Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 15 of 15
Full-Text Articles in Physics
Determination Of The Polymerisation Rate Of A Low-Toxicity Diacetone Acrylamide-Based Holographic Photopolymer Using Raman Spectroscopy, Dervil Cody, Emilia Mihaylova, Luke O'Neill, Izabela Naydenova
Determination Of The Polymerisation Rate Of A Low-Toxicity Diacetone Acrylamide-Based Holographic Photopolymer Using Raman Spectroscopy, Dervil Cody, Emilia Mihaylova, Luke O'Neill, Izabela Naydenova
Articles
The polymerisation rate of a low-toxicity Diacetone Acrylamide (DA)-based photopolymer has been measured for the first time using Raman spectroscopy. A value for the polymerisation rate of 0.020 s−1 has been obtained for the DA photopolymer by modelling the polymerisation reaction dynamics as a stretched exponential or Kohlrausch decay function. This is significantly lower than the polymerisation rate of 0.100 s−1 measured for the well known Acrylamide (AA)-based photopolymer composition. The effect of the additive glycerol on the polymerisation rate of the DA-based photopolymer has also been investigated. The inclusion of glycerol is observed to increase the rate …
Holographic Sensors: Three-Dimensional Analyte-Sensitive Nanostructures And Their Applications, Ali K. Yetisen, Izabela Naydenova, Fernando Da Cruz Vasconcellos, Jeffrey Blyth, Christopher R. R. Lowe
Holographic Sensors: Three-Dimensional Analyte-Sensitive Nanostructures And Their Applications, Ali K. Yetisen, Izabela Naydenova, Fernando Da Cruz Vasconcellos, Jeffrey Blyth, Christopher R. R. Lowe
Articles
Holographic sensors are analytical devices that systematically diffract narrow-band light in the ultraviolet to near-infrared range for application in the detection and quantification of analytes and/or physical parameters. They can be functionalized with analyte-responsive materials to construct highly sensitive optical sensors for use in testing, where a visual readout, fast turnaround time, and reversibility are needed. Holography allows fabrication of disposable sensors that are lightweight for miniaturization and multiplexing purposes.3 Holographic sensors offer three capabilities on a single analytical device: (i) label-free analyte-responsive polymer, (ii) real-time, reversible quantification of the external stimuli, and (iii) three-dimensional visual image display.
Humidity And Temperature Effect On Properties Of Transmission Gratings Recorded In Pva/Aa-Based Photopolymer Layers, Tatsiana Mikulchyk, Suzanne Martin, Izabela Naydenova
Humidity And Temperature Effect On Properties Of Transmission Gratings Recorded In Pva/Aa-Based Photopolymer Layers, Tatsiana Mikulchyk, Suzanne Martin, Izabela Naydenova
Articles
This paper explores the effects of humidity on gratings recorded in a polyvinylalcohol–acrylamide photopolymer medium. Investigation of the behaviour of transmission gratings exposed to high humidity is of significant interest for two reasons, firstly because the grating's sensitivity to humidity can be exploited for the development of irreversible humidity indicators, secondly because too much sensitivity to humidity can limit the use of these materials in applications where an environmentally stable hologram is needed. In this paper we focus on the effect of high humidity on the properties of volume phase transmission gratings recorded in PVA/AA photopolymer layers in the temperature …
Holographic Recording In Corona Charged Acrylamide-Based Mfi-Zeolite Photopolymer, Temenujka Yovcheva, Izabela Naydenova, Simeon Sainov, Vincent Toal, Svetlana Mintova
Holographic Recording In Corona Charged Acrylamide-Based Mfi-Zeolite Photopolymer, Temenujka Yovcheva, Izabela Naydenova, Simeon Sainov, Vincent Toal, Svetlana Mintova
Articles
The influence of corona charging on holographic recording in acrylamide-based photopolymer nanocomposite containing MFI zeolite nanoparticles has been studied. The holographic recording was carried out in two different geometries —transmission grating recording and total internal reflection grating recording. During the recording process, the layers were charged in a corona field. It was observed that independently of the corona polarity, in the case of transmission geometry of recording, the corona charging led to a decrease in the diffraction efficiency (DE) of the grating. In the case of the total internal reflection grating, the DE increased in the corona field presence.
In-Plane Sensitive Electronic Speckle Pattern Interferometer Using A Diffractive Holographic Optical Element, Raghavendra Jallapuram, Con Healy, Emilia Mihaylova, Vincent Toal
In-Plane Sensitive Electronic Speckle Pattern Interferometer Using A Diffractive Holographic Optical Element, Raghavendra Jallapuram, Con Healy, Emilia Mihaylova, Vincent Toal
Articles
We describe a student project in electronic speckle pattern interferometry. The project includes holographic recording of diffraction gratings in thick, self-processing photopolymer layers made from off-the-shelf chemicals. The gratings are employed in a simple electronic speckle pattern interferometer to measure in-plane rotation.
Photopolymerizable Nanocomposites For Holographic Recording And Sensor Application, Elsa Leite, Izabela Naydenova, Svetlana Mintova, Louis Leclercq, Vincent Toal
Photopolymerizable Nanocomposites For Holographic Recording And Sensor Application, Elsa Leite, Izabela Naydenova, Svetlana Mintova, Louis Leclercq, Vincent Toal
Articles
Novel nanocomposites consisting of a water soluble acrylamide–based photopolymer and colloidal zeolite nanoparticles of zeolite Beta and zeolite A were prepared. The interactions between the photopolymer components and zeolite nanoparticles in the photopolymerizable nanocomposites were characterized for the first time by 13C NMR and Visible spectroscopy. It was found that the zeolite Beta nanoparticles (up to 5% wt.) behave as a non-inert additive, resulting in an effective increase in layer thickness that causes doubling of the diffraction efficiency of the nanocomposite in comparison to that of the undoped photopolymer. On the other hand, the nanocomposite containing zeolite A nanoparticles showed …
Study Of The Photoinduced Surface Relief Modulation In Photopolymers Caused By Illumination With A Gaussian Beam Of Light, Tzvetanka Babeva, Dana Mackey, Suzanne Martin, Izabela Naydenova, Vincent Toal
Study Of The Photoinduced Surface Relief Modulation In Photopolymers Caused By Illumination With A Gaussian Beam Of Light, Tzvetanka Babeva, Dana Mackey, Suzanne Martin, Izabela Naydenova, Vincent Toal
Articles
The formation of surface relief profile in photopolymerisable systems when illuminated with a focused beam of light is simulated numerically using a two-way diffusion model that takes account both for monomer and short polymer chains diffusion. The concentration and spatial distribution dynamics of monomer and short and long polymer chains are calculated. The surface profile is obtained from calculated components concentrations considering different densities of monomer and polymer. The influence of the illumination time, intensity and spot diameter on the surface profiles dynamics is discussed. A good agreement between the calculated and the experimentally measured profiles is observed thus demonstrating …
Two-Way Diffusion Model For Short Exposure Holographic Grating Formation In Acrylamide-Based Photopolymer, Tzvetanka Babeva, Izabela Naydenova, Dana Mackey, Suzanne Martin, Vincent Toal
Two-Way Diffusion Model For Short Exposure Holographic Grating Formation In Acrylamide-Based Photopolymer, Tzvetanka Babeva, Izabela Naydenova, Dana Mackey, Suzanne Martin, Vincent Toal
Articles
A theoretical model for formation of a short exposure holographic grating is presented. The model accounts for both monomer and polymer diffusion and distinguishes between short polymer chains capable of diffusing and long polymer chains that are immobile. It is shown that the experimentally observed decrease of diffraction efficiency at higher spatial frequency can be predicted by assuming diffusion of short-chain polymers away from the bright fringes. The time evolution of the refractive index modulation after short exposure is calculated and compared with experimental results. The effects of diffusion coefficients, polymerization rates, intensity and spatial frequency of recording on the …
Optimisation Of An Acrylamide-Based Photopolymer System For Holographic Inscription Of Surface Patterns With Sub-Micron Resolution, Kevin Trainer, Kevin Wearen, Dimana Nazarova, Izabela Naydenova, Vincent Toal
Optimisation Of An Acrylamide-Based Photopolymer System For Holographic Inscription Of Surface Patterns With Sub-Micron Resolution, Kevin Trainer, Kevin Wearen, Dimana Nazarova, Izabela Naydenova, Vincent Toal
Articles
We describe the optimisation of the holographic patterning of sub-micrometer surface relief structures in an acrylamide-based photopolymer. A substantial improvement in the photoinduced surface relief resolution was achieved by altering the photopolymer chemical composition and by introducing a single step post recording thermal treatment of the layers. It was observed that, by optimisation of the chemical composition of the photopolymer layers, the maximum achievable spatial frequency increases from 200 l/mm to 550 l/mm. The improvement of the surface relief amplitude by alteration of the chemical composition is limited due to the fact that both decrease of the plasticiser and increase …
A Diffusion Model For Spatially Dependent Photopolymerization, Dana Mackey, Tzvetanka Babeva, Izabela Naydenova, Vincent Toal
A Diffusion Model For Spatially Dependent Photopolymerization, Dana Mackey, Tzvetanka Babeva, Izabela Naydenova, Vincent Toal
Articles
Photopolymers represent an attractive class of optical recording materials due to properties such as high refractive index modulation, dry film processing, long shelf life, etc. Applications include holographically based devices for optical storage disks, optical interconnections, optical memories and filters. This paper will address the dynamics of short-exposure holographic grating formation; a new mathematical model is proposed with the aim of understanding the experimental observations of low diffraction efficiency in high spatial frequency gratings.
Photopolymers: Beyond The Standard Approach To Photosensitisation, Izabela Naydenova, Suzanne Martin, Vincent Toal
Photopolymers: Beyond The Standard Approach To Photosensitisation, Izabela Naydenova, Suzanne Martin, Vincent Toal
Articles
A photopolymerizable material for use in the visible normally consists of a dye sensitizer, a free radical generator, monomer/monomers and, optionally, a binder, and is prepared usually as a dry or liquid film. Upon illumination with light of appropriate wavelength, a photopolymerisation reaction is triggered, leading to a change in the film’s refractive index. Because the presence of the dye is essential, the film is usually made sensitive to light during its preparation. Here we separate the film preparation and the sensitisation processes. In this way the photopolymerisation process can be used to detect dye labelled analytes, providing an alternative …
Characterisation Of The Humidity And Temperature Responses Of A Reflection Hologram Recorded In Acrylamide-Based Photopolymer, Izabela Naydenova, Raghavendra Jallapuram, Vincent Toal, Suzanne Martin
Characterisation Of The Humidity And Temperature Responses Of A Reflection Hologram Recorded In Acrylamide-Based Photopolymer, Izabela Naydenova, Raghavendra Jallapuram, Vincent Toal, Suzanne Martin
Articles
The humidity and temperature responses of a reflection hologram recorded in a self-processing photopolymer layer have been characterised by measurement of the position of the maximum intensity in the spectral response of the hologram. It has been demonstrated that such a hologram can be used for indication of the relative humidity (RH) in a specific temperature range. The operational range and reversibility of the holograms have been characterised in a controlled humidity and temperature environment. The humidity studies were carried out in the range from 10 to 80% RH and the temperature range under study was 15 – 50 ºC.
Optical And Holographic Characteristics Of Photopolymer Layers, Temenujka Yovcheva, Izabela Naydenova, Ivanka Vlaeva, Suzanne Martin, Vincent Toal, Simeon Sainov
Optical And Holographic Characteristics Of Photopolymer Layers, Temenujka Yovcheva, Izabela Naydenova, Ivanka Vlaeva, Suzanne Martin, Vincent Toal, Simeon Sainov
Articles
In the present work the optical and holographic characteristics of acrylamide-based photopolymer layers are studied. For the first time the refractive index change of a liquid acrylamide photopolymer due to exposure at 532 nm is obtained using a critical angle laser micro-refractometer. The 30 mm thick solid photopolymer films are prepared by casting on glass substrates. Bragg holographic gratings with spatial frequencies of 710 mm-1, 1050 mm-1 and 1600 mm-1 are recorded using a diode laser operating at 532 nm wavelength. The diffraction efficiency dependence on the exposure energy is investigated. The obtained results are compared with the Stetson holographic …
A Visual Indication Of Environmental Humidity Using A Colour Changing Hologram Recorded In A Self-Developing Photopolymer, Izabela Naydenova, Raghavendra Jallapuram, Vincent Toal, Suzanne Martin
A Visual Indication Of Environmental Humidity Using A Colour Changing Hologram Recorded In A Self-Developing Photopolymer, Izabela Naydenova, Raghavendra Jallapuram, Vincent Toal, Suzanne Martin
Articles
A reflection hologram for visual indication of environmental humidity has been studied. The hologram is recorded in a self-developing photopolymer and changes colour when exposed to a change in humidity and is fully reversible. The range of colour change, reversibility and the response time of the hologram have been studied in a controlled humidity environment. Fully reversible holograms with response times from few seconds to tens of minutes have been designed. Extremely sensitive bright visual humidity indicators, capable of dramatic colour change within a few seconds of breathing on them are demonstrated.
Investigation Of The Diffusion Processes In Self-Processing Acrylamide-Based Photopolymer System, Izabela Naydenova, Raghavendra Jallapuram, Robert Howard, Suzanne Martin, Vincent Toal
Investigation Of The Diffusion Processes In Self-Processing Acrylamide-Based Photopolymer System, Izabela Naydenova, Raghavendra Jallapuram, Robert Howard, Suzanne Martin, Vincent Toal
Articles
Results from the investigation of the diffusion processes in a dry acrylamide-based photopolymer system are presented. The investigation is carried out in the context of experimental work on optimization of the high spatial frequency response of the photopolymer. Tracing the transmission holographic grating dynamics at short times of exposure is utilized to measure diffusion coefficients. The results reveal that two different diffusion processes contribute with opposite sign to the refractive index modulation responsible for the diffraction grating build up. Monomer diffusion from dark to bright fringe areas increases the refractive index modulation. It is characterized with diffusion constant D0=1.6E-7 cm2/s. …