Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 10 of 10

Full-Text Articles in Engineering

Rapid Construction Of Pacific Street Bridge, Kromel E. Hanna, George Morcous, Maher K. Tadros Oct 2010

Rapid Construction Of Pacific Street Bridge, Kromel E. Hanna, George Morcous, Maher K. Tadros

Nebraska Department of Transportation: Research Reports

No abstract provided.


Fatigue Strength Of Steel Bridge Members With Intersecting Welds, David T. Delong, Mark D. Bowman Jul 2010

Fatigue Strength Of Steel Bridge Members With Intersecting Welds, David T. Delong, Mark D. Bowman

JTRP Technical Reports

The brittle fracture of the Hoan Bridge in December 2000 highlighted the fracture susceptibility of details containing intersecting welds in steel bridges. Though it is now known that details with intersecting welds should be avoided, many existing bridges in Indiana contain details with intersecting welds. Little experimental data on the fatigue performance of these details exists.

The purpose of this study was to evaluate the fatigue strength of several details commonly found in steel bridges in Indiana that contain intersecting welds. Large-scale experimental fatigue testing were performed using nine steel beams to study the behavior of three basic types of …


Simulation Of Traffic Loading On Highway Bridges, Bernard Enright Mar 2010

Simulation Of Traffic Loading On Highway Bridges, Bernard Enright

Other resources

This work is based on weigh-in-motion measurements for approximately three million trucks obtained from sites in five European countries. Techniques have been developed, supported by photographic evidence, for filtering the measurements to identify and remove unreliable values, and for the classification of extremely heavy vehicles. The collected measurements have been used as the basis for building and calibrating a Monte Carlo simulation model for bridge loading. Two-lane traffic is simulated – either two lanes in the same direction or one lane in each direction. The model allows for vehicles that are both heavier and have more axles than in the …


Historic Bridge Evaluation Using Finite Element Techniques, Helena M. Charron Jan 2010

Historic Bridge Evaluation Using Finite Element Techniques, Helena M. Charron

Masters Theses 1911 - February 2014

The present study examined the application of modern, computer-based analysis methods to two existing historic bridges in Massachusetts. The first bridge featured in this study is the Woronoco Bridge, a reinforced concrete open spandrel arch bridge that was constructed in 1923. It was hoped that a computer-based, parametric study of this bridge would prove it to be deck-stiffened, similar to select bridges of Swiss engineer Robert Maillart. However, the results do not support that there was any intent to reduce bending in the arch as a result of increasing the stiffness of the bridge deck. Instead, the Woronoco Bridge appears …


A New Congested Traffic Load Model For Highway Bridges, Colin C. Caprani, Colm Carey, Bernard Enright Jan 2010

A New Congested Traffic Load Model For Highway Bridges, Colin C. Caprani, Colm Carey, Bernard Enright

Conference papers

Long span highway bridges are critical components of any nation’s infrastructure. Therefore accurate assessment of highway bridge loading is essential, and it is well known that congested traffic governs load effect for such bridges. Current congestion models use conservative assumptions about traffic and inter-vehicle gaps. This research investigates congested traffic flow through the use of traffic microsimulation which has the ability to reproduce complex traffic phenomena based on driver interactions. A time series model has been developed to produce a speed time-series similar to the results of the microsimulation. The speed time-series from the new model, combined with the established …


Management Strategies For Special Permit Vehicles For Bridge Loading, Bernard Enright, Eugene J. Obrien Jan 2010

Management Strategies For Special Permit Vehicles For Bridge Loading, Bernard Enright, Eugene J. Obrien

Conference papers

An examination of weigh-in-motion data collected recently at sites in five European countries has shown that vehicles with weights well in excess of the normal legal limits are found on a daily basis. These vehicles would be expected to have permits issued by the responsible authorities. It can be seen from the measurements that most of them are travelling at normal speeds. Photographic evidence indicates that, while many are accompanied by an escort vehicle, normal traffic is flowing alongside in other lanes. As European freight volume grows, the frequency of these special vehicles can be expected to increase. Hence, the …


Site Specific Modelling Of Traffic Loading On Highway Bridges, Bernard Enright, Eugene J. Obrien Jan 2010

Site Specific Modelling Of Traffic Loading On Highway Bridges, Bernard Enright, Eugene J. Obrien

Conference papers

Accurate traffic loading models based on measured weigh-in-motion (WIM) data are essential for the accurate assessment of existing bridges. Much work has been published on the Monte Carlo simulation of single lanes of heavy vehicle traffic, and this can easily be extended to model the loading on bridges with two streams of traffic in opposing directions. However, a typical highway bridge will have multiple lanes in the same direction, and various types of correlation are evident in measured traffic, such as groups of very heavy vehicles travelling together and heavy vehicles being overtaken by lighter ones. These traffic patterns affect …


The Influence Of Correlation On The Extreme Traffic Loading Of Bridges, Eugene J. Obrien, Bernard Enright, A. T. Dempsey Jan 2010

The Influence Of Correlation On The Extreme Traffic Loading Of Bridges, Eugene J. Obrien, Bernard Enright, A. T. Dempsey

Conference papers

Accurate traffic loading models based on measured data are essential for the accurate assessment of existing bridges. There are well-established methods for the Monte Carlo simulation of single lanes of traffic, and this can easily be extended to model the loading on bridges with two independent streams of traffic in opposing directions. However, a typical highway bridge will have multiple lanes in the same direction, and various types of correlation are evident in measured traffic. This paper analyses traffic patterns using multi-lane WIM data collected at two European sites. It describes an approach to the Monte Carlo simulation of this …


Characteristic Dynamic Increment For Extreme Traffic Loading Events On Short And Medium Span Highway Bridges, Eugene J. Obrien, Daniel Cantero, Bernard Enright, Arturo González Jan 2010

Characteristic Dynamic Increment For Extreme Traffic Loading Events On Short And Medium Span Highway Bridges, Eugene J. Obrien, Daniel Cantero, Bernard Enright, Arturo González

Articles

More accurate assessment of safety can prevent unnecessary repair or replacement of existing bridges which in turn can result in great cost savings at network level. The allowance for dynamics is a significant component of traffic loading in many bridges and is often unnecessarily conservative. Critical traffic loading scenarios are considered in this paper with a model that allows for vehicle-bridge interaction and takes into account the road surface condition. Characteristic dynamic allowance values are presented for the assessment of mid-span bending moment in a wide range of short to medium span bridges for bi-directional traffic.


Importance Of The Tail In Truck Weight Modeling For Bridge Assessment, Eugene J. Obrien, Bernard Enright, Abraham Getachew Jan 2010

Importance Of The Tail In Truck Weight Modeling For Bridge Assessment, Eugene J. Obrien, Bernard Enright, Abraham Getachew

Articles

To predict characteristic extreme traffic load effects, simulations are sometimes performed of bridge loading events. To generalize the truck weight data, statistical distributions are fitted to histograms of weight measurements. This paper is based on extensive WIM measurements from two European sites and shows the sensitivity of the characteristic traffic load effects to the fitting process. A semi-parametric fitting procedure is proposed: direct use of the measured histogram where there are sufficient data for this to be reliable and parametric fitting to a statistical distribution in the tail region where there are less data. Calculated characteristic load effects are shown …