Sustainability Commons^™

Campus Carbon Footprint Study At A South Texas University, Monica Garcia, Christian Florez, Diego Lopez, Jongmin Kim, Maysam Pournik

Mechanical Engineering Faculty Publications

A campus carbon footprint study was conducted at the University of Texas Rio Grande Valley, a Southern Texan university. This initiative was the school’s strategic plan to set a baseline for overall campus resource utilization status as well as to answer global requests to track and reduce campus greenhouse gas emissions and achieve greater sustainability on campus. For fiscal years of 2016 to 2018, an overall increase of campus carbon footprint was about 0.6%. The biggest increase was observed from sources owned or controlled by the school while the emissions associated with power usage decreased. The university’s carbon footprint was …

The Acoustic Camera As A Tool To Identify Belt Conveyor Noises, Piotr Bortnowski, Anna Nowak-Szpak, Maksymilian Ozdoba, Robert Król

Journal of Sustainable Mining

This paper explores the possibilities of using an acoustic camera as a tool that allows the verification of the correct construction and operation of individual elements of a belt conveyor. Based on the simultaneously recorded components - a video camera and measuring microphones, the sound pressure level map of the belt conveyor was created. The tests were carried out in laboratory conditions and covered the location and identification of individual noise sources. The verification consists not only of searching for dominant sound sources, but above all, of searching for frequencies in the analysed spectrum that should not occur during their …

Energy Consumption And Lifecycle Assessment Comparison Of Cutting Fluids For Drilling Titanium Alloy, Navneet Khanna, Prassan Shah, Jwalant Wadhwa, Anjali Pitroda, Julius M. Schoop, Franci Pusavec

Institute for Sustainable Manufacturing Faculty Publications

This study analyzes four cutting conditions (dry, flood, Liquid CO 2 (LCO2), and Liquid N2 (LN 2)) based on energy consumption and ecological impacts for drilling VT-20, a Titanium alloy. The lower cutting and total energy have been consumed for LCO2 as compared to others. The Life Cycle Assessment (LCA) analysis has been performed using ReCiPe 2016 midpoint (H) to identify the impact of cutting conditions on ecosystem, human health, and natural resources. Cryogenic environment with LN 2 has been found as the most ecological cutting condition next to dry machining, while flood coolant has 94-99% of total impact considering …

Sustainability Assessment Of Direct Energy Deposition (Ded) Based Hybrid Manufacturing Using Life Cycle Assessment (Lca) Method, Faujia Islam

Graduate Theses, Dissertations, and Problem Reports (ETD)

As sustainability has emerged as a highlight for almost every field over the last few decades, the manufacturing field is no exception. Generally, additive manufacturing performs better than traditional manufacturing in terms of sustainability because of its lean energy- and material usage. Previous studies have compared the sustainability performance between traditional and additive manufacturing, but hybrid manufacturing was not focused upon much. In this paper, the life cycle assessment method is used to analyze and compare the energy consumption and environmental impact of direct energy deposition (DED) based hybrid manufacturing and traditional manufacturing “CNC milling” process for a turbine blade. …

Applying Renewable Energies Against Climate Change: Solar Photovoltaic (Pv) Energy, Juan Jose Estribi

International Programs

In recent years, more efforts towards fighting climate change have been done. As a direct response, research and technology have offered several insights regarding the specific causes, effects, and even possible solutions for resolving this global issue. Among these solutions, renewable energies and their potential contributions as clean energy sources can be assessed as feasible options for the energy transformation through the decarbonization process of the energy industry. This poster is mainly focused on solar photovoltaic (PV) energy and its great potential as a renewable energy by making a brief assessment of some important aspects such as resource availability, its …

Optimization Of Bioethanol Production, Engine Performance And Exhaust Emissions From Manihot Glaziovii And Sweet Sorghum In A Spark Ignition Engine, Sebayang Abdi Hanra

Student Works (2020-2029)

The ever-increasing fossil fuel consumption over the years is attributable to economic and population growth, which in turn, increases greenhouse gas emissions. Bioethanol is one of the promising solutions to address the depletion of fossil fuels as well as environmental problems. Manihot glaziovii tubers and sweet sorghum grains are inedible feedstocks that can be used for bioethanol production. The carbohydrate content (70%) of these biomasses makes them suitable as feedstocks for bioethanol production. In this study, enzymatic hydrolysis (liquefaction and saccharification) was used to obtain the reduction of sugars. The enzymes α-amylase from Bacillus licheniformis Type XII-A and amyloglucosidase from …

Quantifying The Environmental Impacts Of Cookstove Transitions A Societal Exergy Analysis Based Model Of Energy Consumption And Forest Stocks In Honduras, Noah Ver Beek, Elvin Vindel, Matthew K. Heun, Paul E. Brockway

University Faculty Publications and Creative Works

Unsustainable consumption of biofuels contributes to deforestation and climate change, while household air pollution from burning solid biofuels in homes results in millions of premature deaths globally every year. Honduras, like many low and medium Human Development Index countries, depends on primary solid biofuels for more than 30% of its primary energy supply (as of 2013). We conducted a societal exergy analysis and developed a forest stock model for Honduras for 1971–2013 and used the results to model an energy transition from traditional wood stoves to either improved efficiency wood cookstoves or modern fuel cookstoves (using Electricity or Liquefied petroleum …

Utilization Of Recycled Filament For 3d Printing For Consumer Goods, Alexa Peterson

Apparel Merchandising and Product Development Undergraduate Honors Theses

The 3D printing market has been used in a wide variety of manufacturing industries including textile and apparel. Many consumers can now own a personal 3D printer at home for recreational printing. There are even websites dedicated to 3D printing patterns made by consumers. However, the materials used in the 3D printing process pose a problem for the environment due to their plastic-based nature. 3D printing is a layered process with each layer being printed depending on the layer below it for strength and stability. During the 3D printing process, great amounts of waste are produced as a result of …

An Assessment Of Renewable Energy Technology Implementation In Storrs, Connecticut: Emissions Reduction And Feasibility Of A Microgrid System At Uconn, Sophie Macdonald

Honors Scholar Theses

The purpose of this project is to design a clean energy-sourced microgrid for UConn’s main campus that would reduce the university’s energy emissions while remaining within the geographic boundaries of viable UConn-owned land. Economic cost was not considered in this analysis; instead, emissions and space constraints were the optimized measures of value and feasibility. Sources of energy that were considered include photovoltaics (PV), wind turbines, hydrokinetic systems, and fuel cells. Energy storage capacity was included in the analysis as well. The overall system was optimized first by ignoring space constraints and for a minimum of 10% reduction from the current …

Efficiency Analysis Of Harvesting Solar Energy To Perform Mechanical Work, Haden S. Bragg

Undergraduate Theses and Capstone Projects

The majority of the world’s electricity is generated using fossil fuels; in fact, the United States Energy Information Administration (EIA) states that the U.S. used fossil fuels to generate 62.7 % of its electricity in 2019 [1]. The goal of this research was to create a system that could perform mechanical work using only renewable resources. We built a solar charging station that uses two solar panels to generate electricity and an electric bicycle whose battery can be charged using the charging station. The efficiency for the type of solar cell used in this project is well established. Therefore, in …

Reverse Osmosis; Addressing Freshwater Shortage With Sustainable Desalination, Jessica Savage

Sustainability Conference

Water security is an imperative part of high-functioning societies. Currently, large populations of the globe live in water-impoverished or water-stressed areas. With climate change and growing global populations, projections show more people being impacted by issues of water shortage.

One solution to water security is the implementation of desalination, specifically with reverse osmosis systems. This presentation walks through the history, capabilities, future work, and explanations on how reverse osmosis systems work. With continued research on improving desalination, communities in both developed and developing nations around the world can work towards total water security.

Dual-Axis Solar Tracker, Bryan Kennedy

All Undergraduate Projects

Renewable energies, and fuels that are not fossil fuel-based, are one of the prolific topics of debate in modern society. With climate change now becoming a primary focus for scientists and innovators of today, one of the areas for the largest amount of potential and growth is that of the capturing and utilization of Solar Energy. This method involves using a mechanical system to track the progression of the sun as it traverses the sky throughout the day. A dual-axis solar tracker such as the one designed and built for this project, can follow the sun both azimuthally and in …

Adapting To Extreme Heat: Social, Atmospheric, And Infrastructure Impacts Of Air Conditioning In Megacities - The Case Of New York City, Harold Gamarro

Dissertations and Theses

Extreme heat events are becoming more frequent and intense in most large cities. Built-up surfaces also limit cooling mechanisms, leading to warmer conditions in cities, a phenomenon called the Urban Heat Island (UHI). This presents major challenges to reduce adverse health effects of hot weather, particularly in vulnerable populations like the elderly and low-income communities. Here we explore the overall impacts of increasing air conditioning (AC) system adoption in residences as an adaptive measure to reduce human health risks under heat waves, with New York City (NYC) as a case study. This study uses AC adoption data from the 2017 …

Arising: Hurricane (Superstorm) Sandy’S Impact On Design/Planning Professionals, Maxinne R. Leighton

Antioch University Dissertations & Theses

Standing by my bedroom window, looking out at the ocean, a huge wave comes and swallows up my building. Everything around me is gone, including me. I wake up. I am 13 years old and living in the Coney Island Houses on Surf Avenue, Brooklyn, New York. With ongoing anthropogenic changes to the natural environment such as sea level rise and intensifying storms, coastal communities, especially ones segregated by class and culture, are particularly vulnerable in this context that challenges a way of life, and in some instances, threatens that life's survival. This dissertation focuses specifically on what one massive …

Using Numerical Models Of Dewatering At Coal Ash Impoundments To Understand Cost And Schedule, Peter Bell, Joel Thompson, Don Fuller

World of Coal Ash Proceedings

No abstract provided.

Investigating Ccr Units And Evaluating The Physical Properties Of Ponded Ccr, David Skeggs, Zahra Aghazadeh, Rachel Combs

World of Coal Ash Proceedings

No abstract provided.

Demonstration Of “No Migration” Alternative Performance Standard For Ccr Facilities In Arid To Semi- Arid Regions Using Unsaturated Zone Modeling, James Aiken, Katy Lindstom

World of Coal Ash Proceedings

No abstract provided.

Coal Combustion Residuals Management Using Geotextile Containers- Considerations For Various Options, Randall Wilcox, Gregg Lebster, Bryan Hamilton, Thomas Stephens

World of Coal Ash Proceedings

No abstract provided.

State Vs Federal Ccr Rule Regulations: Comparisons And Impacts, Nicole Kron, Eric Nelson

World of Coal Ash Proceedings

No abstract provided.

Continuous, Real-Time Tss Monitoring Verifies Effluent Quality And Coal Ash Management Performance While Reducing Compliance Costs, Dave Fraley, Chris Bauman, Dave Donahue

World of Coal Ash Proceedings

No abstract provided.

Effect Of Coal Fly Ash On Agricultural Crops :Second Phase Showcase Project On Use Of Fly Ash In Agriculture In And Around Thermal Power Station Areas Of National Thermal Power Corporation Ltd., India., K. Arivazhagan, M. Ravichandran, S.K. Dube, V.K. Mathur

World of Coal Ash Proceedings

No abstract provided.

Advantages Of Single Source Contracting In-Plant Ccr Services, Kevin Foody, Marcella Funderburg, Blake Whittington

World of Coal Ash Proceedings

No abstract provided.

Design And Construction Of A Ccr Landfill Adjacent To The Missouri River, Thomas Gredell, Jeffrey Fouse, Jay Ellington

World of Coal Ash Proceedings

No abstract provided.

Geochemical Tools For Groundwater Monitoring At Coal Fired Utilities, Jeff Gillow, Bruce Sass, Hari Parthasarathy

World of Coal Ash Proceedings

No abstract provided.

Bottom Ash Handling Conversions – Lessons Learned, Dustin Doerr

World of Coal Ash Proceedings

No abstract provided.

Encapsulation Of Thermoevaporation Brines Using Coal Combustion Residuals, Dale Prentice, Kirk Ellison, Gaurav Sant

World of Coal Ash Proceedings

No abstract provided.

Recycling Of Coal Ash In Agriculture: Use Of Vermicomposting Biotechnology, G.N. Chattopadhyay, Gourab Roy, Wasim Iftikar

World of Coal Ash Proceedings

No abstract provided.

Surface Water And Groundwater Mixing In Alluvial Floodplains: A Significant Issue For Understanding Contaminant Transport At Coal Ash Facilities Adjacent To Rivers, Joel Thompson, Peter Bell, John Griggs

World of Coal Ash Proceedings

No abstract provided.

Alternate Source Demonstration Considerations Within The Appalachian Basin, Joseph Robb, Larry Mastera

World of Coal Ash Proceedings

No abstract provided.

Locating And Permitting A Ccr Landfill Adjacent To The Missouri River, Paul Reitz, Thomas Gredell, Jay Ellington

World of Coal Ash Proceedings

No abstract provided.