Intensification Of Clostridium Pasteurianum Fermentation Producing N-Butanol From Glycerol Using Microfiltration Cell Recycle, Colin W. Couper

Electronic Thesis and Dissertation Repository

This work demonstrates lab scale intensification of the fermentation of glycerol to 1-butanol using Clostridum pasteurianum, starting with simulation and comparison of different cell recycle arrangements, development of a cell recycle apparatus with an existing bioreactor, and demonstration of fermentation with the final system. Fermentations performed with the completed system showed that the cell recycle system was not significantly inhibitory to fermentation, and achieved a maximum apparent cell dry weight of 3.14g/L and a maximum butanol productivity of 1.16g/Lh.

Effect Of L-Ascorbic Acid And All-Trans Retinoic Acid On Smooth Muscle Cells Cultured On Pcl Scaffolds, Brandon Chaffay

Electronic Thesis and Dissertation Repository

The aim of vascular tissue engineering (VTE) is to fabricate tissues that are both mechanically and biologically competent similar to the native vessel they are intended to replace. To this end, the incorporation of sufficient extracellular matrix elastin and collagen is important. The objective of this thesis work was to evaluate the effect of two biochemical factors, l-ascorbic acid (AA) and all-trans retinoic acid (atRA), on elastin synthesis when coronary artery smooth muscle cells were cultured on 3D polycaprolactone (PCL) scaffolds. First, porous PCL scaffolds were fabricated using a solvent casting and particulate leaching approach. The effect of different …

Fermentative Processes Requiring Low Solubility Feed Gases: An Investigation Into Gas-Dependent Microorganisms, Eric W. Doerr

Electronic Thesis and Dissertation Repository

Two bioprocesses were separately investigated based on their common interest of using gaseous substrates that have low solubility. The first process involved the development of a mixed culture using two organisms capable of utilizing glycerol and carbon monoxide separately to increase biobutanol production, while the second process involved an investigation of different production media used in aerobic xanthan production of Xanthomonas campestris with pressurization effects. It was determined that Clostridium pasteurianum should be used with an organism like Clostridium carboxidivorans or Eubacterium limosum in order for butyrate uptake at 3 g/L to occur with a minimum 0.1 g/L butyrate production. …

Towards The Development Of A Wearable Tremor Suppression Glove, Yue Zhou

Electronic Thesis and Dissertation Repository

Patients diagnosed with Parkinson’s disease (PD) often associate with tremor. Among other symptoms of PD, tremor is the most aggressive symptom and it is difficult to control with traditional treatments. This thesis presents the assessment of Parkinsonian hand tremor in both the time domain and the frequency domain, the performance of a tremor estimator using different tremor models, and the development of a novel mechatronic transmission system for a wearable tremor suppression device. This transmission system functions as a mechatronic splitter that allows a single power source to support multiple independent applications. Unique features of this transmission system include low …

Digestion Of Municipal Wastewater Biosolids Using An Anaerobic Fluidized Bed Bioreactor (Anfbr), Zhenqi Wang

Electronic Thesis and Dissertation Repository

This research investigated the efficacy of the anaerobic fluidized bed bioreactor (AnFBR) technology in treating municipal wastewater sludges. Primary sludge (PS) and thickened waste activated sludge (TWAS) were studied in two lab-scale AnFBRs using High-density polyethylene (HDPE) as carrier media. PS was investigated at various organic loading rates (OLRs) ranging from 9 to 18 kg chemical oxygen demand (COD)/m³-d corresponding to hydraulic retention times (HRTs) of 2 to 4 days, with maximum COD and volatile suspended solid (VSS) removal efficiency of 70% and 72%, respectively. For TWAS, VSS destruction efficiency varied from 53% at an HRT of 4 …

Surface Functionalization And Bioconjugation Of Nanoparticles For Biomedical Applications, Longyan Chen

Electronic Thesis and Dissertation Repository

Colloidal inorganic nanoparticles (NPs) have been attracting considerable interest in biomedicine, from drug and gene delivery to imaging, sensing and diagnostics. It is essential to modify the surface of nanoparticles to have enhanced biocompatibility and functionality for the in vitro and in vivo applications, especially in delivering locally and recognizing biomolecules. Herein, the goal of this research work is to develop advanced NPs with well-tailored surface functionalities and/or bio-functionality for the applications in cell tracking and analytes detection.

In the first project, quantum dots incorporating with gelatin nanoparticles (QDs-GNPs) have been developed for bioimaging applications. Two different approaches have been …

Effect Of Plant Hormones On The Production Of Biomass And Lipid In Microalgae, Malihe Mehdizadeh Allaf

Electronic Thesis and Dissertation Repository

Limited fossil fuel reserves, increasing demand for energy in all parts of the world are some driving forces to look for new sources of transportation fuels. Among different options available, microalgae are currently attracting wide interests as an alternative and renewable fuel source.

Microalgae are single cell photosynthetic organisms that are known for rapid growth and high energy content and as a part of photosynthesis; they produce oil that can be used as a feedstock for biodiesel production. Some algae strains could contain lipid up to 80% of the dry biomass. The amount of lipid production is in direct relation …

Impact Of Bioparticle Recirculation In A Circulating Fluidized Bed Biofilm Reactor On Simultaneous Organic And Nitrogen Removal, Ming Li

Electronic Thesis and Dissertation Repository

The Circulating Fluidized Bed Biofilm Reactor (CFBBR), a bioparticle technology designed for biological nutrient removal, has been implemented to achieve considerable biodegradation efficiency and low sludge production, compared with activated sludge system and typical biofilm technology. The inherent advantages of bioparticle technology are enhanced substantially by the CFBBR, for example, decoupling of hydraulic retention time (HRT) from solids retention time (SRT), large specific surface area, ideal conditions for biofilm ecosystem.

In this work, bioparticle recirculation, as a novel control method for bioparticle system, was demonstrated in CFBBRs. To verify the impact of bioparticle recirculation on the reactor performance, bio-kinetics and …

Investigating The Therapeutic Potential Of Salivary Proteins For Oral Diseases, Dusa Vukosavljevic

Electronic Thesis and Dissertation Repository

ABSTRACT

Saliva is responsible for the formation of the acquired enamel pellicle (AEP), a protein

integument formed as a result of selective adsorption of salivary proteins to the enamel

surface. The AEP demonstrates an important role for modulating dental erosion as a

result of its physical properties, along with its salivary and exogenous protein

composition (Chapter 2). In addition, individual proteins that comprise the AEP have

important physiological functions. Histatin 5 (H5) has potent antifungal effect against C.

albicans, the yeast responsible for the initiation of oral candidiasis. We designed an in

vitro model and found, for the first time, …

Calcium Phosphate-Based Resorbable Biomaterials For Bone Regeneration, Daniel O. Costa

Electronic Thesis and Dissertation Repository

Bone defects are a prevalent problem in orthopedics and dentistry. Calcium phosphate-based coatings and nanocomposites offer unique solutions towards producing scaffolds with suitable physical, mechanical and biological properties for bone regeneration.

We developed a novel method to synthesize hydroxyapatite (HA) particles with high aspect ratio using sol-gel chemistry and hydrothermal treatment. We obtained tunable pure-phase carbonated-HA in the form of micro/nanorods and nanowires (diameters 25-800 nm). To mimic the structure of bone, HA nanowires were homogenously mixed within poly(ε-caprolactone) (PCL) to produce nanocomposites with improved mechanical properties as determined by uniaxial tensile testing.

Surface chemistry and topography of biomaterials play …

An Image-Based Tool To Examine Joint Congruency At The Elbow, Emily A. Lalone

Electronic Thesis and Dissertation Repository

Post-traumatic osteoarthritis commonly occurs as a result of a traumatic event to the articulation. Although the majority of this type of arthritis is preventable, the sequence and mechanism of the interaction between joint injury and the development of osteoarthritis (OA) is not well understood. It is hypothesized that alterations to the joint alignment can cause excessive and damaging wear to the cartilage surfaces resulting in OA. The lack of understanding of both the cause and progression of OA has contributed to the slow development of interventions which can modify the course of the disease. Currently, there have been no reported …

Metrics For Evaluating Surgical Microscope Usage During Myringotomy, Arefin M. Shamsil

Electronic Thesis and Dissertation Repository

Abstract

Although teaching and learning surgical microscope manoeuvring is a fundamental step in middle ear surgical training, currently there is no objective method to teach or assess this skill. This thesis presents an experimental study designed to implement and test sets of metrics capable of numerically evaluating microscope manoeuvrability and qualitatively assessing surgical expertise of a subject during a middle ear surgery called myringotomy. The experiment involved performing a myringotomy on a fixed cadaveric ear. As participants, experienced ear-nose-throat (ENT) surgeons and ENT surgical residents were invited. While performing the procedure, their microscope manoeuvring motions were captured as translational and …

Modeling Lung Tissue Motions And Deformations: Applications In Tumor Ablative Procedures, Ali Sadeghi Naini

Electronic Thesis and Dissertation Repository

Various types of motion and deformation that the lung undergoes during minimally invasive tumor ablative procedures have been investigated and modeled in this dissertation. The lung frequently undergoes continuous large respiratory deformation, which can greatly affect the pre-planned outcome of the operation, hence deformation compensation becomes necessary. The first type of major deformation involved in a target lung throughout a tumor ablative procedure is the one encountered in procedures where the lung is totally deflated before starting the operation. A consequence of this deflation is that pre-operative images (acquired while the lung was partially inflated) become inaccurate for targeting the …