Physical Sciences and Mathematics Commons^™

Adsorption-Controlled Growth Of Bivo4 By Molecular-Beam Epitaxy, D. A. Hillsberry, D. A. Tenne

Physics Faculty Publications and Presentations

Single-phase epitaxial films of the monoclinic polymorph of BiVO₄ were synthesized by reactive molecular-beam epitaxy under adsorption-controlled conditions. The BiVO₄ films were grown on (001) yttria-stabilized cubic zirconia (YSZ) substrates. Four-circle x-ray diffraction, scanning transmission electron microscopy (STEM), and Raman spectroscopy confirm the epitaxial growth of monoclinic BiVO₄ with an atomically abrupt interface and orientation relationship (001)_BiVO4 ∥ (001)_YSZ with [100]_BiVO4 ∥ [100]_YSZ. Spectroscopic ellipsometry, STEM electron energy loss spectroscopy (STEM-EELS), and x-ray absorption spectroscopy indicate that the films have a direct band gap of 2.5 ± 0.1 eV.

Nanoparticle Film Assemblies As Platforms For Electrochemical Biosensing – Factors Affecting Amperometric Signal Enhancement Of Hydrogen Peroxide, Adrienne R. Schmidt, Natalie D. T. Nguyen, Michael C. Leopold

Chemistry Faculty Publications

Factors affecting the enhanced amperometric signal observed at electrodes modified with polyelectrolyte–gold nanoparticle (Au-NP) composite films, which are potential interfaces for first-generation biosensors, were systematically investigated and optimized for hydrogen peroxide (H2O2) detection. Polyelectrolyte multilayer films embedded with citrate-stabilized gold nanoparticles exhibited high sensitivity toward the oxidation of H2O2. From this Au-NP film assembly, the importance of Au-NP ligand protection, film permeability, the density of Au-NPs within the film, and electronic coupling between Au-NPs (interparticle) and between the film and the electrode (interfacial) were evaluated. Using alternative Au-NPs, including those stabilized with thiols, polymers, and bulky ligands, suggests that the …

The Impact Of Growth Conditions On Cubic Znmgo Ultraviolet Sensors, Ryan Boutwell

Electronic Theses and Dissertations

Cubic Zn1-xMgxO (c-Zn1-xMgxO) thin films have opened the deep ultraviolet (DUV) spectrum to exploration by oxide optoelectronic devices. These extraordinary films are readily wet-etch-able, have inversion symmetric lattices, and are made of common and safe constituents. They also host a number of new exciting experimental and theoretical challenges. Here, the relation between growth conditions of the c-Zn1-xMgxO film and performance of fabricated ultraviolet (UV) sensors is investigated. Plasma-Enhanced Molecular Beam Epitaxy was used to grow Zn1-xMgxO thin films and formation conditions were explored by varying the growth temperature, Mg source flux, oxygen flow rate, and radio-frequency (RF) power coupled into …

Origin Of The Low Frequency Radiation Emitted By Radiative Polaritons Excited By Infrared Radiation In Planar La2o3 Films, Anita J. Vincent-Johnson, Yosep Schwab, Harkirat S. Mann, Mathieu Francoeur, James S. Hammonds Jr., Giovanna Scarel

Department of Physics and Astronomy - Faculty Scholarship

Upon excitation in thin oxide films by infrared radiation, radiative polaritons are formed with complex angular frequency ω, according to the theory of Kliewer and Fuchs (1966 Phys. Rev. 150 573). We show that radiative polaritons leak radiation with frequency ωi to the space surrounding the oxide film. The frequency ωi is the imaginary part of ω. The effects of the presence of the radiation leaked out at frequency ωi are observed experimentally and numerically in the infrared spectra of La2O3 films on silicon upon excitation by infrared radiation of the 0TH type radiative polariton. The frequency ωi is found …

Structural, Optical And Electrical Properties Of Yttrium-Doped Hafnium Oxide Nanocrystalline Thin Films, Abhilash Kongu

Open Access Theses & Dissertations

Hafnium oxide (HfO2) has emerged as the most promising high-k dielectric for Metal-Oxide-Semiconductor (MOS) devices and has been highlighted as the most suitable dielectric materials to replace silicon oxide because of its comprehensive performance. In the present research, yttrium-doped HfO2 (YDH) thin films were fabricated using RF magnetron sputter deposition onto Si (100) and quartz with a variable thickness. Cross-sectional scanning electron microscopy coupled with Filmetrics revealed that film thickness values range from 700 A° to 7500 A°. Electrical properties such as AC Resistivity and current-voltage (I-V) characteristics of YDH films were studied. YDH films that were relatively thin (<1500 A°) crystallized in monoclinic phase while thicker films crystallized in cubic phase. The band gap (Eg) of the films was calculated from the optical measurements. The band gap was found to be ∼5.60 eV for monoclinic while it is ∼6.05 eV for cubic phase of YDH films. Frequency dependence of the electrical resistivity (ρac) and the total conductivity of the films were measured. Resistivity decreased (by three orders of magnitude) with increasing frequency from 100 Hz to 1 MHz, attributed due to the hopping mechanism in YDH films. Whereas, while ρac∼1Ω-m at low frequencies (100 Hz), it decreased to ∼ 104 Ω-cm at higher frequencies (1 MHz). Aluminum (Al) metal electrodes were deposited to fabricate a thin film capacitor with YDH layer as dielectric film thereby employing Al-YDH-Si capacitor structure. The results indicate that the capacitance of the films decrease with increasing film thickness. A detailed analysis of the electrical characteristics of YDH films is presented.

Ruco To Extend The Scalability Of Ultra-Thin Direct Plate Liners, Daniel Verne Greenslit

Legacy Theses & Dissertations (2009 - 2024)

In traditional semiconductor technology a sputtered copper seed layer is used to improve the adhesion, microstucture, and electromigration characteristics of electrochemically deposited (ECD) copper. The seed layer is deposited on top of a Ta/TaN stack. The Ta layer acts as an adhesion and nucleation layer for the copper seed and the TaN serves as a diffusion barrier for the Cu. As the line widths continue to shrink, scaling each of these layers becomes more difficult. It would be advantageous for the interconnect to be composed of as much copper as possible, transitioning from the traditional liner seed stack to a …

Applications Of High Throughput (Combinatorial) Methodologies To Electronic, Magnetic, Optical, And Energy-Related Materials, Martin L. Green, Ichiro Takeuchi, Jason R. Hattrick-Simpers

Faculty Publications

High throughput (combinatorial) materials science methodology is a relatively new research paradigm that offers the promise of rapid and efficient materials screening, optimization, and discovery. The paradigm started in the pharmaceutical industry but was rapidly adopted to accelerate materials research in a wide variety of areas. High throughput experiments are characterized by synthesis of a “library” sample that contains the materials variation of interest (typically composition), and rapid and localized measurement schemes that result in massive data sets. Because the data are collected at the same time on the same “library” sample, they can be highly uniform with respect to …

Surface Studies Of Organic Thin Films Using Scanning Probe Microscopy And Nanofabrication, Venetia Denae Lyles

LSU Doctoral Dissertations

Porphyrins and metalloporphyrins have unique chemical and electronic properties and thus provide useful model structures for nanoscale studies of the role of chemical structure for electronic properties. Porphyrins have been proposed as viable materials for molecular-based information-storage devices, gas sensors, photovoltaic cells, organic light-emitting diodes and molecular wires. The function and efficiency of porphyrins in devices is largely attributable to molecular architecture and how the molecules are self-organized. Modifications of the porphyrin macrocycle, peripheral groups or bound metal ions can generate a range of electrical, photoelectrical or magnetic properties. The conductive properties are greatly influenced at the molecular level by …

Investigation Of Nbnx Thin Films And Nanoparticles Grown By Pulsed Laser Deposition And Thermal Diffusion, Ashraf Hassan Farha

Electrical & Computer Engineering Theses & Dissertations

Niobium nitride films (NbNx) were grown on Nb and Si (100) substrates using pulsed laser deposition (PLD), laser heating, and thermal diffusion methods. Niobium nitride films were deposited on Nb substrates using PLD with a Q-switched Nd: YAG laser (λ = 1064 nm, 40 ns pulse width, and 10 Hz repetition rate) at different laser fluences, different nitrogen background pressures and deposition temperatures. The effect of changing PLD parameters for films done by PLD was studied. The seen observations establish guidelines for adjusting the laser parameters to achieve the desired morphology and phase of the grown NbNx films.

When the …