Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 18 of 18
Full-Text Articles in Engineering
Mechanical Properties Of Intermetallic Compounds In Electrodeposited Multilayered Thin Film At Small Scale By Nanoindentation
Faculty of Engineering University of Malaya
Mechanical properties of intermetallic compounds (IMCs) which were formed in electrodeposited Cu/Sn and Cu/Ni/Sn multilayered thin film have been investigated. The layers of Cu, Sn and Ni were formed by electrodeposition technique using copper pyrophosphate, tin methanesulfonic and nickel Watts baths, respectively. After synthesis, samples were subjected to high temperature aging at 150 degrees C for 168 h. Two different types of intermetallics Cu3Sn and Cu6Sn5 were formed in Cu/Sn. After adding ultra-thin layer of Ni (70 nm) in between Cu and Sn layers, (Cu, Ni)(6)Sn-5 was formed after aging at similar condition to that of Cu/Sn. Tin whisker growth …
Evaluating The Optical Properties Of Tio2 Nanofluid For A Direct Absorption Solar Collector
Evaluating The Optical Properties Of Tio2 Nanofluid For A Direct Absorption Solar Collector
Faculty of Engineering University of Malaya
Recent studies specify that designated nanofluids may increase the proficiency of direct absorption solar thermal collectors. To determine the efficiency of nanofluids in solar applications, their capability to change light energy to thermal energy must be identified (i.e., the absorption spectrum of the solar material). In view of that, this study compares model predictions to spectroscopic measurements of extinction coefficients over wavelengths that are important for solar energy (200- 1100nm). In the first decade of nanofluid research, most of the focus was on measuring and modeling the fundamental thermophysical properties of nanofluids (i.e., thermal conductivity, density, viscosity, and convection coefficients). …
Monitoring And Controlling Of Air Pollution Using Intelligent Control System, Innovative Research Publications Irp India, Anil.H. Sonune, S.M. Hambarde
Monitoring And Controlling Of Air Pollution Using Intelligent Control System, Innovative Research Publications Irp India, Anil.H. Sonune, S.M. Hambarde
Innovative Research Publications IRP India
This paper focuses on implementation of Environmental air pollution monitoring and controlling system. First, the air pollution monitoring system contains sensors to monitor the interested pollution parameter in environment. Second, wireless communication modules for monitoring system were developed using wireless sensor networks technologies based on ZigBee network. And then a performance of modules was estimated in the real-fields. Finally, integrated wireless sensor board which employs dust, CO2, temperature, humidity sensor and a ZigBee module was developed. The board is embedded device based on Arm processor LPC2148. This paper accelerates the digital convergence age through continual research and development of technologies …
The Tribological And Electrochemical Behavior Of Hvof-Sprayed Cr3c2-Nicr Ceramic Coating On Carbon Steel
Faculty of Engineering University of Malaya
High Velocity Oxygen Fuel (HVOF) is an excellent approach to prepare a good, wear-resistant lamella of Chromium Carbide-Nickel Chrome (Cr3C2-NiCr) on carbon steel for high temperature application. This research investigates the effect of a thin, deposited layer of Cr3C2-NiCr on carbon steel in terms of wear and corrosion properties. The microstructure of the HVOF-sprayed Cr3C2-NiCr coating was characterized at each step by scanning electron microscopy. Wear testing was performed with a pin-on-disk tester. Wear weight loss was examined by applying different loads over a 9048.96 m sliding distance. Experimental results show that the wear resistance of the coated sample reduced …
Changes In Heavy Rainstorm Characteristics With Time And Temperature, Barry A. Palynchuk Phd, Yiping Guo Phd
Changes In Heavy Rainstorm Characteristics With Time And Temperature, Barry A. Palynchuk Phd, Yiping Guo Phd
Barry A. Palynchuk PhD
The effects of climate change upon extreme rainfall is evaluated, based upon the identification of individual storms, and the changes in their statistical parameters and distributions. Those changes will be measured based upon historical time spans, and climatic temperature associated with the events. A brief review and comparison with other research is provided.
Changes In Heavy Rainstorm Characteristics With Time And Temperature - Presentation, Barry A. Palynchuk Phd
Changes In Heavy Rainstorm Characteristics With Time And Temperature - Presentation, Barry A. Palynchuk Phd
Barry A. Palynchuk PhD
The effects of climate change upon extreme rainfall is evaluated, based upon the identification of individual storms, and the changes in their statistical parameters and distributions. Those changes will be measured based upon historical time spans, and climatic temperature associated with the events. A brief review and comparison with other research provided.
Sintering Behaviour Of Natural Porous Hydroxyapatite Derived From Bovine Bone
Sintering Behaviour Of Natural Porous Hydroxyapatite Derived From Bovine Bone
Faculty of Engineering University of Malaya
The aim of this research is to study the properties of natural porous hydroxyapatite developed from bovine bone through a sintering process. Bovine bone samples were prepared and sintered in an air atmosphere at different temperatures ranging from 600 degrees C to 1000 degrees C. The sintered bodies were characterized to determine the phases present, bulk density, Ca/P ratio and Vickers hardness. In addition, the microstructural evolution of the sintered porous bodies was also examined. The results revealed that the thermal stability of the HA matrix was not disrupted and that all of the sintered bodies exhibited phase pure HA. …
Sintering Behaviour Of Natural Porous Hydroxyapatite Derived From Bovine Bone
Sintering Behaviour Of Natural Porous Hydroxyapatite Derived From Bovine Bone
Faculty of Engineering University of Malaya
The aim of this research is to study the properties of natural porous hydroxyapatite developed from bovine bone through a sintering process. Bovine bone samples were prepared and sintered in an air atmosphere at different temperatures ranging from 600 degrees C to 1000 degrees C. The sintered bodies were characterized to determine the phases present, bulk density, Ca/P ratio and Vickers hardness. In addition, the microstructural evolution of the sintered porous bodies was also examined. The results revealed that the thermal stability of the HA matrix was not disrupted and that all of the sintered bodies exhibited phase pure HA. …
Analysis Of Transient Natural Convection Flow Past An Accelerated Infinite Vertical Plate, Innovative Research Publications Irp India, Kaprawi S.
Analysis Of Transient Natural Convection Flow Past An Accelerated Infinite Vertical Plate, Innovative Research Publications Irp India, Kaprawi S.
Innovative Research Publications IRP India
This work describes a vertical hot plate moves with acceleration and with variation wall temperature. The temperatures of the plate decrease with the increase of velocity of the plate. The temperature and velocity are given by the governing equations. The dimensionless equations of the problem have been solved numerically by the finite difference method. The temperature and the velocity profiles against several parameters like Prandtl Number, Grashoft number and time are presented. The results show that the temperature and velocity profiles are significantly influenced by Prandtl and Grashoft number.
Modeling The Polyphenoloxidase Inactivation Kinetics In Pear, Apple And Strawberry Purees After High Pressure Processing
Faculty of Engineering University of Malaya
High Pressure Processing of Royal Gala apple, Taylor's Gold pear and Camarosa strawberry purees was carried out to inactivate polyphenoloxidase (PPO). First, 600 MPa enzyme inactivation at room temperature was investigated. After 60 min, strawberry (8% RA, residual activity) and apple (89% RA) PPOs were partially inactivated and pear PPO was not inactivated, demonstrating the high variability in the resistance of different fruits' PPOs. Then, the fruit purees were submitted to 600 MPa combined with mild heat, and the PPO inactivation kinetics was modeled. The pear PPO was found to be resistant even after 60 min 600 MPa-71 degrees C …
Co-Production Of Hydrogen And Carbon Nanofibers From Methane Decomposition Over Zeolite Y Supported Ni Catalysts
Faculty of Engineering University of Malaya
The objective of this paper is to study the influences of different operating conditions on the hydrogen formation and properties of accumulated carbon from methane decomposition using zeolite Y supported 15% and 30% Ni, respectively, at a temperature range between 500 and 650 degrees C in a pilot scale fixed bed reactor. The temperature ramp was showed a significant impact on the thermo-catalytic decomposition (TCD) of methane. An optimum temperature range of 550-600 degrees C were required to attain the maximum amount of methane conversion and revealed that at 550 and 600 degrees C, catalyst showed longer activity for the …
Self-Regulated Solar Lighting System, Innovative Research Publications Irp India, Mr. Ramesh C R, Prof.Lyla B Das
Self-Regulated Solar Lighting System, Innovative Research Publications Irp India, Mr. Ramesh C R, Prof.Lyla B Das
Innovative Research Publications IRP India
Electricity is a prime concern in today’s world. On observing the path through which we travel daily we can see that a lot of electricity is wasted by glowing sodium wafer lamps and even the traditional tube lights on the electric posts at unnecessary intervals. The self regulating solar system enters into action and exits from functioning depending upon the output from the Day/Night sensing unit. Once the unit indicates arrival of night then the system turns ON, the controlling unit thereafter controls the illumination level of the lamp depending upon the outputs of interruption detector, temperature sensor & real …
Review Of Improvements In Wire Electrode Properties For Longer Working Time And Utilization In Wire Edm Machining
Faculty of Engineering University of Malaya
Wire electrical discharge machining (WEDM) is an important technology, which demands high-speed cutting and high-precision machining to realize productivity and improved accuracy for manufacturing hard materials. WEDM has experienced explosive growth and complexity of equipment as well as rising demand for the basic process tool (the wire electrode). Greater taper angles, thicker workpieces, automatic wire threading, and long periods of unattended operation make the selection of the ideal wire a much more critical basis for achieving successful operation. This paper focuses on the evolution of EDM wire electrode technologies from using copper to the widely employed brass wire electrodes and …
Preparation And Low-Temperature Sintering Of Cu Nanoparticles For High-Power Devices
Preparation And Low-Temperature Sintering Of Cu Nanoparticles For High-Power Devices
A.S. Md Abdul Haseeb
One of the fundamental requirements for high-temperature electronic packaging is reliable silicon attach with low and stable electrical resistance. This paper presents a study conducted on Cu nanoparticles as an alternative lead-free interconnect material for high-temperature applications. Cu nanoparticles were prepared using pulsed wire evaporation technique in water medium. Pure Cu nanoparticles without any organic mixture were used in this paper. An economical approach to extract the nanoparticles from water was established. In situ Cu nanoparticles oxide reduction was successfully done using forming gas $({\rm N}-{2}{\hbox{-}}5\%{\rm H}-{2})$. Cross-section analysis on bonded interface shows onset of Cu nanoparticles sintering at 400$^{\circ}{\rm …
Effects Of Pre-Treatments And Drying Temperatures On The Drying Rate And Qualityof African Catfish (Claris Gariepinus), Michael Ayodele Omodara, Adesoji Matthew Olaniyan
Effects Of Pre-Treatments And Drying Temperatures On The Drying Rate And Qualityof African Catfish (Claris Gariepinus), Michael Ayodele Omodara, Adesoji Matthew Olaniyan
Michael Ayodele Omodara
Effects of pre-treatments and drying temperatures on the drying rate and the quality of African Catfish Clarias gariepinus was examined by drying samples of catfish under four different temperatures (40 0C, 45 0C, 50 0C and 55 0C) and four different pre-treatment methods (Salting, Sugaring, Blanching, and Control) using an experimental dryer. Drying of the fish samples for all the pre-treatments at 40 0C to 55 0C occurred in the falling rate period only showing that the predominant mechanism of mass transfer in drying process of catfish is that of internal mass transfer. The drying rate increases with increase in …
A Packed Bed Membrane Reactor For Production Of Biodiesel Using Activated Carbon Supported Catalyst, Abdul Aziz Abdul Raman
A Packed Bed Membrane Reactor For Production Of Biodiesel Using Activated Carbon Supported Catalyst, Abdul Aziz Abdul Raman
Abdul Aziz Abdul Raman
In this study, a novel continuous reactor has been developed to produce high quality methyl esters (biodiesel) from palm oil. A microporous TiO 2/Al 2O 3 membrane was packed with potassium hydroxide catalyst supported on palm shell activated carbon. The central composite design (CCD) of response surface methodology (RSM) was employed to investigate the effects of reaction temperature, catalyst amount and cross flow circulation velocity on the production of biodiesel in the packed bed membrane reactor. The highest conversion of palm oil to biodiesel in the reactor was obtained at 70°C employing 157.04g catalyst per unit volume of the reactor …
Effect Of Temperature On Tribological Properties Of Palm Biodiesel
Effect Of Temperature On Tribological Properties Of Palm Biodiesel
A.S. Md Abdul Haseeb
Biodiesel, as an alternative fuel is steadily gaining attention to replace petroleum diesel partially or completely. The tribological performance of biodiesel is crucial for its application in automobiles. In the present study, effect of temperature on the tribological performance of palm biodiesel was investigated by using four ball wear machine. Tests were conducted at temperatures 30, 45, 60 and 75 °C, under a normal load of 40 kg for 1 h at speed 1200 rpm. For each temperature, the tribological properties of petroleum diesel (B0) and three biodiesel blends like B10, B20, B50 were investigated and compared. During the wear …
A Technical Note On The Production Of Zirconia And Zircon Brick From Locally Available Zircon In Bangladesh
A.S. Md Abdul Haseeb
In this study, the potentiality of Bangladesh zircon as a raw material for zirconia and zircon brick production was examined. Decomposition of zircon (ZrSiO4) into zirconia (ZrO2) was attempted by using caustic soda (NaOH) as the decomposition agent. 5-10 μm size zircon, 5-30 wt.% NaOH, and decomposition temperatures ranging from 1300 to 1500°C were investigated. X-ray diffraction method using Mo Kα radiation was used in order to find out the extent of decomposition of zircon into zirconia. Zircon bricks of 0.06 mm× 0.06 mm× 0.025 mm shaped were made under a pressure of 15 MPa. Carboxi methyal cellulose (CMC) and …