Engineering Commons^™

Dependence Of Microstructure Evolution, Texture, And Mechanical Behavior Of A Mg Alloy On Thermo-Mechanical Input During Friction Stir Processing, Zhenzhen Yu

Doctoral Dissertations

In this thesis, the relationship among friction stir processing (FSP) parameters, microstructure evolution, texture development, and mechanical hehavior of AZ31B Mg alloy was investigated.

First of all, in order to reveal the correlation among the deformation conditions, dynamic recrystallization (DRX) mechanisms, and microstructure evolution in the Mg alloy, hot compression tests at a wide range of Zener-Hollomon parameter (Z) values were conducted. Through optical microscopic examination, it was found out that above a critical Z value, twinning influences the DRX process resulting in a more effective grain refinement, which is manifested in a significant change in the slope of the …

Energetics And Kinetics Of Dislocation Initiation In The Stressed Volume At Small Scales, Tianlei Li

Doctoral Dissertations

Instrumented nanoindentation techniques have been widely used in characterizing mechanical behavior of materials in small length scales. For defect-free single crystals under nanoindentation, the onset of elastic-plastic transition is often shown by a sudden displacement burst in the measured load-displacement curve. It is believed to result from the homogeneous dislocation nucleation because the maximum shear stress at the pop-in load approaches the theoretical strength of the material and because statistical measurements agree with a thermally activated process of homogeneous dislocation nucleation. For single crystals with defects, the pop-in is believed to result from the sudden motion of pre-existing dislocations or …

Laser Textured Calcium Phosphate Bio-Ceramic Coatings On Ti-6al-4v For Improved Wettability And Bone Cell Compatibility, Sameer R. Paital

Doctoral Dissertations

The interaction at the surfaces of load bearing implant biomaterials with tissues and physiological fluids is an area of crucial importance to all kinds of medical technologies. To achieve the best clinical outcome and restore the function of the diseased tissue, several surface engineering strategies have been discussed by scientific community throughout the world. In the current work, we are focusing on one such technique based on laser surface engineering to achieve the appropriate surface morphology and surface chemistry. Here by using a pulsed and continuous wave laser direct melting techniques we synthesize three dimensional textured surfaces of calcium phosphate …

Deformation Study Of Nanocrystalline Ni-Fe Alloy Using Synchrotron Diffraction, Li Li

Doctoral Dissertations

This dissertation addresses two critical issues in the deformation of nc metals and alloys: (1) A stress-induced genuine grain growth after the plastic deformation rather than just a change of the grain shape; (2) A systematically quantitative study of micrsostructural evolution during the plastic deformation.

These two critical issues point to the deformation of nc materials with the average-grain sizes within the range of 10 to 50 nm, which is the most interesting and controversial region in the current time. The current study provides a systematic and detailed microstructural evolution for this region, which is definitely beneficial for the investigation …