Physics Commons^™

Design Of An Accelerator-Based Shielding Experiment At The Nasa Space Radiation Laboratory Relevant To Enclosed, Shielded Environments In Space, Lawrence H Heilbronn, Michael Sivertz, Adam Rusek, Charlie Pearson, Martha Clowdsley, Luis Castellanos, Natalie Mcgirl, Ashwin Srikrishna, Cary Zeitlin

Faculty Publications and Other Works -- Nuclear Engineering

Recent calculations indicate that the dose equivalent in an enclosed, shielded environment in a galactic cosmic ray field will increase or remain unchanged when shielding thickness increases beyond 20 to 30 g/cm2. This trend is seen out to 100 g/cm2, beyond which calculations were not run since depths greater than this are not envisioned for human missions in deep space. If these calculations are accurate, then an optimal shielding thickness (or narrow range of thicknesses) exists, with important implications for spacecraft and habitat design. Crucially, the calculation reveals a minimum dose equivalent value that cannot be reduced with added shielding, …

Characterization Of The Non-Uniqueness Of Used Nuclear Fuel Burnup Signatures Through A Mesh-Adaptive Direct Search, Steven Skutnik, David R. Davis

Faculty Publications and Other Works -- Nuclear Engineering

The use of passive gamma and neutron signatures from fission indicators is a common means of estimating used fuel burnup, enrichment, and cooling time. However, while characteristic fission product signatures such as ¹³⁴Cs, ¹³⁷Cs and ¹⁵⁴Eu, and others are generally reliable estimators for used fuel burnup within the context where the assembly initial enrichment and the discharge time are known, in the absence of initial enrichment and/or cooling time information (such as when applying NDA measurements in a safeguards/verification context), these fission product indicators no longer yield a unique solution for assembly enrichment, burnup, and cooling time …

Computer Code Verification And Cross Section Calculation For Promethium-147, Rita Inez Zell-Lusk

Nuclear Engineering Reports

The goals of this research are to (1) verify the predictions and accuracy of two computer codes which will be utilized in future research on Pm-147 production with data from a previous experiment and to (2) measure the cross section of Pm-147 for single neutron capture producing Pm-148 ground state and Pm-148 metastable state. The research in goal (1) used previous data obtained by James H. Hinderer in 2010 and a sample of Promethium-147 prepared by Rose Boll in 2006. The main elements of the new research done here included a correction of Mr. Hinderer’s data and the subsequent use …

Characterization Of Heavy Ion Beams At The Heavy Ion Medical Accelerator In Chiba Using A Li-Drifted 5-Mm Silicon Detector, Alexander Lang

Nuclear Engineering Reports

Measurements were taken at the Heavy Ion Medical Accelerator in Chiba, Japan (HIMAC) to characterize accelerator beams to assist in the study of various tissue equivalent proportional counters (TEPCs) designed by Colorado State University (CSU), Oklahoma State University (OSU), and the National Aeronautics and Space Administration (NASA). There were four beams that were part of the HIMAC experiment:

• 290 MeV/nucleon carbon
• 150 MeV/nucleon helium
• 500 MeV/nucleon argon
• 500 MeV/nucleon iron

For the first time ever, a single, 5-mm lithium drifted silicon detector was used to characterize the beam and measure the spectrum of particles striking the TEPCs. If successful, this …

Secondary Neutron-Production Cross Sections From Heavy-Ion Interactions Between 230 And 600 Mev/Nucleon, Lawrence H Heilbronn

Faculty Publications and Other Works -- Nuclear Engineering

Secondary neutron-production cross-sections have been measured from interactions of 230 MeV/nucleon He, 400 MeV/nucleon N, 400 MeV/nucleon Kr, 400 MeV/nucleon Xe, 500 MeV/nucleon Fe, and 600 MeV/nucleon Ne interacting in a variety of elemental and composite targets. We report the double-differential production cross sections, angular distributions, energy spectra, and total cross sections from all systems. Neutron energies were measured using the time-of-flight technique, and were measured at laboratory angles between 5° and 80°. The spectra exhibit behavior previously reported in other heavy-ion-induced neutron production experiments; namely, a peak at forward angles near the energy corresponding to the beam velocity, with …