Engineering Commons^™

Concrete Mix Design Using Abrams And Bolomey Methods, Salem Abdelgader, Marzena Kurpinska, Hakim Abdelgader, Jamal Khatib

BAU Journal - Science and Technology

This research studied concrete design methods. To design concrete using two methods, including the Abrams law and the modified Bolomey method. Concrete with assumed compressive strength 25, 30, 35, 40, and 45 MPa was researched. The research was conducted in the laboratory using two types of samples: cubic 15x15x15cm for compressive strength tests and cylinders ϕ-15cm, h-30cm for the splitting strength tests using the Brazilian method.

The analysis of the cement content in the composition of 1m3 of the mixture showed very large differences depending on the calculation method used. The cement content calculated according to the Abrams method ranged …

Persistence And Mitigation Of Pfas Within Concrete Stormwater Drainage Infrastructure, Jason R. Mcdonald

Theses and Dissertations

The persistence, fate, and transport of per- and poly-fluoroalkyl substances, which have been shown to have adverse effects on human health, have been previously studied in environmental media such as soils and groundwater. This study investigates concrete, a medium that is rarely studied but frequently present in instances where PFAS originating from AFFF releases and spills have occurred. Used heavily throughout aviation firefighting, AFFF poses environmental hazards due to the length of PFAS degradation and toxicological implications, thus its classification as a forever chemical. From the very limited reports to date, studies have suggested very slow release from concrete, potentially …

Effect Of Using Cathode-Ray Tubes (Crt) Waste Glass On Concrete Properties, Jad Bawab, Jamal Khatib, Ali Jahami, Said Kenai, Adel Elkordi

BAU Journal - Science and Technology

Cathode-ray tube (CRT) glass is a hazardous material that should be responsibly managed when disposed. One of the possible options for recycling CRT waste glass is using it as fine aggregates in concrete for its richness in silica. For the aim of evaluating concrete with this material, four mixes with replacement levels of 0%, 10%, 20% and 30% are prepared. Workability, hardened density, ultra-pulse velocity, compressive strength, tensile strength, and static modulus of elasticity were examined. Experimental results showed that the use of CRT improved properties of concrete at certain replacement levels. CRT glass improved the workability of concrete where …

Concrete Mix Design Using Simple Equations, Hakim Abdelgader, Ramadan Suleiman, Abdalla Adam, Jamal Khatib

BAU Journal - Science and Technology

The behaviour of concrete, whether fresh or hardened, depends basically on the behaviour of its components and the relationship between them, therefore, obtaining a concrete with certain properties depends fundamentally on the concrete mix design. Concrete mix design generally includes two main steps: 1-Selection of the main components suitable for the concrete (cement, aggregate, water, and additives); 2-Determination of more economical mix ratios to fulfil the workability, strength and efficiency requirements. Currently, there are many international methods locally approved for mix designs. They are all related to each other, they give relatively the same quantities of the mix components and …

A Review On The Use Of Vegetable Oil And Its Waste In Construction Applications, Ahmed Chamaa, Jamal Khatib, Adel Elkordi

BAU Journal - Science and Technology

The generation of waste materials is causing an impact on the environment due to many reasons including the effect on human health and decrease in landfill space. Of these waste materials is the waste cooking oil. There are large amounts of waste vegetable oil generated in the world and most of it is disposed of in the sewer system which can cause problems when treating wastewater. This paper is a review of literature on the use of vegetable oil (VO) and waste vegetable oil (WVO) as chemical admixtures in construction materials. The construction materials include mainly concrete and pavement. The …

Macro - And Microstructure Evaluation And Field Applications Of Concrete With Recycled Glass Pozzolan, Marija Krstic

Dissertations and Theses

Concrete is the most used material in the world, second only to water. Conventional concrete is produced with Portland cement (PC). The production of cement is an energy intensive operation that has raised significant environmental concerns, since one ton of cement generates an equal ton of CO₂. In the USA about 90 million tons of cement are used annually, with 3 million tons used in New York. Most contemporary concrete applications for buildings and infrastructure use high-performance concrete (HPC) mixtures which are produced by replacing a percentage of cement with supplementary cementitious materials (SCMs), consisting mainly of fly-ash …

Performance Of Concrete Made With A Calcined Clay – Limestone-Portland Cement Exposed To Natural Conditions, Fernando Martirena, Ernesto Díaz, Dayran Rocha, Hamed Maraghechi, Karen Louise Scrivener

International Conference on Durability of Concrete Structures

This work presents the results of an investigation carried out to assess durability of concrete made with a calcined clay- limestone-Portland cement with 47% of clinker, hereafter named LC3, produced during an industrial trial in 2013. LC3 was used to cast concrete blocks and later expose them at a natural location at the northern coast of Cuba. Reference concrete was cast with Cuban Portland cement having 88% of clinker. Throughout three years (2015, 2016, 2017) concrete cores were systematically taken and the specimens were subjected to a testing program that included Formation factor, chloride profiling, surface resistivity, air permeability and …

Impact Of Extreme Summer Temperatures On Bridge Structures, Ryan Hagedorn

Graduate Theses and Dissertations

Climate change and its effect on weather in the United States is a well-documented phenomenon. In particular, extreme heat waves have become more intense, more frequent, and longer lasting, especially in the southern United States. As with much of America’s transportation infrastructure, prestressed concrete bridge girders experience the effects of these heat waves. Uneven heating of optimized bridge girder sections results in large non-linear temperature gradients. In this study, temperature was monitored in three different AASHTO I-girders to determine the vertical and transverse temperature gradients in a pre-deck placement condition. It was determined that the current design standard, which uses …

Alkali-~Activated Fly Ash Binders: Feasibility As A Sustainable Alternative To Ordinary Portland Cement For Pre-~Cast Systems, Kimberly Sierra

UNLV Theses, Dissertations, Professional Papers, and Capstones

Fresh, load-dependent, transport, and durability properties of alkali-activated fly ash mortars were studied. The influences of activator concentration, solution-to-binder ratio, curing condition, activator type, and sodium silicate-to-total solution ratio on the properties of the studied alkali-activated mortars were examined. This study was divided in two phases. The first phase dealt with the use of sodium hydroxide as the sole activator. The second phase of the study was divided into two parts, both of which used a combination of sodium hydroxide and sodium silicate as the activator solution. Part I of phase II used elevated temperature curing conditions, whereas part II …

Advanced Sustainable Concrete Materials For Infrastructure Applications, Kaylea Ann Smith

Masters Theses

"This study was performed to examine the effects of cement replaced by high volumes of Class C fly-ash on durability characteristics of concrete up to 120 days. Specifically, this study investigates possibility of amending American Society for Testing and Materials (ASTM) to allow High Volume Fly-ash (HVFA) concrete to cure until later ages prior to testing instead of 28 days. Five mix designs were compared with varying fly-ash percentages from 0 to 70% (by total cementitious mass). No other additives were present in any of the five mix designs. Water-to-cementitious ratio (w/cm) and total cementitious material remained constant as 0.40 …

An Investigation Of Waste Glass-Based Geopolymers Supplemented With Alumina, Mary U. Christiansen

Dissertations, Master's Theses and Master's Reports - Open

An increased consideration of sustainability throughout society has resulted in a surge of research investigating sustainable alternatives to existing construction materials. A new binder system, called a geopolymer, is being investigated to supplement ordinary portland cement (OPC) concrete, which has come under scrutiny because of the CO2 emissions inherent in its production.

Geopolymers are produced from the alkali activation of a powdered aluminosilicate source by an alkaline solution, which results in a dense three-dimensional matrix of tetrahedrally linked aluminosilicates. Geopolymers have shown great potential as a building construction material, offering similar mechanical and durability properties to OPC. Additionally, geopolymers have …

Electrochemical Detection For The Corrosion Of Reinforcing Steel In Concrete During Immersion And Drying Cycles, Bing-Li Jia, Fa-He Cao, An-Na Chen, Jian-Qing Zhang

Journal of Electrochemistry

The corrosion behavior of reinforcing steel in concrete under dry-wet cycle condition has been studied by electrochemical noise(EN) compared with the electrochemical impedance spectroscopy(EIS),SEM micrographs and EDS.The statistical method has been employed to analyze the EN data of reinforcing steel in concrete,which revealed three different corrosion stages of reinforcing steel in concrete,including the dissolution of the passive film,the active corrosion and the cumulation of corrosion product.The wavelet transform has also been employed,which indicated that steel in concrete with pH 1 is associated with uniform corrosion,while steel in concrete with pH 3 and pH 7 are associated with localized corrosion,such as …

Studied Corrosion Behaviors Of Reinforcing Steel In Concrete By A Single-Dimensional Array Electrode, Lan-Qiang Li, Shi-Gang Dong, Rong-Gui Du, Chang-Jian Lin

Journal of Electrochemistry

A single-dimensional array electrode was developed as a new electrochemical technique to image corrosion potential,galvanic current and polarization curves of reinforcing steel in concrete during corrosion process.Combining with the polarization behavior for each micro-electrode,the interactions between corrosion macrocell and corrosion microcell of the steel in concrete were evaluated.It was noticed that the corrosion macrocell and microcell occurred independently in difference regions at the initial stage of corrosion.The corrosion macrocell current can be in situ followed by corrosion potential imaging.The corrosion propagation of steel in concrete is closely related to the interactions between corrosion macrocell and corrosion microcell.

Effect Of Naphthalene Water Reducer On Corrosion Behavior Of Reinforcing Steel In Concrete, Yu-Ming Tang, Jie Zhang, Yu Zuo

Journal of Electrochemistry

The influence of naphthalene water reducer on corrosion behavior of reinforcing steel in concrete was studied by the methods of corrosion potential measurement,linear polarization and EIS test.The values of concrete resistance(Rc) and polarization resistance(Rp) of the samples with naphthalene water reducer were higher than those without naphthalene water reducer,especially in the concrete with 0.2 percent naphthalene water reducer.A suitable amount of water reducer can improve the pore structures of concrete,increase the concrete compactness and impermeability,and decrease corrosion rate of rebars in concrete.

Effect Of Cracks On Corrosion Of Rebar In Concrete Studied By Wire Beam Electrode, Guo-Xi Li

Journal of Electrochemistry

The effects of crack and ethanolamine on corrosion of rebar in concrete were studied by measuring the distribution of corrosion potential and polarization resistance of iron wires in 10% NaCl solution.The results showed that the diffusion of water,oxygen and chloric ion toward concrete was accelerated by the crack which intensified the nonuniform corrosion of iron wire with the regions near to crack as anode and the uncracked regions as cathode.Ethanolamine could diffuse into the body of concrete and absorb on the surface of iron wire,which reduced iron corrosion evidently and successfully inhibited the nonuniform corrosion caused by crack without changing …

The Lineal Polarization Method For Corrosion Rate Measurement Of Reinforcing Bar Of Concrete In Situ, Ai-Ling Du, Wen-Tao Hou, He-Ming Zhang, Jian-Qun Luo

Journal of Electrochemistry

A linear polarization method was applied to measure corrosion rate of reinforcing bar of concrete in situ. Generally in the experiment, the area and shape of the reinforcing bar as a working electrode can be changed and adjusted according to our needs. But polarization area cannot be defined when reinforcing bar is polarized in situ, so that a real R p can't be obtained. Thus the purpose of present work is to improve the measurement system. We used the double_ring auxiliary electrodes made by ourselves. The size of the double_ring auxiliary electrodes was adjusted repeatedly until the real polarization area …

An Investigation On The Corrosion Potential Imaging At The Interface Of Concrete/Reinforcing Bar In Corrosion Media, Rong-Zong Hu, Chang-Jian Lin, Xiang Zhou, Jian-Guang Tan, Xiong-Chao Zhao

Journal of Electrochemistry

The iron array electrode covered with concrete as a new electrochemical technique is applied to map the potential imaging and to investigate on the iron electrode corrosion process under concrete: In Cl - solution the corrosion of the iron array electrode covered with concrete had been prevented for a short term since the concrete protection, but the corrosion still occurreed and developed after immersed for a long time. In SO 4 2- solution although the sample had being immersed for a long time and the concrete was possibly broken, the corrosion did not develop. In Cl - solution the corrosion …

Synthesis And Application Of Polymeric Corrosion Inhibitor For Reinforced Concrete, Weiwei Lin, Shengxian Wang, Jianqing Zhang

Journal of Electrochemistry

A new polymer E Twas synthesized and used as a corrosion inhibitor for reinforced concrete. The inhibitive behavior and mechanism were studied with linear polarization ,Tafel polarization,EIS and XPS method in simulated pore solution system with concrete samples.The result showed that the polymer was a mixing type inhibitor. A 1% dosage was sufficient to imhibit the corrosion of steel in simulated pore solution system. The salt endurance was enhanced from 0.02 mol/L to 0.10 mol/L.The result also showed the good synergetic effect of NaNO 2,especially in low NaNO 2 concentration.The EIS showed that E_T has dual function on reinforced concrete,i.e.,densifying …

An Evaluation Of In-Stream Structures Designed To Provide Fish Habitat, Charles H. Call Jr.

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

In-stream concrete structures were studied through model tests and river tests. The model studies indicated that four designs provided good habitat in the model stream. These structures were the inverted weir, the "V" structure, the slab with legs and the cylinder. Through the river studies it was determined that these structures did not influence enough of the total river area to be effective in providing good fish habitat. Also an appreciable amount of yearly maintenance would be required to free the structures from silting in, debris, and vandalism. The slab with legs was the only promising structure.