PES) and Nylon) suitable for the required solvent-stable applications were chosen first and then the supports were modified to satisfy the requirements for the applications. Membrane …

Enhancement Of Fluidization And Filtration Using Nanoparticle Agglomerates And Aerogels, Jose A. Quevedo

Dissertations

Previous works have classified the fluidization behavior of nanoparticles as Agglomerate Particulate Fluidization (APF) and Agglomerate Bubbling Fluidization (ABE). These fluidization behaviors are quite different in regard to the fluidized bed expansion, the presence of bubbles and the smoothness of the bed surface, with APF nanopowders showing a much more homogeneous fluidization and a much better dispersion than ABE nanopowders which are generally very difficult to fluidize and show vigorous bubbling. In the present work, the fluidization of APF as well as ABF nanopowders is studied in depth, both conventionally, and in the presence of extemal assistance; several related topics …

Reactive Modification And Crystallization Behavior Of Foamed Poly(Butylene Terephthalate), Byeong Joon Jeong

Dissertations

The objective of this study is to investigate the feasibility of preparing low density foams based on poly(butylene terephthalate) (PBT) through modification of its molecular structure and rheological characteristics by reactive extrusion. The scientific and/or engineering interpretation of the experimental data was based on fundamentals of extrusion, crystallization mechanisms, as well as information on reactivity and tendency toward degradation of PBT.

As a preliminary study, the extrusion foaming behavior of a commercial linear semi-crystalline PBT with a chemical blowing agent (CBA) was investigated. Foam characteristics were functions of extrusion operational variables, such as die set temperature and screw speed. Gas …