Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 6 of 6
Full-Text Articles in Public Policy
Ddasaccident759, Hd-Aid
Ddasaccident759, Hd-Aid
Global CWD Repository
On 06 Sep 2010, when Mr. [the Victim] was working in his clearance lane and excavated a detected signal, during the excavation drill his excavation tool touched the mine and caused it to go off. According to investigation report the cause of the accident was the wrong excavation technique, as he started excavation drill close to the pinpointing target. He had gone down and did not expand the trench to allow entry from the side, which caused to stroke his excavation tool on the top of the mine. Due to the injuries sustained on his eyes, it seems that the …
Ddasaccident686, Hd-Aid
Ddasaccident686, Hd-Aid
Global CWD Repository
On 1st of June [Demining group] started clearance operation on mentioned task, they cleared 3350 sqm and found/destroyed 150 anti-personnel and 90 UXO till the accident time. On 23 June 2009 at 08:40 am when [the Victim] was working in his clearance lane a PMN2 antipersonnel mines went off and caused the accident. However the deminer had worn his PPE but he got some injures on his both legs, fortunately the injuries were not severe. According to the investigation report the ground was hard to conduct excavation easily, however the MDU was used for ground preparation, but it was failed …
Ddasaccident598, Hd-Aid
Ddasaccident598, Hd-Aid
Global CWD Repository
It is the conclusion of investigation team that the involved deminer was excavation a signal in an area where the ground surface was hard with dense vegetation, and considering the crater created as a result of the explosion it seems that the deminer was excavating the signal about 30 cm on right side of the working lane where he was not in a stable position for excavating the signal by scraper; the excavation of this lane required to be done in next clearance lane.
Ddasaccident370, Hd-Aid
Ddasaccident370, Hd-Aid
Global CWD Repository
On the day of the accident at approximately 11:45hrs, the Victim was commencing a clearance lane up the side of a hill. He was investigating a reading from his metal detector by prodding, and was in the kneeling position at the time. Whilst prodding he detonated a PMA3 anti-personnel blast mine.
Ddasaccident127, Hd-Aid
Ddasaccident127, Hd-Aid
Global CWD Repository
The investigators determined that the deminer was "excavating" to investigate a detector reading when the accident occurred. He was using a shovel to do so. Investigators were unable to visit the accident site [due to deminer mobility and seasonal redeployment], so the report relied on interviews and written statements.
Ddasaccident114, Hd-Aid
Ddasaccident114, Hd-Aid
Global CWD Repository
The investigators determined that the victim was squatting to prod with a bayonet and applied too much pressure. He used the presence of bamboo to explain why he squatted to prod. The mine was identified as a PMN from "found fragments". His visor was shattered in the accident and his bayonet was "lost".