Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Publication
- Publication Type
Articles 1 - 4 of 4
Full-Text Articles in Chemistry
Synthesis, Densification, And Cation Inversion In High Entropy (Co,Cu,Mg,Ni,Zn)Al2o4 Spinel, Cole A. Corlett, Nina Obradovic, Jeremy Lee Watts, Eric W. Bohannan, William Fahrenholtz
Synthesis, Densification, And Cation Inversion In High Entropy (Co,Cu,Mg,Ni,Zn)Al2o4 Spinel, Cole A. Corlett, Nina Obradovic, Jeremy Lee Watts, Eric W. Bohannan, William Fahrenholtz
Materials Science and Engineering Faculty Research & Creative Works
The synthesis, densification behavior, and crystallographic site occupancy were investigated for four different spinel-based ceramics, including a high-entropy spinel (Co0.2Cu0.2Mg0.2Ni0.2 Zn0.2)Al2O4. Each composition was reacted to form a single phase, but analysis of X-ray diffraction patterns revealed differences in cation site occupancy with the high-entropy spinel being nearly fully normal. Densification behavior was investigated and showed that fully dense ceramics could be produced by hot pressing at temperatures as low as 1375°C for all compositions. Vickers' hardness values were at least 10 GPa for all compositions. The …
Ultrasmall Nanodiamonds: Perspectives And Questions, Shery L.Y. Chang, Philipp Reineck, Anke Krueger, Vadym Mochalin
Ultrasmall Nanodiamonds: Perspectives And Questions, Shery L.Y. Chang, Philipp Reineck, Anke Krueger, Vadym Mochalin
Chemistry Faculty Research & Creative Works
Nanodiamonds are at the heart of a plethora of emerging applications in areas ranging from nanocomposites and tribology to nanomedicine and quantum sensing. The development of alternative synthesis methods, a better understanding, and the availability of ultrasmall nanodiamonds of less than 3 nm size with a precisely engineered composition, including the particle surface and atomic defects in the diamond crystal lattice, would mark a leap forward for many existing and future applications. Yet today, we are unable to accurately control nanodiamond composition at the atomic scale, nor can we reliably create and isolate particles in this size range. In this …
Relating Detonation Parameters To The Detonation Synthesis Of Nanomaterials, Martin Langenderfer
Relating Detonation Parameters To The Detonation Synthesis Of Nanomaterials, Martin Langenderfer
Doctoral Dissertations
“This research investigates the physical and chemical processes that contribute to the detonation synthesis of silicon carbide nanoparticles. Bulk production of SiC nanoparticles through detonation is possible due to pressures achieved over 20 GPa and temperatures over 2000 K as well as quenching rates in excess of 13 billion K/second. These conditions catalyze reaction and bottom-up molecular growth while retaining particles < 100 nm in diameter. In this work, detonation synthesis of SiC was demonstrated by incorporation of polycarbosilane, an SiC precursor material, into an RDX/TNT explosive matrix prior to detonation. Detonation Synthesis of SiC was also accomplished by reacting elemental silicon with carbon liberated by the detonation of negatively oxygen balanced TNT. Hydrodynamic simulation of a 60:40 mass ratio RDX/TNT detonation created conditions thermodynamically suitable to produce cubic silicon carbide within the first 500 nanoseconds after the passage of the detonation wave while carbon remains chemically reactive for molecular formation. Simulations and experimental tests indicated that loading configuration and impedance mismatch of the precursor additives used in detonation synthesis results in conditions in the additives that exceed the accepted detonation pressure of the explosive by greater than three times. Finally, a full factorial experimental design showed increasing silicon concentration, reducing silicon size, and reducing oxygen balance by adjusting the ratio of RDX to TNT decreased the explosives detonation pressure by 20% and increased the soot yield and concentration of SiC observed in the detonation products by 82% and 442% respectively”--Abstract, page iv.
New Polyanion-Based Cathode Materials For Alkali-Ion Batteries, Hooman Yaghoobnejad Asl
New Polyanion-Based Cathode Materials For Alkali-Ion Batteries, Hooman Yaghoobnejad Asl
Doctoral Dissertations
"A number of new materials have been discovered through exploratory synthesis with the aim to be studied as the positive electrode (cathode) in Li-ion and Na-ion batteries. The focus has been set on the ease of synthesis, cost and availability of active ingredients in the battery, and decent cycle-life performance through a combination of iron and several polyanionic ligands. An emphasis has been placed also on phosphite (HPO32-) as a polyanionic ligand, mainly due to the fact that it has not been studied seriously before as a polyanion for cathode materials. The concept of mixed polyanions, for …