Automotive Engineering Commons^™

Laser Doppler Velocimetry Research Of The Blowby Gas Characteristics In An Internal Combustion Engine, Mark Kevin Coffill

Masters Theses

The project was designed to measure a reciprocating engine fluid flow (blowby gases past the piston rings) using a laser doppler velocimeter (LDV). Blowby gases were obtained by introducing compressed air into an engine cylinder (piston held at TDC) to simulate engine combustion pressures. Beginning the proposed research included starting an LDV/reciprocating engine laboratory at Western Michigan University and determining the limits of the measurement devices (LDV system in particular).

The limitations which were found in the LDV system only allowed for limited results of in cylinder optical measurements. The results obtained were for cylinder pressures below 0.6 kPa gauge …

Book Review, Allan M. Wheatcraft

RISK: Health, Safety & Environment (1990-2002)

Review of the following: LEONARD EVANS, TRAFFIC SAFETY AND THE DRIVER. (Van Nostrand Reinhold 1991) [404 pp.] About the author, author index, figures, notes, preface, subject index, tables. LC 90-44233, ISBN 0-4421-00163-0. [Cloth $51.95. P.O.B. 668, Florence KY 41022-0668.]

Apparatus For Measuring The Temperature Of A Piston In An Internal Combustion Engine, Carl L. Anderson, Glen L. Barna, Douglas B. Brumm

Michigan Tech Patents

An apparatus for measuring the temperature of a piston in an internal combustion engine. The apparatus includes a thermistor to sense the temperature of the piston and generate an electrical signal representative of that temperature, a transmission unit connected to the thermistor for receiving the electrical signal and for converting the signal to an infrared beam for transmission to a point remote from the piston, and a receiver to receive the beam and convert the beam to an electrical signal corresponding to the electrical signal generated by the thermistor. The first mentioned electrical signal is converted to a rectangular wave …

Shape Sensitivity Analysis And Optimization Of Skeletal Structures And Geometrically Nonlinear Solids, Ching-Hung Chuang

Mechanical & Aerospace Engineering Theses & Dissertations

Formulations and computational schemes for shape design sensitivity analysis and optimization have been developed for both skeletal structures and geometrically nonlinear elastic solids. The continuum approach, which is based on the weak variational form of the governing differential equation and the concept of the material derivative, plays a central role in such a development.

In the first part of this work, the eigenvalue and eigenvector sensitivity equations for skeletal structures are derived with respect to configuration variables of joint and support locations. This derivation is done by the domain method as well as the boundary method. The discrete approach for …

The Safety Risks Of Proposed Fuel Economy Legislation, John D. Graham

RISK: Health, Safety & Environment (1990-2002)

Based on, e.g., a comprehensive assessment of what is known of factors influencing automobile safety, previous industry responses to requirements for fuel economy and prior success of regulators in reducing injuries, Professor Graham concludes that pending fuel economy bills are apt to add 1650 fatalities and 8500 serious accidents to the annual highway toll. He also presents several short-term and long-term strategies for simultaneously saving fuel and lives.