Engineering Commons^™

Application Of Wavelet Analysis And Random Field In Integrity Management Of Pipelines Containing Dents And Corrosions, Junxiong Lin

Electronic Thesis and Dissertation Repository

Metal loss corrosions and dents are two major threats to the integrity of oil and natural gas pipelines. In the pipeline industry, the Fitness-For-Service (FFS) assessment is commonly employed for pipelines containing these defects. However, FFS assessment usually assumes that a defect has a simple shape, and such a simplification may significantly affect the accuracy of the assessment. Therefore, retaining the actual shapes of defects and incorporating them into the FFS assessment can improve assessment accuracy. The main objective of the present thesis is to extract key information about the sizes, directions, and shapes of corrosions and dents from the …

Coating Condition Detection And Assessment On The Steel Girder Of A Bridge Through Hyperspectral Imaging, Pengfei Ma, Jiaoli Li, Ying Zhuo, Pu Jiao, Genda Chen

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

The organic coating of bridge steel girders is subjected to physical scratches, corrosion, and aging in natural weathering. The breakdown of the coating may cause serviceability and safety problems if left unnoticed. Conventional coating inspection is time-consuming and lacks information about the coating's chemical integrity. A hyperspectral imaging method is proposed to detect the condition of steel coatings based on coating-responsive features in reflectance spectra. A field test was conducted on the real-world bridge, which shows obvious signs of degradation. The hyperspectral signature enables an assessment of the coating's health and defect severity. The results indicated that the coating scratch …

Revised Load Rating Procedures For Deteriorated Prestressed Concrete Beams, Alex Stripsky, Sergio F. Brena, Jessica Boakye, Scott A. Civjan, Simos Gerasimidis

Structural Engineering and Mechanics Research Reports

The first prestressed concrete bridge in the United States was built in the early 1950s. Since then, several typical sections have been developed for use in bridge construction including I-beams, deck slabs, box beams, double tees, etc. In bridges under aggressive environments, corrosion deterioration of prestressing strands and stirrups has occurred creating challenges associated with determining the strength of deteriorated existing bridge sections. The MassDOT LRFD Bridge Manual includes provisions to estimate strength of corrosion deteriorated prestressed concrete box beams allowing engineers to calculate the load rating of these types of bridges. The provisions are based on the observed condition …

Seismic Performance Of Ductile Corrosion-Free Reinforced Concrete Frames, Mohamed Meshaly, Maged A. Youssef, Ahmed Elansary

Civil and Environmental Engineering Publications

Corrosion of steel bars is the main cause of the deterioration of reinforced concrete (RC) structures. To avoid this problem, steel rebars can be replaced with glass-fiber-reinforced-polymer (GFRP). However, the brittle behaviour of GFRP RC elements has limited their use in many applications. The use of shape memory alloy (SMA) and/or stainless steel (SS) rebars can solve this problem, because of their ductile behaviour and corrosion resistance. However, their high price is a major obstacle. To address issues of ductility, corrosion, and cost, this paper examines the hybrid use of GFRP, SS, and SMA in RC frames. The use of …

A Novel Probabilistic Framework Of Rc Corroded Structures Under Dynamic Loading, Rawan Mouin Mashmoushy Eng., Wael Slika, Adel Elkordi

BAU Journal - Science and Technology

Steel corrosion in reinforced concrete structures can lead to severe deterioration damage under static and seismic loads. In practice, it is essential to mitigate failure risk by quantifying the extent of damage and simulating the structural response of damaged structures. However, numerical modeling of the dynamic behavior of corroded structure is challenging due to high nonlinearity of the problem and its multidisciplinary nature. In addition, corrosion damage exhibits various sources of uncertainty that impede accurate deterministic modeling of the dynamic response of RC structures. Therefore, this study presents a simplified framework, to simulate the non-linear response of corroded structures under …

Bridge Resilience Assessment With Inspire Data, Iris Tien, Yijian Zhang

Project RR-1

This project proposed a methodology to assess the impact of corrosion on the performance of bridges. The combined analytical and numerical modeling of shear-critical and lap-spliced columns is detailed, and outcomes are verified with previous experimental test data. The impact of corrosion on risk is assessed through conducting fragility analyses. Results quantify the increase in failure probabilities of these structures, measured by increasing probabilities of exceeding defined damage states, with increasing levels of corrosion. Corrosion is found to have a larger impact on increasing probabilities of exceeding more severe damage states. Twenty percent mass loss of reinforcement increases the probability …

Strengthening Of Corroded Steel Structures Using Cfrp – An Experimental Review, Ghada El-Mahdy Ph.D., P.Eng, Abdallah H. Yassin, Abdel El Rahman Khaled

Civil Engineering

Fibre reinforced polymers (FRP) have been widely used to strengthen reinforced concrete structures, however, nowadays their use to strengthen steel structures is under investigation. In particular, the need to strengthen corroded steel structures found in aggressive environments, such as marine environments, which have undergone a reduction in cross-sectional area and hence a reduction in their load-carrying capacity is in need of studying. The main problems that arise when using carbon fibre reinforced polymer (CFRP) sheets to strengthen steel structures is the weakness in the interfacial bond between the CFRP and the steel surface, the thinness of CFRP sheet, and the …

Retrofit Of Corroded Corrugated Metal Culverts Using Gfrp Slip-Liner, Rahulreddy Chennareddy

Civil Engineering ETDs

Culverts are water conveyance structures, typically used to allow water flow and maintain a balance between the flow streams without interrupting structures such as highways and bridges. Corrugated metal pipes (CMPs) have been used as culverts in North America since the 1950s because of their low cost and simple construction method. Today, the corrosion of CMPs is a major problem faced by all U.S. Departments of Transportation. There is an urgent need to provide an efficient solution, one that is corrosion-resistant, to retrofit thousands of corroded CMPs across the country. High specific strength, high strength to weight ratio, corrosion resistance, …

Application Of Bayesian Networks To Integrity Management Of Energy Pipelines, Wei Xiang

Electronic Thesis and Dissertation Repository

Metal-loss corrosion and third-party damage (TPD) are the leading threats to the integrity of buried oil and natural gas pipelines. This thesis employs Bayesian networks (BNs) and non-parametric Bayesian networks (NPBNs) to deal with four issues with regard to the reliability-based management program of corrosion and TPD. The first study integrates the quantification of measurement errors of the ILI tools, corrosion growth modeling and reliability analysis in a single dynamic Bayesian network (DBN) model, and employs the parameter learning technique to learn the parameters of the DBN model from the ILI-reported and filed-measured corrosion depths. The second study develops the …

Development Of Local And Global Corrosion Sensing Technique To Monitor Structural Behavior Of Prestressed Concrete Structures, Dewan Z. Hossain

FIU Electronic Theses and Dissertations

Corrosion of steel rebar in reinforced concrete structures is a concern for highway bridge owners. According to 2002 study by the Federal Highway Administration, ~15% of the highway bridges in the US are structurally deficient due to corrosion and have an estimated annual direct cost of $8.3 billion. Generally, in post-tensioned bridges, ducts filled with poor or incomplete grouting can allow the tendons to come into contact with water, leading to corrosion and fracture. Although new and improved procedures of grouting have been developed to reduce the instances of poor grouting, the problem of how to reliably inspect tendons on …

Corrosion Durability Of A Nano-Particle Enriched Zinc-Rich Coating System For Highway Steel Bridges, Saiada Fuadi Fancy

FIU Electronic Theses and Dissertations

Corrosion is a major concern for the long-term durability and structural integrity of steel components of highway bridges when unprotected. The application of protective coatings has been widely used for corrosion mitigation of atmospherically exposed structural steel. At present, the zinc-rich primer (ZRP) based three-coat system is widely used in the United States. The metallic zinc pigment ideally would provide corrosion resistance by sacrificial as well as barrier protection. The life of these coating systems is at best only half of the bridge design life. Furthermore, premature degradation may occur if there are flaws in the system due to improper …

Sustainability-Based Long-Term Management Of Bridges Under Multi-Hazard Exposure, Mohamed Soliman

Publications

Bridges are under deterioration due to various mechanical and environmental stressors. Hydraulic-related hazards (e.g., flood and scour), aggressive environmental conditions, and seismic events (e.g., earthquake) are recognized as the most significant threats to the safety of bridges. In traditional risk assessment methods for structures susceptible to damage due to floods and other natural hazards (e.g., corrosion and seismic events), future hazard predictions are conducted using historic return periods and climate records. However, recent increase in flood intensity in central-southern states indicate that future hazard occurrence rate may not necessarily follow past trends. Accordingly, current design, assessment, and management methodologies should …

Nano-Channels Early Formation Investigation On Stainless Steel 316ti After Immersion In Molten Pb-Bi, Abu Khalid Rivai, Mardiyanto Mardiyanto, Annette Heinzel

Makara Journal of Technology

Development of fuel cladding and structural materials in Pb-Bi environment, especially at high temperature, is a critical issue for the deployment of LFR (Lead alloy-cooled Fast Reactor) and ADS (Accelerator Driven Transmutation System). This is because of the corrosive characteristic of Pb-Bi to metals as constituent materials of fuel cladding and structural of the reactors. Corrosion test of a high-chromium austenitic stainless steel i.e. SS316Ti in molten Pb-Bi at 550 ºC has been carried out for about 300 hours continuously. The characterization using SEM-EDS (Scanning Electron Microscopy - Energy Dispersive X-ray Spectroscopy) showed that an iron oxide as the outer …

Chloride Contamination Remediation On Steel Bridges, Bobby W. Meade, Christopher Goff, Sudhir Palle, Theodore Hopwood Ii

Kentucky Transportation Center Research Report

Researchers evaluated 32 steel surface preparation methods to determine how effectively they remove chloride from corroded chloride-contaminated steel panels. Wet methods proved more effective than dry methods. The three most effective wet methods injected mineral slag abrasives in a water stream and resulted in less than 1% chlorides remaining. Most dry surface preparation methods left significantly more chloride contamination after surface preparation. The three most effective dry methods used multiple blast cleaning cycles. These methods approached the effectiveness of the best wet methods, with 1.6 to 2.0% chlorides remaining. The least effective surface preparation was a single abrasive blast cleaning …

Evaluation Of The Use Of Painted And Unpainted Weathering Steel On Bridges, Theodore Hopwood Ii, Sudhir Palle, Bobby W. Meade, Rick Younce

Kentucky Transportation Center Research Report

KTC researchers studied the use of unpainted weathering steel on bridges, using findings of inspections performed on Kentucky Transportation Cabinet (KYTC) bridges constructed with both painted and unpainted weathering steel as well as laboratory testing. Laboratory tests were conducted on test panels of conventional and weathering grades of steel to determine the performance of barrier and zinc-based coatings over abrasive-blasted substrates of those steel types in both the new and corroded conditions. The report provides the following recommendations for the use of painted and unpainted weathering steel on Kentucky bridges based upon both the field and laboratory findings:

• KYTC should …

Performance Assessment Of Deteriorated And Retrofitted Steel Hp Piles, Steven T. Stauffer

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

Deterioration of aging bridges can be attributed to an assortment of mechanisms throughout the structure, with remediation policies also varying. This study focused on assessing the validity of the Nebraska Department of Roads’ (NDOR) reinforced concrete encasement retrofit for corroded steel HP piles. Experiments were designed and conducted to test the capacity of the NDOR retrofit and evaluate failure limit states. Two pile locations were considered: abutment and pile bent. For each location there was a non-deteriorated, deteriorated, and retrofitted case. These cases represented the pile at key stages during its life. NDOR’s concrete encasement retrofit provided the required stability …

On The Role Of The Pore Water Chemistry Of Deficient Post-Tension Grout To Promote Steel Corrosion, Samanbar Permeh

FIU Electronic Theses and Dissertations

Corrosion failure of post-tension tendons with pre-packaged thixotropic grout was documented in Florida Bridges in less than 10 years of service. Analysis of deficient grout in Florida post-tensioned (PT) bridges where severe corrosion developed indicated enhanced sulfate ion concentration, high pore water pH, enhanced moisture and low chloride content. The corrosion wasn’t consistent with the conventional causes of steel corrosion such as bleed water accumulation in grout void spaces, chloride contamination and pore water carbonation. Corrosion development was associated with deficient grout with enhanced sulfate levels. However, limited information is available on the corrosion behavior of PT strand in grout …

Probability-Based Hurricane Resilience Evaluation And Retrofitting For Residential Community, Yadong Dong

Dissertations, Master's Theses and Master's Reports

Wood residential construction is vulnerable to hurricanes, as evident in recent hurricane events. Many studies indicated that the changing climate may very likely alter hurricane patterns, which could lead to more severe hurricane damage to the wood residential construction that accounts for 90% of the residence in the USA. On the other hand, deterioration of material increases the chance of structural failure by reducing the structural capacity (e.g., corrosion of fasteners in roof panel could significantly reduce the withdrawal capacity of the roofing structure during hurricane events).

Currently, most hurricane damage estimations only focus on direct loss (e.g., structural loss). …