Open Access. Powered by Scholars. Published by Universities.®

Navigation, Guidance, Control and Dynamics Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Navigation, Guidance, Control and Dynamics

Nonlinear Regression Methods For Estimation, Eric B. Nelson Sep 2005

Nonlinear Regression Methods For Estimation, Eric B. Nelson

Theses and Dissertations

Regression techniques are developed for batch estimation and applied to three specific areas, namely, ballistic trajectory launch point estimation, adaptive flight control, and radio-frequency target triangulation. Specifically, linear regression with an intercept is considered in detail. An augmentation formulation is developed. Extensions of theory are applied to nonlinear regression as well. The intercept parameter estimate within the linear regression is used to identify the effects of trim change that are associated with the occurrence of a control surface failure. These estimates are used to adjust the inner loop control gains via a feed-forward command, hence providing an automatic reconfigurable retrim …


The Use Of X-Ray Pulsars For Aiding Gps Satellite Orbit Determination, Dennis W. Woodfork Ii Mar 2005

The Use Of X-Ray Pulsars For Aiding Gps Satellite Orbit Determination, Dennis W. Woodfork Ii

Theses and Dissertations

This research proposes the use of an existing "signal of opportunity" - namely x-ray pulsars - to improve the accuracy and robustness of the GPS satellite and clock estimation algorithm. Improvement in satellite and clock accuracy results in a direct benefit to the user. A simulation has been developed to determine the effects of using x-ray pulsar measurements on the GPS Operational Control Segment. The epoch-specific position, velocity, and clock errors of all GPS satellites in the constellation were estimated using both pseudoranges and time-difference-of-arrival (TDOA) measurements from pulsars. The primary measure of accuracy is a constellation Signal-In-Space Range Error …